![]() |
Code of Federal Regulations (Last Updated: July 5, 2024) |
![]() |
Title 40 - Protection of Environment |
![]() |
Chapter I - Environmental Protection Agency |
![]() |
SubChapter C - Air Programs |
![]() |
Part 91 - Control of Emissions from Marine Spark-Ignition Engines |
![]() |
Subpart D - Emission Test Equipment Provisions |
§ 91.328 - Measurement equipment accuracy/calibration frequency table.
-
§ 91.328 Measurement equipment accuracy/calibration frequency table.
(a) The accuracy of measurements must be such that the maximum tolerances shown in Table 2 in appendix A to this subpart are not exceeded.
(b) Calibrate all equipment and analyzers according to the frequencies shown in Table 2 in appendix A to this subpart.
(c) Prior to initial use and after major repairs, bench check each analyzer (see § 91.323).
(e) At least monthly, or after any maintenance which could alter calibration, perform the following calibrations and checks.
(1) Leak check the vacuum side of the system (see § 91.324(a)).
(2) Verify that the automatic data collection system (if used) meets the requirements found in Table 2 in appendix A to this subpart.
(3) Check the fuel flow measurement instrument to insure that the specifications in Table 2 in appendix A to this subpart are met.
(f) Verify that all NDIR analyzers meet the water rejection ratio and the CO2 rejection ratio as specified in § 91.325.
(g) Verify that the dynamometer test stand and power output instrumentation meet the specifications in Table 2 in appendix A to this subpart.