![]() |
Code of Federal Regulations (Last Updated: July 5, 2024) |
![]() |
Title 40 - Protection of Environment |
![]() |
Chapter I - Environmental Protection Agency |
![]() |
SubChapter C - Air Programs |
![]() |
Part 80 - Regulation of Fuels and Fuel Additives |
![]() |
Subpart N - Additional Requirements for Gasoline-Ethanol Blends |
§ 80.1501 - Labeling requirements that apply to retailers and wholesale purchaser-consumers of gasoline that contains greater than 10 volume percent ethanol and not more than 15 volume percent ethanol.
-
§ 80.1501 Labeling requirements that apply to retailers and wholesale purchaser-consumers of gasoline that contains greater than 10 volume percent ethanol and not more than 15 volume percent ethanol.
(a) Any retailer or wholesale purchaser-consumer who sells, dispenses, or offers for sale or dispensing E15 shall affix the following conspicuous and legible label to the fuel dispenser:
Attention
E15
Up to 15% ethanol
Use only in
• 2001 and newer passenger vehicles
• Flex-fuel vehicles
Don't use in other vehicles, boats, or gasoline-powered equipment. It may cause damage and is prohibited by Federal law.
(b) Labels under this section shall meet the following requirements for appearance and placement:
(1) Dimensions. The label shall measure 3 and 5⁄8 inches wide by 3 and 1⁄8 inches high.
(2) Placement. The label shall be placed on the upper two-thirds of each fuel dispenser where the consumer will see the label when selecting a fuel to purchase. For dispensers with one nozzle, the label shall be placed above the button or other control used for selecting E15, or in any other manner which clearly indicates which control is used to select E15. For dispensers with multiple nozzles, the label shall be placed in the location that is most likely to be seen by the consumer at the time of selection of E15.
(3) Text. The text shall be justified and the fonts and backgrounds shall be as described in paragraphs (b)(3)(i) through (vi) and (b)(4)(i) through (iv) of this section.
(i) The word “ATTENTION” shall be capitalized in 20-point, black, Helvetica Neue LT 77 Bold Condensed font, and shall be placed in the top 1.25 inches of the label as further described in paragraph (b)(4)(iii) of this section.
(ii) The word “E15” shall be in 42-point, orange, Helvetica Black font, and shall be placed in the top 1.25 inches of the label.
(iii) The ethanol content: “Up to 15% ethanol” shall be in 14-point, center-justified, orange, Helvetica Black font in the top 1.25 inches of the label, below the word E15.
(iv) The words “Use only in” shall be in 20-point, left-justified, black, Helvetica Bold font in the bottom 1.875 inches of the label.
(v) The words, and symbols “• 2001 and newer passenger vehicles • Flex-fuel vehicles” shall be in 14-point, left-justified, black, Helvetica Bold font.
(vi) The remaining two sentences shall be in 12-point, left-justified, Helvetica Bold font, except that the word “prohibited” in the second sentence shall be in 12-point, black, Helvetica Black Italics font.
(4) Color.
(i) The background of the top 1.25 inches of the label shall be black.
(ii) The background of the bottom 1.875 inches of the label shall be orange.
(iii) The label shall have on the upper left side of the label a diagonal orange stripe that is .3125 inches tall. The stripe shall be placed as far down and across the label as is necessary so as to as to create a black triangle of the upper left corner of the label whose vertical side is contiguous to the vertical edge of the label and is.4375 inches long, and whose horizontal side is contiguous to the horizontal edge of the label and is 1.0 inches long. The word “Attention” shall be centered to the upper edge of this stripe.
(5) Alternative labels to those specified in this section may be used if approved by EPA in advance. Such labels must contain all of the informational elements specified in paragraph (a) of this section, and must use colors and other design elements similar in substance and appearance to the label required by this section. Such labels may differ in size and shape from the label required by this section only to a small degree, except to the extent a larger label is necessary to accommodate additional information or translation of label information.
(i) A request for approval of an alternative label shall be sent to the attention of “E15 Alternative Label Request” to the address in § 80.10(a).
(ii) [Reserved]
[76 FR 44443, July 25, 2011, as amended at 79 FR 42165, July 18, 2014; 85 FR 7084, Feb. 6, 2020]