Code of Federal Regulations (Last Updated: July 5, 2024) |
Title 40 - Protection of Environment |
Chapter I - Environmental Protection Agency |
SubChapter C - Air Programs |
Part 63 - National Emission Standards for Hazardous Air Pollutants for Source Categories |
Subpart VVVV - National Emission Standards for Hazardous Air Pollutants for Boat Manufacturing |
Demonstrating Compliance for Open Molding Operations Controlled by Add-on Control Devices |
§ 63.5715 - What operating limits must I meet?
Latest version.
-
§ 63.5715 What operating limits must I meet?
(a) For open molding operations on which you use a thermal oxidizer as an add-on control device, you must meet the operating limits specified in Table 4 to this subpart that apply to the emission capture system and thermal oxidizer. You must establish the operating limits during the performance test according to the procedures in § 63.5725. You must meet the operating limits at all times after you establish them.
(b) If you use an add-on control device other than a thermal oxidizer, or wish to monitor an alternative parameter and comply with a different operating limit, you must apply to the Administrator for approval of alternative monitoring under § 63.8(f).