2019-26871. Airworthiness Directives; International Aero Engines AG Turbofan Engines  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration (FAA), DOT.

    ACTION:

    Notice of proposed rulemaking (NPRM).

    SUMMARY:

    The FAA proposes to adopt a new airworthiness directive (AD) for International Aero Engines AG (IAE) V2500-A1, V2522-A5, V2524-A5, V2525-D5, V2527-A5, V2527E-A5, V2527M-A5, V2528-D5, V2530-A5, V2531-E5, and V2533-A5 turbofan engine models with a certain diffuser case assembly installed. This proposed AD was prompted by a report of a manufacturing quality escape that could impact the life of the diffuser case assembly. This proposed AD would require removal of the affected diffuser case assembly from service and replacement with a part eligible for installation. The FAA is proposing this Start Printed Page 68375AD to address the unsafe condition on these products.

    DATES:

    The FAA must receive comments on this proposed AD by January 30, 2020.

    ADDRESSES:

    You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

    • Federal eRulemaking Portal: Go to https://www.regulations.gov. Follow the instructions for submitting comments.
    • Fax: 202-493-2251.
    • Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.
    • Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

    For service information identified in this NPRM, contact International Aero Engines AG, 400 Main Street, East Hartford, CT 06118; phone: 800-565-0140; email: help24@pw.utc.com; internet: http://fleetcare.pw.utc.com. You may view this service information at the FAA, Engine and Propeller Standards Branch, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7759.

    Examining the AD Docket

    You may examine the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2019-0832; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, the regulatory evaluation, any comments received, and other information. The street address for Docket Operations is listed above. Comments will be available in the AD docket shortly after receipt.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Nicholas Paine, Aerospace Engineer, ECO Branch, FAA, 1200 District Avenue, Burlington, MA, 01803; phone: 781-238-7116; fax: 781-238-7199; email: nicholas.j.paine@faa.gov.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Comments Invited

    The FAA invites you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2019-0832; Product Identifier 2019-NE-28-AD” at the beginning of your comments. The FAA specifically invites comments on the overall regulatory, economic, environmental, and energy aspects of this NPRM. The FAA will consider all comments received by the closing date and may amend this NPRM because of those comments.

    The FAA will post all comments received, without change, to https://www.regulations.gov,, including any personal information you provide. The FAA will also post a report summarizing each substantive verbal contact received about this NPRM.

    Discussion

    The FAA received a report of a manufacturing quality escape that identified certain diffuser case assemblies which did not meet material specification. According to an IAE investigation, the production defects in the affected diffuser case assemblies could impact the part design life and, therefore, the diffuser case assemblies require replacement. This condition, if not addressed, could result in the uncontained release of the diffuser case assembly, damage to the engine, and damage to the airplane.

    Related Service Information

    The FAA reviewed IAE Non-Modification Service Bulletin (NMSB) V2500-ENG-72-0707, dated July 1, 2019. The NMSB describes procedures for replacing the affected diffuser case assemblies.

    FAA's Determination

    The FAA is proposing this AD because it evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.

    Differences Between This Proposed AD and the Service Information

    IAE NMSB V2500-ENG-72-0707, dated July 1, 2019, identifies IAE V2522-A5, V2524-A5, V2527-A5, V2527E-A5, V2527M-A5, V2530-A5, and V2533-A5 turbofan engine models as applicable to replacement of the affected diffuser case assemblies. This proposed FAA AD additionally identifies V2500-A1, V2525-D5, V2528-D5, and V2531-E5 turbofan engine models to the applicability due to operators having the ability to install the affected diffuser case assemblies on any of the turbofan engine models.

    Proposed AD Requirements

    This proposed AD would require removal of the affected diffuser case assembly from service and its replacement with a part eligible for installation.

    Costs of Compliance

    The FAA estimates that this proposed AD affects two engines installed on airplanes of U.S. registry.

    The FAA estimates the following costs to comply with this proposed AD:

    Estimated Costs

    ActionLabor costParts costCost per productCost on U.S. operators
    Replace the diffuser case assembly70 work-hours × $85 per hour = $5,950$250,000$255,950$511,900

    According to the manufacturer, some of the costs of this proposed AD may be covered under warranty, thereby reducing the cost impact on affected individuals. The FAA does not control warranty coverage for affected individuals. As a result, the FAA has included all costs in our cost estimate.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

    The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or Start Printed Page 68376develop on products identified in this rulemaking action.

    This AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to engines, propellers, and associated appliances to the Manager, Engine and Propeller Standards Branch, Policy and Innovation Division.

    Regulatory Findings

    The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify this proposed regulation:

    (1) Is not a “significant regulatory action” under Executive Order 12866,

    (2) Will not affect intrastate aviation in Alaska, and

    (3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    The Proposed Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

    Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

    End Amendment Part

    International Aero Engines AG: Docket No. FAA-2019-0832; Product Identifier 2019-NE-28-AD.

    (a) Comments Due Date

    The FAA must receive comments by January 30, 2020.

    (b) Affected ADs

    None.

    (c) Applicability

    This AD applies to International Aero Engines AG (IAE) V2500-A1, V2522-A5, V2524-A5, V2525-D5, V2527-A5, V2527E-A5, V2527M-A5, V2528-D5, V2530-A5, V2531-E5, and V2533-A5 turbofan engine models with diffuser case assembly, serial number PGGUBB8267, PGGUBB8271, PGGUA95825, PGGUA95827, or PGGUBB8264, installed.

    (d) Subject

    Joint Aircraft System Component (JASC) Code 7230, Turbine Engine Compressor Section.

    (e) Unsafe Condition

    This AD was prompted by a report of a manufacturing quality escape that could impact the life of the diffuser case assembly. The FAA is issuing this AD to prevent failure of the diffuser case assembly. The unsafe condition, if not addressed, could result in the uncontained release of the diffuser case assembly, damage to the engine, and damage to the airplane.

    (f) Compliance

    Comply with this AD within the compliance times specified, unless already done.

    (g) Required Action

    At the next engine shop visit after the effective date of the AD or before accumulating 10,000 cycles since new, whichever occurs first, remove the affected diffuser case assembly from service and replace with a part eligible for installation.

    Note to paragraph (g): IAE Non-Modification Service Bulletin (NMSB) V2500-ENG-72-0707, dated July 1, 2019, contains guidance for replacing the diffuser case assembly.

    (h) Definition

    For the purpose of this AD, an “engine shop visit” is the induction of an engine into the shop for maintenance involving the separation of pairs of major mating engine flanges, except that the separation of engine flanges solely for the purposes of transportation without subsequent engine maintenance does not constitute an engine shop visit.

    (i) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, ECO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to the attention of the person identified in paragraph (j)(1) of this AD. You may email your request to: ANE-AD-AMOC@faa.gov.

    (2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

    (j) Related Information

    (1) For more information about this AD, contact Nicholas Paine, Aerospace Engineer, ECO Branch, FAA, 1200 District Avenue, Burlington, MA 01803; phone: 781-238-7116; fax: 781-238-7199; email: nicholas.j.paine@faa.gov.

    (2) For service information identified in this AD, contact International Aero Engines AG, 400 Main Street, East Hartford, CT 06118; phone: 800-565-0140; email: help24@pw.utc.com; internet: http://fleetcare.pw.utc.com. You may view this referenced service information at the FAA, Engine and Propeller Standards Branch, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7759.

    Start Signature

    Issued in Burlington, Massachusetts, on December 6, 2019.

    Robert J. Ganley,

    Manager, Engine & Propeller Standards Branch, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. 2019-26871 Filed 12-13-19; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Published:
12/16/2019
Department:
Federal Aviation Administration
Entry Type:
Proposed Rule
Action:
Notice of proposed rulemaking (NPRM).
Document Number:
2019-26871
Dates:
The FAA must receive comments on this proposed AD by January 30, 2020.
Pages:
68374-68376 (3 pages)
Docket Numbers:
Docket No. FAA-2019-0832, Product Identifier 2019-NE-28-AD
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
2019-26871.Pdf
Supporting Documents:
» Service Bulletin
» U.S. DOT/FAA - Supplemental AD Documents
CFR: (1)
14 CFR 39.13