![]() |
Code of Federal Regulations (Last Updated: July 5, 2024) |
![]() |
Title 46 - Shipping |
![]() |
Chapter I - Coast Guard, Department of Homeland Security |
![]() |
SubChapter F - Marine Engineering |
![]() |
Part 52 - Power Boilers |
![]() |
Subpart 52.05 - Requirements for Boilers Fabricated by Welding |
§ 52.05-30 - Minimum requirements for attachment welds (modifies PW-16).
-
§ 52.05-30 Minimum requirements for attachment welds (modifies PW-16).
(a) The location and minimum size of attachment welds for nozzles and other connections shall be as required by PW-16 of section I of the ASME Boiler and Pressure Vessel Code (incorporated by reference; see 46 CFR 52.01-1) except as noted otherwise in this section.
(b) When nozzles or couplings are attached to boilers, as shown in Figure PW-16 (a) and (c) of section I of the ASME Boiler and Pressure Vessel Code and are welded from one side only, backing strips shall be used unless it can be determined visually or by acceptable nondestructive test methods that complete penetration has been obtained.
(c) When attachments as shown in Figure PW-16 (y) and (z) of section I of the ASME Boiler and Pressure Vessel Code are employed they shall be limited to 2-inch pipe size for pressure exceeding 150 pounds per square inch.
[CGFR 68-82, 33 FR 18815, Dec. 18, 1968, as amended by USCG-2003-16630, 73 FR 65161, Oct. 31, 2008]