![]() |
Code of Federal Regulations (Last Updated: July 5, 2024) |
![]() |
Title 47 - Telecommunication |
![]() |
Chapter I - Federal Communications Commission |
![]() |
SubChapter B - Common Carrier Services |
![]() |
Part 27 - Miscellaneous Wireless Communications Services |
![]() |
Subpart P - Regulations Governing Licensing and Use of 900 MHz Broadband Service in the 897.5-900.5 MHz and 936.5-939.5 MHz Bands |
§ 27.1509 - Emission limits.
-
§ 27.1509 Emission limits.
The power of any emission outside a licensee's frequency band(s) of operation shall be attenuated below the transmitter power (P) in watts by at least the following amounts:
(a) For 900 MHz broadband operations in 897.5-900.5 MHz band by at least 43 + 10 log (P) dB.
(b) For 900 MHz broadband operations in the 936.5-939.5 MHz band, by at least 50 + 10 log (P) dB.
(c) Compliance with the provisions of paragraphs (a) and (b) of this section is based on the use of measurement instrumentation employing a resolution bandwidth of 100 kHz or greater. However, in the 100 kHz bands immediately outside and adjacent to the licensee's band, a resolution bandwidth of at least 1 percent of the emission bandwidth of the fundamental emission of the transmitter may be employed. The emission bandwidth is defined as the width of the signal between two points, one below the carrier center frequency and one above the carrier center frequency, outside of which all emissions are attenuated at least 26 dB below the transmitter power.
(d) The measurements of emission power can be expressed in peak or average values, provided they are expressed in the same parameters as the transmitter power.
(e) When an emission outside of the authorized bandwidth causes harmful interference, the Commission may, at its discretion, require greater attenuation than specified in this section.