Code of Federal Regulations (Last Updated: May 6, 2024) |
Title 40 - Protection of Environment |
Chapter I - Environmental Protection Agency |
SubChapter C - Air Programs |
Part 63 - National Emission Standards for Hazardous Air Pollutants for Source Categories |
Subpart WWWW - National Emissions Standards for Hazardous Air Pollutants: Reinforced Plastic Composites Production |
Table 11 to Subpart WWWW of Part 63 - Data Requirements for New and Existing Continuous Lamination and Continuous Casting Lines Complying With a Percent Reduction Limit or a Lbs/Ton Limit on an Averaging Basis
Latest version.
-
Table 11 to Subpart WWWW of Part 63 - Data Requirements for New and Existing Continuous Lamination and Continuous Casting Lines Complying With a Percent Reduction Limit or a Lbs/Ton Limit on an Averaging Basis
As required in § 63.5865, in order to comply with a percent reduction limit or a lbs/ton limit on an averaging basis for continuous lamination lines and continuous casting lines you must determine the data in the following table:
For each . . . That . . . You must determine . . . 1. Wet-out area Is uncontrolled Annual uncontrolled wet-out area organic HAP emissions. 2. Wet-out area a. Has an enclosure that is not a PTE i. The capture efficiency of the enclosure, and
ii. Annual organic HAP emissions that escape the enclosure.3. Wet-out area Has an enclosure that is a PTE That the enclosure meets the requirements of EPA Method 204 of appendix M to 40 CFR part 51 for a PTE. 4. Oven Is uncontrolled Annual uncontrolled oven organic HAP emissions. 5. Line a. Is controlled or uncontrolled i. The amount of neat resin plus applied, and
ii. The amount of neat gel coat plus applied.6. Add-on control device i. Total annual inlet organic HAP emissions, and total annual outlet organic HAP emissions.