E8-26440. Asbestos Exposure Limit  

  • Start Preamble

    AGENCY:

    Mine Safety and Health Administration, Labor.

    ACTION:

    Final rule, technical amendment.

    Start Printed Page 66172

    SUMMARY:

    The Mine Safety and Health Administration (MSHA) is amending and clarifying its existing health standards for asbestos exposure. The amendments make no substantive change to the existing standards, MSHA's enforcement of the standards, or the protection afforded miners under the standards.

    DATES:

    This technical amendment is effective November 7, 2008.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Patricia W. Silvey at silvey.patricia@dol.gov (e-mail), 202-693-9440 (Voice), or 202-693-9441 (Fax).

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    MSHA published a final rule amending its health standards for asbestos exposure at metal and nonmetal mines, surface coal mines, and surface areas of underground coal mines on February 29, 2008 (73 FR 11284). The rule became effective on April 29, 2008. To assure that the mining community fully understands MSHA's intent with respect to certain provisions of the existing standards, the Agency is issuing this technical amendment. This technical amendment clarifies MSHA's definition of asbestos and analytical methods the Agency uses to enforce the existing asbestos exposure limit. As stated above, these clarifications do not change any substantive requirements and reflect MSHA's intent as explained in the preamble to the final rule issued on February 29, 2008.

    Start List of Subjects

    List of Subjects

    30 CFR Parts 56 and 57

    • Air quality
    • Asbestos
    • Chemicals
    • Hazardous substances
    • Metals
    • Mine safety and health

    30 CFR Part 71

    • Air quality
    • Asbestos
    • Chemicals
    • Coal mining
    • Hazardous substances
    • Mine safety and health
    End List of Subjects Start Signature

    Richard E. Stickler,

    Acting Assistant Secretary for Mine Safety and Health.

    End Signature Start Amendment Part

    For the reasons set out in the preamble, MSHA is amending title 30 of the Code of Federal Regulations as follows.

    End Amendment Part Start Part

    PART 56—SAFETY AND HEALTH STANDARDS—SURFACE METAL AND NONMETAL MINES

    End Part Start Amendment Part

    1. The authority citation for part 56 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 30 U.S.C. 811.

    End Authority Start Amendment Part

    2. Amend § 56.5001 by revising the introductory text of paragraph (b)(1), adding a definition for asbestos fiber, and revising paragraph (b)(3) to read as follows:

    End Amendment Part
    Exposure limits for airborne contaminants.
    * * * * *

    (b) Asbestos standard—(1) Definitions. Asbestos is a generic term for a number of asbestiform hydrated silicates that, when crushed or processed, separate into flexible fibers made up of fibrils.

    * * * * *

    Asbestos fiber means a fiber of asbestos that meets the criteria of a fiber.

    * * * * *

    (3) Measurement of airborne asbestos fiber concentration. Potential asbestos fiber concentration shall be determined by phase contrast microscopy (PCM) using the OSHA Reference Method in OSHA's asbestos standard found in 29 CFR 1910.1001, Appendix A, or a method at least equivalent to that method in identifying a potential asbestos exposure exceeding the 0.1 f/cc full-shift limit or the 1 f/cc excursion limit. When PCM results indicate a potential exposure exceeding the 0.1 f/cc full-shift limit or the 1 f/cc excursion limit, samples shall be further analyzed using transmission electron microscopy according to NIOSH Method 7402 or a method at least equivalent to that method.

    * * * * *
    Start Part

    PART 57—SAFETY AND HEALTH STANDARDS—UNDERGROUND METAL AND NONMETAL MINES

    End Part Start Amendment Part

    3. The authority citation for part 57 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 30 U.S.C. 811.

    End Authority Start Amendment Part

    4. Amend § 57.5001 by revising the introductory text of paragraph (b)(1), adding a definition for asbestos fiber, and revising paragraph (b)(3) to read as follows:

    End Amendment Part
    Exposure limits for airborne contaminants.
    * * * * *

    (b) Asbestos standard—(1) Definitions. Asbestos is a generic term for a number of asbestiform hydrated silicates that, when crushed or processed, separate into flexible fibers made up of fibrils.

    * * * * *

    Asbestos fiber means a fiber of asbestos that meets the criteria of a fiber.

    * * * * *

    (3) Measurement of airborne asbestos fiber concentration. Potential asbestos fiber concentration shall be determined by phase contrast microscopy (PCM) using the OSHA Reference Method in OSHA's asbestos standard found in 29 CFR 1910.1001, Appendix A, or a method at least equivalent to that method in identifying a potential asbestos exposure exceeding the 0.1 f/cc full-shift limit or the 1 f/cc excursion limit. When PCM results indicate a potential exposure exceeding the 0.1 f/cc full-shift limit or the 1 f/cc excursion limit, samples shall be further analyzed using transmission electron microscopy according to NIOSH Method 7402 or a method at least equivalent to that method.

    * * * * *
    Start Part

    PART 71—MANDATORY HEALTH STANDARDS—SURFACE COAL MINES AND SURFACE WORK AREAS OF UNDERGROUND COAL MINES

    End Part Start Amendment Part

    5. The authority citation for part 71 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 30 U.S.C. 811, 951, 957.

    End Authority Start Amendment Part

    6. Amend § 71.702 by revising the introductory text of paragraph (a), adding a definition for asbestos fiber, and revising paragraph (c) to read as follows:

    End Amendment Part
    Asbestos standard.

    (a) Definitions. Asbestos is a generic term for a number of asbestiform hydrated silicates that, when crushed or processed, separate into flexible fibers made up of fibrils.

    * * * * *

    Asbestos fibe r means a fiber of asbestos that meets the criteria of a fiber.

    * * * * *

    (c) Measurement of airborne asbestos fiber concentration. Potential asbestos fiber concentration shall be determined by phase contrast microscopy (PCM) using the OSHA Reference Method in OSHA's asbestos standard found in 29 CFR 1910.1001, Appendix A, or a method at least equivalent to that method in identifying a potential asbestos exposure exceeding the 0.1 f/cc full-shift limit or the 1 f/cc excursion limit. When PCM results indicate a potential exposure exceeding the 0.1 f/cc full-shift limit or the 1 f/cc excursion limit, samples shall be further analyzed using transmission electron microscopy according to NIOSH Method 7402 or a method at least equivalent to that method.

    End Supplemental Information

    [FR Doc. E8-26440 Filed 11-6-08; 8:45 am]

    BILLING CODE 4510-43-P

Document Information

Effective Date:
11/7/2008
Published:
11/07/2008
Department:
Mine Safety and Health Administration
Entry Type:
Rule
Action:
Final rule, technical amendment.
Document Number:
E8-26440
Dates:
This technical amendment is effective November 7, 2008.
Pages:
66171-66172 (2 pages)
RINs:
1219-AB24: Asbestos Exposure Limit
RIN Links:
https://www.federalregister.gov/regulations/1219-AB24/asbestos-exposure-limit
Topics:
Asbestos, Chemicals, Hazardous substances, Metals, Mine safety and health
PDF File:
e8-26440.pdf
CFR: (3)
30 CFR 56.5001
30 CFR 57.5001
30 CFR 71.702