![]() |
Code of Federal Regulations (Last Updated: July 5, 2024) |
![]() |
Title 29 - Labor |
![]() |
Subtitle B - Regulations Relating to Labor |
![]() |
Chapter XVII - Occupational Safety and Health Administration, Department of Labor |
![]() |
Part 1918 - Safety and Health Regulations for Longshoring |
![]() |
Subpart C - Gangways and Other Means of Access |
§ 1918.22 - Gangways.
-
§ 1918.22 Gangways.
(a) Whenever practicable, a gangway of not less than 20 inches (.51 m) in width, of adequate strength, maintained in safe repair and safely secured shall be used. If a gangway is not practicable, a straight ladder meeting the requirements of § 1918.24 that extends at least 36 inches (.91 m) above the upper landing surface and is secured against shifting or slipping shall be provided. When conditions are such that neither a gangway nor straight ladder can be used, a Jacob's ladder meeting the requirements of § 1918.23 may be used.
(b) Each side of the gangway, and the turntable, if used, shall have a hand rail with a minimum height of 33 inches (.84 m) measured perpendicularly from rail to walking surfaces at the stanchion, with a midrail. Rails shall be of wood, pipe, chain, wire, rope or materials of equivalent strength and shall be kept taut always. Portable stanchions supporting railings shall be supported or secured to prevent accidental dislodgement.
(c) The gangway shall be kept properly trimmed.
(d) When a fixed flat tread accommodation ladder is used, and the angle is low enough to require employees to walk on the edge of the treads, cleated duckboards shall be laid over and secured to the ladder.
(e) When the gangway overhangs the water so that there is danger of employees falling between the ship and the dock, a net or suitable protection shall be provided to prevent employees from receiving serious injury from falls to a lower level.
(f) If the foot of a gangway is more than one foot (.30 m) away from the edge of the apron, the space between them shall be bridged by a firm walkway equipped with a hand rail with a minimum height of approximately 33 inches (.84 m) with midrails on both sides.
(g) Gangways shall be kept clear of supporting bridles and other obstructions, to provide unobstructed passage. If, because of design, the gangway bridle cannot be moved to provide unobstructed passage, then the hazard shall be properly marked to alert employees of the danger.
(h) Obstructions shall not be laid on or across the gangway.
(i) Handrails and walking surfaces of gangways shall be maintained in a safe condition to prevent employees from slipping or falling.
(j) Gangways on vessels inspected and certificated by the U.S. Coast Guard are deemed to meet the requirements of this section.