Code of Federal Regulations (Last Updated: October 10, 2024) |
Title 40 - Protection of Environment |
Chapter I - Environmental Protection Agency |
SubChapter U - Air Pollution Controls |
Part 1036 - Control of Emissions from New and in-Use Heavy-Duty Highway Engines |
§ 1036.30 - Submission of information. |
Subpart A - Overview and Applicability |
§ 1036.1 - Applicability. |
§ 1036.2 - Compliance responsibility. |
§ 1036.5 - Excluded engines. |
§ 1036.10 - Organization of this part. |
§ 1036.15 - Other applicable regulations. |
Subpart B - Emission Standards and Related Requirements |
§ 1036.100 - Overview of exhaust emission standards. |
§ 1036.101 - Overview of exhaust emission standards. |
§ 1036.104 - Criteria pollutant emission standards—NOX, HC, PM, and CO. |
§ 1036.108 - Greenhouse gas emission standards—CO2, CH4, and N2O. |
§ 1036.110 - Diagnostic controls. |
§ 1036.111 - Inducements related to SCR. |
§ 1036.115 - Other requirements. |
§ 1036.120 - Emission-related warranty requirements. |
§ 1036.125 - Maintenance instructions and allowable maintenance. |
§ 1036.130 - Installation instructions for vehicle manufacturers. |
§ 1036.135 - Labeling. |
§ 1036.136 - Clean Idle sticker. |
§ 1036.140 - Primary intended service class and engine cycle. |
§ 1036.150 - Interim provisions. |
Subpart C - Certifying Engine Families |
§ 1036.201 - General requirements for obtaining a certificate of conformity. |
§ 1036.205 - Requirements for an application for certification. |
§ 1036.210 - Preliminary approval before certification. |
§ 1036.225 - Amending applications for certification. |
§ 1036.230 - Selecting engine families. |
§ 1036.235 - Testing requirements for certification. |
§ 1036.240 - Demonstrating compliance with criteria pollutant emission standards. |
§ 1036.241 - Demonstrating compliance with greenhouse gas emission standards. |
§ 1036.245 - Deterioration factors for exhaust emission standards. |
§ 1036.246 - Verifying deterioration factors. |
§ 1036.250 - Reporting and recordkeeping for certification. |
§ 1036.255 - EPA oversight on certificates of conformity. |
Subpart D - Testing Production Engines and Hybrid Powertrains |
§ 1036.301 - Measurements related to GEM inputs in a selective enforcement audit. |
Subpart E - In-Use Testing |
§ 1036.401 - Testing requirements for in-use engines. |
§ 1036.405 - Overview of the manufacturer-run field-testing program. |
§ 1036.410 - Selecting and screening vehicles and engines for testing. |
§ 1036.415 - Preparing and testing engines. |
§ 1036.420 - Pass criteria for individual engines. |
§ 1036.425 - Pass criteria for engine families. |
§ 1036.430 - Reporting requirements. |
§ 1036.435 - Recordkeeping requirements. |
§ 1036.440 - Warranty obligations related to in-use testing. |
Subpart F - Test Procedures |
§ 1036.501 - General testing provisions. |
§ 1036.503 - Engine data and information for vehicle certification. |
§ 1036.505 - Engine data and information to support vehicle certification. |
§ 1036.510 - Supplemental Emission Test. |
§ 1036.512 - Federal Test Procedure. |
§ 1036.514 - Low Load Cycle. |
§ 1036.520 - Determining power and vehicle speed values for powertrain testing. |
§ 1036.525 - Clean Idle test. |
§ 1036.527 - Powertrain system rated power determination. |
§ 1036.530 - Test procedures for off-cycle testing. |
§ 1036.535 - Determining steady-state engine fuel maps and fuel consumption at idle. |
§ 1036.540 - Determining cycle-average engine fuel maps. |
§ 1036.543 - Carbon balance error verification. |
§ 1036.545 - Powertrain testing. |
§ 1036.550 - Calculating greenhouse gas emission rates. |
§ 1036.555 - Test procedures to verify deterioration factors. |
§ 1036.580 - Infrequently regenerating aftertreatment devices. |
Subpart G - Special Compliance Provisions |
§ 1036.601 - Overview of compliance provisions. |
§ 1036.605 - Alternate emission standards for engines used in specialty vehicles. |
§ 1036.610 - Off-cycle technology credits and adjustments for reducing greenhouse gas emissions. |
§ 1036.615 - Engines with Rankine cycle waste heat recovery and hybrid powertrains. |
§ 1036.620 - Alternate CO2 standards based on model year 2011 compression-ignition engines. |
§ 1036.625 - In-use compliance with CO2 family emission limits (FELs). |
§ 1036.630 - Certification of engine greenhouse gas emissions for powertrain testing. |
§ 1036.635 - Certification requirements for high-GCWR medium-duty vehicles. |
§ 1036.655 - Special provisions for diesel-fueled engines sold in American Samoa or the Commonwealth of the Northern Mariana Islands. |
Subpart H - Averaging, Banking, and Trading for Certification |
§ 1036.701 - General provisions. |
§ 1036.705 - Generating and calculating emission credits. |
§ 1036.710 - Averaging. |
§ 1036.715 - Banking. |
§ 1036.720 - Trading. |
§ 1036.725 - Required information for certification. |
§ 1036.730 - ABT reports. |
§ 1036.735 - Recordkeeping. |
§ 1036.740 - Restrictions for using emission credits. |
§ 1036.745 - End-of-year CO2 credit deficits. |
§ 1036.750 - Consequences for noncompliance. |
§ 1036.755 - Information provided to the Department of Transportation. |
Subpart I - Definitions and Other Reference Information |
§ 1036.801 - Definitions. |
§ 1036.805 - Symbols, abbreviations, and acronyms. |
§ 1036.810 - Incorporation by reference. |
§ 1036.815 - Confidential information. |
§ 1036.820 - Requesting a hearing. |
§ 1036.825 - Reporting and recordkeeping requirements. |
Appendix A of Part 1036 - Summary of Previous Emission Standards |
Appendix B of Part 1036 - Transient Duty Cycles |
Appendix C of Part 1036 - Default Engine Fuel Maps for § 1036.540 |
Appendix A to Part 1036 - Summary of Previous Emission Standards |
Appendix B to Part 1036 - Transient Duty Cycles |
Appendix C to Part 1036 - Default Engine Fuel Maps for § 1036.540 |
Appendix I to Part 1036 - Default Engine Fuel Maps for § 1036.540 |