Code of Federal Regulations (Last Updated: May 6, 2024) |
Title 40 - Protection of Environment |
Chapter I—Environmental Protection Agency |
SubChapter C—Air Programs |
Part 53 - Ambient Air Monitoring Reference and Equivalent Methods |
Subpart E - Procedures for Testing Physical (Design) and Performance Characteristics of Reference Methods and Class I and Class II Equivalent Methods for PM 2.5 or PM 10-2.5 |
Subpart E - Procedures for Testing Physical (Design) and Performance Characteristics of Reference Methods and Class I and Class II Equivalent Methods for PM 2.5 or PM 10-2.5
§ 53.50 - General provisions. |
§ 53.51 - Demonstration of compliance with design specifications and manufacturing and test requirements. |
§ 53.52 - Leak check test. |
§ 53.53 - Test for flow rate accuracy, regulation, measurement accuracy, and cut-off. |
§ 53.54 - Test for proper sampler operation following power interruptions. |
§ 53.55 - Test for effect of variations in power line voltage and ambient temperature. |
§ 53.56 - Test for effect of variations in ambient pressure. |
§ 53.57 - Test for filter temperature control during sampling and post-sampling periods. |
§ 53.58 - Operational field precision and blank test. |
§ 53.59 - Aerosol transport test for Class I equivalent method samplers. |
Table E-2 - Spectral Energy Distribution and Permitted Tolerance for Conducting Radiative Tests |
Figure E-1 - Designation Testing Checklist |
Figure E-2 - Product Manufacturing Checklist |
Table E-1 to Subpart E - Summary of Test Requirements for Reference and Class I Equivalent Methods for PM2.5 |
Table E-2 to Subpart E - Spectral Energy Distribution and Permitted Tolerance for Conducting Radiative Tests |
Figure E-1 to Subpart E - Designation Testing Checklist |
Figure E-2 to Subpart E - Product Manufacturing Checklist |
Appendix A to Subpart E - References |
Table E-1 to Subpart E of Part 53 - Summary of Test Requirements for Reference and Class I Equivalent Methods for PM 2.5 and PM 10-2.5 |
Table E-2 to Subpart E of Part 53 - Spectral Energy Distribution and Permitted Tolerance for Conducting Radiative Tests |
Figure E-1 to Subpart E of Part 53 - Designation Testing Checklist |
Figure E-2 to Subpart E of Part 53 - Product Manufacturing Checklist |
Appendix A to Subpart E of Part 53 - References |