![]() |
Code of Federal Regulations (Last Updated: July 5, 2024) |
![]() |
Title 40 - Protection of Environment |
![]() |
Chapter I—Environmental Protection Agency |
![]() |
SubChapter C—Air Programs |
![]() |
Part 63 - National Emission Standards for Hazardous Air Pollutants for Source Categories |
![]() |
Subpart U - National Emission Standards for Hazardous Air Pollutant Emissions: Group I Polymers and Resins |
§ 63.498 - Back-end process provisions—recordkeeping.
-
§ 63.498 Back-end process provisions—recordkeeping.
(a) Each owner or operator shall maintain the records specified in paragraphs (a)(1) through (4), and paragraphs (b) through (e) of this section, as appropriate.
(1) The type of elastomer product processed in the back-end operation.
(2) The type of process (solution process, emulsion process, etc.)
(3) If the back-end process operation is subject to a residual organic HAP limitation in § 63.494(a)(1) through (3), whether compliance will be achieved by stripping technology, or by control or recovery devices.
(4) If the back-end process operation is subject to an emission limitation in § 63.494(a)(4), the organic HAP emission limitation calculated in accordance with § 63.494(a)(4)(i) through (iv), as applicable.
(b) Each owner or operator of a back-end process operation using stripping technology to comply with a residual organic HAP limitation in § 63.494(a)(1) through (3), and demonstrating compliance using the periodic sampling procedures in § 63.495(b), shall maintain the records specified in paragraph (b)(1), and in paragraph (b)(2) or paragraph (b)(3) of this section, as appropriate.
(1) Records associated with each sample taken in accordance with § 63.495(b). These records shall include the following for each sample:
(i) Elastomer type,
(ii) The date and time the sample was collected,
(iii) The corresponding quantity of elastomer processed over the time period represented by the sample. Acceptable methods of determining this quantity are production records, measurement of stream characteristics, and engineering calculations.
(A) For emulsion processes, this quantity shall be the weight of the latex leaving the stripper.
(B) For solution processes, this quantity shall be the crumb rubber dry weight of the rubber leaving the stripper.
(iv) The organic HAP content of each sample.
(2) The monthly weighted average organic HAP content, calculated in accordance with § 63.495(f).
(3) If the organic HAP contents for all samples analyzed during a month are below the appropriate level in § 63.494(a), the owner or operator may record that all samples were in accordance with the residual organic HAP limitations in § 63.494(a)(1) through (3), rather than calculating and recording a monthly weighted average.
(c) Each owner or operator of a back-end process operation using stripping technology to comply with a residual organic HAP limitation in § 63.494(a)(1) through (3), and demonstrating compliance using the stripper parameter monitoring procedures in § 63.495(c), shall maintain the records specified in paragraphs (c)(1) through (3) of this section.
(1) Records associated with the initial, and subsequent, determinations of the organic HAP content of each grade of elastomer produced. These records shall include the following:
(i) An identification of the elastomer type and grade;
(ii) The results of the residual organic HAP analyses, conducted in accordance with § 63.505(e)(1);
(iii) The stripper monitoring parameters required to be established in § 63.495(c)(1).
(iv) If re-determinations are made of the organic HAP content, and re-establishment of the stripper monitoring parameters, records of the initial determination are no longer required to be maintained.
(2) Records associated with each grade or batch. These records shall include the following for each grade or batch:
(i) Elastomer type and grade;
(ii) The quantity of elastomer processed;
(A) For emulsion processes, this quantity shall be the weight of the latex leaving the stripper.
(B) For solution processes, this quantity shall be the crumb rubber dry weight of the crumb rubber leaving the stripper.
(iii) The hourly average of all stripper parameter results;
(iv) If one or more hourly average stripper monitoring parameters is not in accordance with the established levels, the results of the residual organic HAP analysis.
(3) The monthly weighted average organic HAP content, calculated in accordance with § 63.495(f).
(d) Each owner or operator of a back-end process operation using control or recovery devices to comply with a residual organic HAP limitation in § 63.494(a)(1) through (3), shall maintain the records specified in paragraphs (d)(1) through (5) of this section. The recordkeeping requirements contained in paragraphs (d)(1) through (4) pertain to the results of the testing required by § 63.496(b), for each of the three required test runs.
(1) The uncontrolled residual organic HAP content in the latex or dry crumb rubber, as required to be determined by § 63.496(b)(3), including the test results of the analysis;
(2) The total quantity of material (weight of latex or dry crumb rubber) processed during the test run, recorded in accordance with § 63.496(b)(4);
(3) The organic HAP emissions at the inlet and outlet of the control or recovery device, determined in accordance with § 63.496(b)(5) through (b)(8), including all test results and calculations.
(4) The residual organic HAP content, adjusted for the control or recovery device emission reduction, determined in accordance with § 63.496(c)(1).
(5) Each owner or operator using a control or recovery device shall keep the following records readily accessible:
(i) Continuous records of the equipment operating parameters specified to be monitored under § 63.497(a) or specified by the Administrator in accordance with § 63.497(b). For flares, the records specified in Table 3 of 40 CFR part 63, subpart G shall be maintained in place of continuous records.
(ii) Records of the daily average value of each continuously monitored parameter for each operating day, except as provided in paragraphs (d)(5)(ii)(D) and (d)(5)(ii)(E) of this section.
(A) The daily average shall be calculated as the average of all values for a monitored parameter recorded during the operating day, except as provided in paragraph (d)(5)(ii)(B) of this section. The average shall cover a 24-hour period if operation is continuous, or the number of hours of operation per operating day if operation is not continuous.
(B) Monitoring data recorded during periods of monitoring system breakdowns, repairs, calibration checks, and zero (low-level) and high-level adjustments, shall not be included in computing the hourly or daily averages. In addition, monitoring data recorded during periods of non-operation of the EPPU (or specific portion thereof) resulting in cessation of organic HAP emissions, shall not be included in computing the hourly or daily averages. Records shall be kept of the times and durations of all such periods and any other periods of process or control device operation when monitors are not operating.
(C) The operating day shall be the period defined in the operating permit or the Notification of Compliance Status in § 63.506(e)(8) or (e)(5). It may be from midnight to midnight or another 24-hour period.
(D) If all recorded values for a monitored parameter during an operating day are below the maximum, or above the minimum, level established in the Notification of Compliance Status in § 63.506(e)(5) or in the operating permit, the owner or operator may record that all values were below the maximum or above the minimum level, rather than calculating and recording a daily average for that operating day.
(E) For flares, records of the times and duration of all periods during which the pilot flame is absent, shall be kept rather than daily averages. The records specified in this paragraph are not required during periods when emissions are not routed to the flare.
(iii) Hourly records of whether the flow indicator specified under § 63.497(d)(1) was operating and whether a diversion was detected at any time during the hour, as well as records of the times of all periods when the vent stream is diverted from the control device or the flow indicator is not operating.
(iv) Where a seal mechanism is used to comply with § 63.497(d)(2), hourly records of flow are not required.
(A) For compliance with § 63.497(d)(2), the owner or operator shall record whether the monthly visual inspection of the seals or closure mechanisms has been done, and shall record instances when the seal mechanism is broken, the bypass line damper or valve position has changed, or the key for a lock-and-key type configuration has been checked out, and records of any car-seal that has broken.
(B) [Reserved]
(e) If the back-end process operation is subject to an organic HAP emission limitation in § 63.494(a)(4), the records specified in paragraphs (e)(1) through (4) of this section.
(1) The applicable organic HAP emission limitation determined in accordance with § 63.494(a)(4)(i) through (iv).
(2) The organic HAP emissions from all back-end process operations for each month, along with documentation of all calculations and other information used in the engineering assessment to estimate these emissions.
(3) The mass of elastomer product produced each month.
(4) The total mass of organic HAP emitted for each 12-month period divided by the total mass of elastomer produced during the 12-month period, determined in accordance with § 63.495(g)(5).
[62 FR 46925, Sept. 5, 1996, as amended at 65 FR 38068, June 19, 2000; 76 FR 22591, Apr. 21, 2011]