§ 229.36 - Atlantic Pelagic Longline Take Reduction Plan (PLTRP).

§ 229.36 Atlantic Pelagic Longline Take Reduction Plan (PLTRP).

Cross Reference

Link to an amendment published at 88 FR 36972, June 6, 2023.

Cross Reference

Link to a delay of the above amendment published at 89 FR 55523, July 5, 2024.

(a) Purpose and scope. The purpose of this section is to implement the PLTRP to reduce incidental mortality and serious injury of short-finned pilot whales in the Atlantic pelagic longline fishery off the U.S. East Coast, a component of the Atlantic Ocean, Caribbean, Gulf of Mexico large pelagics longline fishery. The requirements in this section apply to the owner or operator of any vessel that has been issued or is required to be issued an Atlantic HMS tunas, swordfish, or shark permit (under 50 CFR 635.4) and that has onboard pelagic longline gear (as defined at 50 CFR 635.2) in the EEZ (as defined in 50 CFR 600.10) of the Atlantic Ocean east of the line of demarcation between the Atlantic Ocean and the Gulf of Mexico (as defined in 50 CFR 600.105(c)).

(b) Definitions. In addition to the definitions contained in the MMPA and §§ 216.3 and 229.2 of this chapter, the following definitions apply.

(1) Active gear means mainline in the water with gangions (as defined in 50 CFR 635.2) or hooks attached.

(2) Mid-Atlantic Bight means the area bounded by rhumb lines connecting the following points: 43° N 77° W; 43° N 71° W; 35° N 71° W; 35° N 77° W; and 43° N 77° W.

(c) Marine Mammal Handling and Release Placard. The placard, “Marine Mammal Handling/Release Guidelines: A Quick Reference for Atlantic Pelagic Longline Gear,” must be kept posted inside the wheelhouse and on the working deck. You may contact the NMFS Southeast Regional Office at [phone] to request additional copies of the placard.

(d) [Reserved]

(e) Mainline gear restrictions. Vessels operating in the portion of the Mid-Atlantic Bight in the EEZ (as defined in 50 CFR 600.10) may not deploy pelagic longline gear unless the gear meets the following mainline specifications:

(1) Mainline setting. There can only be one piece of mainline in the water at any time. If the gear breaks or parts after setting, the vessel owner or operator must make every effort to remove the additional portions of the gear as soon as possible.

(2) Mainline length. Mainline length cannot exceed 32 nmi.

(3) Active gear. There can be no more than 30 nmi of active gear.

(4) Maximum active gear length. A section of active gear cannot exceed 20 nmi.

(5) Gaps. Between any two parts of active gear, there must be a gap of at least 1 nmi.

[74 FR 23358, May 19, 2009, as amended at 88 FR 36972, June 6, 2023]