![]() |
Code of Federal Regulations (Last Updated: May 6, 2024) |
![]() |
Title 30 - Mineral Resources |
![]() |
Chapter II - Bureau of Safety and Environmental Enforcement, Department of the Interior |
![]() |
SubChapter B - Offshore |
![]() |
Part 250 - Oil and Gas and Sulphur Operations in the Outer Continental Shelf |
![]() |
Subpart H - Oil and Gas Production Safety Systems |
![]() |
Additional Production System Requirements |
§ 250.870 - Time delays on pressure safety low (PSL) sensors.
-
§ 250.870 Time delays on pressure safety low (PSL) sensors.
(a) You may apply any or all of the industry standard Class B, Class C, or Class B/C logic to all applicable PSL sensors installed on process equipment, as long as the time delay does not exceed 45 seconds. Use of a PSL sensor with a time delay . If the device may be bypassed for greater than 45 seconds requires BSEE approval , you must monitor the bypassed devices in accordance with § 250.141869(a). You must document on your field test records any use of a PSL sensor with a time delay greater than 45 seconds. For purposes of this section, PSL sensors are categorized as follows:
(1) Class B safety devices have logic that allows for the PSL sensors to be bypassed for a fixed time period (typically less than 15 seconds, but not more than 45 seconds). Examples include sensors used in conjunction with the design of pump and compressor panels such as PSL sensors, lubricator no-flows, and high-water jacket temperature shutdowns.
(2) Class C safety devices have logic that allows for the PSL sensors to be bypassed until the component comes into full service (i.e., the time at which the startup pressure equals or exceeds the set pressure of the PSL sensor, the system reaches a stabilized pressure, and the PSL sensor clears). If a Class C safety device is bypassed, you must monitor the device until it is in full service.
(3) Class B/C safety devices have logic that allows for the PSL sensors to incorporate a combination of Class B and Class C circuitry. These devices are used to ensure that the PSL sensors are not unnecessarily bypassed during startup and idle operations, (e.g., Class B/C bypass circuitry activates when a pump is shut down during normal operations). The PSL sensor remains bypassed until the pump's start circuitry is activated and either:
(i) The Class B timer expires no later than 45 seconds from start activation, or
(ii) The Class C bypass is initiated until the pump builds up pressure above the PSL sensor set point and the PSL sensor comes into full service.
(b) If you do not install time delay circuitry that bypasses activation of PSL sensor shutdown logic for a specified time period on process and product transport equipment during startup and idle operations, you must manually bypass (pin out or disengage) the PSL sensor, with a time delay not to exceed 45 seconds.
[81 FR 60918, Sept. 7, 2016, as amended at 83 FR 49259, Sept. 28, 2018]