![]() |
Code of Federal Regulations (Last Updated: July 5, 2024) |
![]() |
Title 10 - Energy |
![]() |
Chapter II - Department of Energy |
![]() |
SubChapter D - Energy Conservation |
![]() |
Part 429 - Certification, Compliance, and Enforcement for Consumer Products and Commercial and Industrial Equipment |
![]() |
Subpart B - Certification |
§ 429.46 - Commercial clothes washers.
-
§ 429.46 Commercial clothes washers.
Prior to February 17, 2023, certification reports must be submitted as required either in this section or 10 CFR 429.46 as it appears in the 10 CFR parts 200 through 499 edition revised as of January 1, 2022. On or after February 17, 2023, certification reports must be submitted as required in this section.
(a) Sampling plan for selection of units for testing.
(1) The requirements of § 429.11 are applicable to commercial clothes washers; and
(2) For each basic model of commercial clothes washers, a sample of sufficient size shall be randomly selected and tested to ensure that -
(i) Any represented value of the integrated water factor or other measure of energy or water consumption of a basic model for which consumers would favor lower values shall be greater than or equal to the higher of:
(ii) Any represented value of the modified energy factor, active-mode energy efficiency ratio, water efficiency ratio, or other measure of energy or water consumption of a basic model for which consumers would favor higher values shall be greater than or equal to the higher of:
(3) The clothes container capacity of a basic model reported in accordance with paragraph (b)(2) of this section shall be the mean of the measured clothes container capacity (C) of all tested units of the basic model.
(4) The corrected remaining moisture content (RMC) of a basic model reported in accordance with paragraph (b)(2) of this section shall be the mean of the final RMC value measured for all tested units of the basic model.
(b) Certification reports.
(1) The requirements of § 429.12 are applicable to commercial clothes washers; and
(2) Pursuant to § 429.12(b)(13), a certification report shall include the following public product-specific information:
(i) If testing was conducted using Appendix J1 to subpart B of part 430 of this chapter: The modified energy factor (MEFJ2), in cubic feet per kilowatt-hour per cycle (cu ft/kWh/cycle); and the
WF(ii) The integrated water factor (
per cycleIWF), in gallons per cycle per cubic feet
/cycle(gal/cycle/cu ft
);
ii) If testing was conducted using Appendix J2 to subpart B of part 430 of this chapter: The modified energy factor (MEFJ2) in cu ft/kWh/cycle and the integrated water factor (IWF) in gal/cu ft/cycle.(
iii) The clothes container capacity, in cubic feet (cu ft);
(iv) The type of loading (top-loading or front-loading); and
(v) The corrected RMC (expressed as a percentage).
(c) Reported values. Values reported pursuant to this section must be rounded as follows: Clothes container capacity to the nearest 0.1 cu ft, and corrected RMC to the nearest 0.1 percentage point.
[76 FR 12451, Mar. 7, 2011; 76 FR 24777, May 2, 2011, as amended at 79 FR 71630, Dec. 3, 2014; 87 FR 33379, June 1, 2022; 87 FR 43979, July 22, 2022]