00-31600. Defense Federal Acquisition Regulation Supplement; Domestic Source Restrictions-Ball and Roller Bearings and Vessel Propellers  

  • Start Preamble

    AGENCY:

    Department of Defense (DoD).

    ACTION:

    Interim rule with request for comments.

    SUMMARY:

    The Director of Defense Procurement has issued an interim rule amending the Defense Federal Acquisition Regulation Supplement (DFARS) to implement Section 8064 of the DoD Appropriations Act for Fiscal year 2001 and Section 805 of the DoD Authorization Act for Fiscal Year 2001. These laws place restrictions on the acquisition of vessel propellers and ball and roller bearings from foreign sources.

    DATES:

    Effective date: December 13, 2000.

    Comment date: Comments on the interim rule should be submitted to the address shown below on or before February 12, 2001, to be considered in the formation of the final rule.

    ADDRESSES:

    E-mailed comments are preferred. Submit comments to: dfars@acq.osd.mil. Please cite DFARS Case 2001-D301 in the subject line.

    Respondents that cannot submit comments by e-mail may submit comments to: Defense Acquisition Regulations Council, Attn: Ms. Amy Williams, OUSD(AT&L) DP (DAR), IMD 3C132, 3062 Defense Pentagon, Washington, DC 20301-3062; facsimile (703) 602-0350. Please cite DFARS Case 2000-D301.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Ms. Amy Williams, (703) 602-0288.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    A. Background

    This interim rule amends the DFARS to implement Section 8064 of the DoD Appropriations Act for Fiscal Year 2001 (Public Law 106-259) and Section 805 of the DoD Authorization Act for Fiscal Year 2001 (Public Law 106-398). Section 8064 of Public Law 106-259 restricts the acquisition of ball and roller bearings and vessel propellers to those produced by a domestic source and of domestic origin. The restriction does not apply to the purchase of commercial items, except ball or roller bearings purchased as end items. Section 805 of Public Law 106-398 extends the restriction on acquisition of ball and roller bearings at 10 U.S.C. 2534 through fiscal year 2005.

    This rule was not subject to Office of Management and Budget review under Executive Order 12866, dated September 30, 1993.

    B. Regulatory Flexibility Act

    This interim rule may have a significant economic impact on a substantial number of small entities within the meaning of the Regulatory Flexibility Act, 5 U.S.C. 601, et seq. An initial regulatory flexibility analysis has been prepared and is summarized as follows: The objective of this interim rule is to protect the domestic industrial base for ball and roller bearings and vessel propellers as required by Section 8064 of Public Law 106-259 and 10 U.S.C. 2534. By restricting foreign competition, the rule will benefit domestic small business concerns that manufacture ball or roller bearings, bearing components, vessel propellers, or vessel propeller casings. This rule does not duplicate, overlap, or conflict with other relevant Federal rules.

    DoD has submitted a copy of the initial regulatory flexibility analysis to the Chief Counsel for Advocacy of the Small Business Administration. Interested parties may obtain a copy of the analysis from the point of contact specified herein. Comments are invited. DoD also will consider comments from small entities concerning the affected DFARS subparts in accordance with 5 U.S.C. 610. Such comments should be submitted separately and should cite DFARS Case 2000-D301.

    C. Paperwork Reduction Act

    The Paperwork Reduction Act does not apply because the rule does not impose any information collection requirements that require the approval of the Office of Management and Budget under 44 U.S.C. 3501, et seq.

    D. Determination To Issue an Interim Rule

    A determination has been made under the authority of the Secretary of Defense that urgent and compelling reasons exist to publish this interim rule prior to affording the public an opportunity to Start Printed Page 77828comment. This interim rule implements Section 8064 of the DoD Appropriations Act for Fiscal Year 2001 (Public Law 106-259) and Section 805 of the DoD Authorization Act for Fiscal Year 2001 (Public Law 106-398). Section 8064 of Public Law 106-259 restricts the acquisition of ball and roller bearings and vessel propellers to those produced by a domestic source and of domestic origin. Section 805 of Public Law 106-398 extends the restriction on acquisition of ball and roller bearings at 10 U.S.C. 2534 through fiscal year 2005. Section 8064 of Public Law 106-259 became effective on August 9, 2000, and Section 805 of Public Law 106-398 became effective on October 30, 2000. DoD will consider comments received in response to this interim rule in the formation of the final rule.

    Start List of Subjects

    List of Subjects in 48 CFR Parts 212, 225, and 252

    • Government procurement
    End List of Subjects Start Signature

    Michele P. Peterson,

    Executive Editor, Defense Acquisition Regulations Council.

    End Signature Start Amendment Part

    Therefore, 48 CFR Parts 212, 225, and 252 are amended as follows:

    End Amendment Part Start Amendment Part

    1. The authority citation for 48 CFR Parts 212, 225, and 252 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 41 U.S.C. 421 and 48 CFR Chapter 1.

    End Authority Start Part

    PART 212—ACQUISITION OF COMMERCIAL ITEMS

    End Part Start Amendment Part

    2. Section 212.503 is amended by revising paragraph (a)(xi) to read as follows:

    End Amendment Part
    Applicability of certain laws to Executive Agency contracts for the acquisition of commercial items.

    (a) * * *

    (xi) Domestic Content Restrictions in the National Defense Appropriations Acts for Fiscal Years 1996 and Subsequent Years, unless the restriction specifically applies to commercial items. For the restriction that specifically applies to commercial ball or roller bearings as end items, see 225.7019-2(b) (Section 8064 of Public Law 106-259).

    * * * * *
    Start Amendment Part

    3. Section 212.504 is amended by revising paragraph (a)(xxv) to read as follows:

    End Amendment Part
    Applicability of certain laws to subcontracts for the acquisition of commercial items.

    (a) * * *

    (xxv) Domestic Content Restrictions in the National Defense Appropriations Acts for Fiscal Years 1996 and Subsequent Years, unless the restriction specifically applies to commercial items. For the restriction that specifically applies to commercial ball or roller bearings as end items, see 225.7019-2(b) (Section 8064 of Public Law 106-259).

    * * * * *
    Start Part

    PART 225—FOREIGN ACQUISITION

    [Amended]
    End Part Start Amendment Part

    4. Section 225.7019-1 is amended in paragraph (a) by removing the phrase “fiscal year 2000” and adding in its place “fiscal year 2005”.

    End Amendment Part Start Amendment Part

    5. Section 225.7019-2 is amended by revising paragraph (b) to read as follows:

    End Amendment Part
    Exceptions.
    * * * * *

    (b) The restriction in 225.7019-1(b) does not apply to contracts or subcontracts for acquisition of commercial items, except for commercial ball and roller bearings acquired as end items.

    Start Amendment Part

    6. Section 225.7019-4 is revised to read as follows:

    End Amendment Part
    Contract clause.

    (a) Use the clause at 252.225-7016, Restriction on Acquisition of Ball and Roller Bearings, in solicitations and contracts, unless—

    (1) The restrictions in 225.7019-1 do not apply or a waiver has been granted; or

    (2) The contracting officer knows that the items being acquired do not contain ball or roller bearings.

    (b) In solicitations and contracts that use simplified acquisition procedures, use the clause with its Alternate I.

    Start Amendment Part

    7. Sections 225.7020 through 225.7020-4 are added to read as follows:

    End Amendment Part
    Restriction on vessel propellers.
    Restriction.

    In accordance with Section 8064 of the National Defense Appropriations Act for Fiscal Year 2001 (Public Law 106-259), do not use fiscal year 2000 or 2001 funds to acquire vessel propellers other than those produced by a domestic source of domestic origin, i.e., vessel propellers—

    (a) Manufactured in the United States or Canada; and

    (b) For which all component castings were poured and finished in the United States or Canada.

    Exceptions.

    This restriction does not apply to contracts or subcontracts for acquisition of commercial items.

    Waiver.

    The Secretary of the department responsible for acquisition may waive this restriction on a case-by-case basis, by certifying to the House and Senate Committees on Appropriations that—

    (a) Adequate domestic supplies are not available to meet DoD requirements on a timely basis; and

    (b) The acquisition must be made in order to acquire capability for national security purposes.

    Contract clause.

    Use the clause at 252.225-7023, Restriction on Acquisition of Vessel Propellers, in solicitations and contracts for the acquisition of vessels or vessel propellers, unless—

    (a) An exception under 225.7020-2 is known to apply or a waiver has been granted in accordance with 225.7020-3; or

    (b) The vessels being acquired do not contain vessel propellers.

    Start Part

    PART 252—SOLICITATION PROVISIONS AND CONTRACT CLAUSES

    End Part Start Amendment Part

    8. Section 252.212-7001 is amended by revising the clause date; and in paragraph (a) by adding, in numerical order, a new entry “252.225-7016” to read as follows:

    End Amendment Part
    Contract Terms and Conditions Required to Implement Statutes or Executive Orders Applicable to Defense Acquisitions of Commercial Items.
    * * * * *

    Contract Terms and Conditions Required To Implement Statutes or Executive Orders Applicable to Defense Acquisitions of Commercial Items (Dec 2000)

    (a) * * *

    ____252.225-7016 Restriction on Acquisition of Ball and Roller Bearings (____Alternate I) (Section 8064 of Pub. L. 106-259).

    * * * * *
    Start Amendment Part

    9. Section 252.225-7016 is amended by revising the clause date and paragraph (c)(1); and by adding Alternate I to read as follows:

    End Amendment Part
    Restriction on Acquisition of Ball and Roller Bearings.
    * * * * *

    Restriction on Acquisition of Ball and Roller Bearings (Dec 2000)

    * * * * *

    (c)(1) The restriction in paragraph (b) of this clause does not apply to ball or roller bearings that are acquired as components if—

    (i) The end items or components containing ball or roller bearings are commercial items; orStart Printed Page 77829

    (ii) The ball or roller bearings are commercial components manufactured in the United Kingdom.

    * * * * *

    Alternate I (Dec 2000) As prescribed in 225.7019-4(b), substitute the following paragraph (c)(1)(ii) for paragraph (c)(1)(ii) of the basic clause:

    (c)(1)(ii) The ball or roller bearings are commercial components.

    Start Amendment Part

    10. Section 252.225-7023 is added to read as follows:

    End Amendment Part
    Restriction on Acquisition of Vessel Propellers.

    As prescribed in 225.7020-4, use the following clause:

    Restriction on Acquisition of Vessel Propellers (Dec 2000)

    (a) Except as provided in paragraph (b) of this clause, the Contractor shall deliver under this contract, whether as end items or components of end items, vessel propellers—

    (1) Manufactured in the United States or Canada; and

    (2) For which all component castings were poured and finished in the United States or Canada.

    (b) The restriction in paragraph (a) of this clause—

    (1) Does not apply to vessel propellers that are commercial items; and

    (2) For other than commercial items, may be waived upon request from the Contractor in accordance with subsection 225.7020-3 of the Defense Federal Acquisition Regulation Supplement.

    (End of clause)

    End Supplemental Information

    [FR Doc. 00-31600 Filed 12-12-00; 8:45 am]

    BILLING CODE 5000-04-M

Document Information

Published:
12/13/2000
Department:
Defense Department
Entry Type:
Rule
Action:
Interim rule with request for comments.
Document Number:
00-31600
Pages:
77827-77829 (3 pages)
Docket Numbers:
DFARS Case 2000-D301
Topics:
Government procurement
PDF File:
00-31600.pdf
CFR: (13)
48 CFR 212.503
48 CFR 212.504
48 CFR 225.7020
48 CFR 225.7019-1
48 CFR 225.7019-2
More ...