2018-07585. Branding Requirements for Bovines Imported Into the United States From Mexico  

  • Start Preamble Start Printed Page 15756

    AGENCY:

    Animal and Plant Health Inspection Service, USDA.

    ACTION:

    Proposed rule.

    SUMMARY:

    We are proposing to amend the regulations regarding the branding of bovines imported into the United States from Mexico. We are taking this action at the request of the Government of Mexico to address issues that have arisen with the branding requirement for these bovines. The changes we are proposing would help prevent inconsistencies in branding that can result in bovines being rejected for import into the United States.

    DATES:

    We will consider all comments that we receive on or before June 11, 2018.

    ADDRESSES:

    You may submit comments by either of the following methods:

    Supporting documents and any comments we receive on this docket may be viewed at http://www.regulations.gov/​#!docketDetail;​D=​APHIS-2016-0050 or in our reading room, which is located in room 1141 of the USDA South Building, 14th Street and Independence Avenue SW, Washington, DC. Normal reading room hours are 8 a.m. to 4:30 p.m., Monday through Friday, except holidays. To be sure someone is there to help you, please call (202) 799-7039 before coming.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Dr. Betzaida Lopez, Senior Staff Veterinarian, National Import Export Services, Policy, Permitting, and Regulatory Services, VS, APHIS, 4700 River Road Unit 39, Riverdale, MD 20737-1231; (301) 851-3300.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Background

    The regulations in 9 CFR part 93 prohibit or restrict the importation of certain animals, birds, and poultry into the United States to prevent the introduction of communicable diseases of livestock and poultry. Subpart D of part 93 (§§ 93.400 through 93.436, referred to below as the regulations) governs the importation of ruminants; within subpart D, § 93.427 specifically addresses the importation of cattle and other bovines from Mexico into the United States.

    In § 93.427, paragraph (c) contains conditions to prevent the spread of tuberculosis to U.S. livestock and paragraph (e) contains conditions to prevent the entry of bovine spongiform encephalopathy (BSE) via the importation of cattle and other bovines from Mexico. Under paragraph (c)(1), steers imported into the United States must be identified with a distinct, permanent, and legible “M” mark, and spayed heifers must be identified with a distinct, permanent, and legible “MX” mark, applied with a freeze brand, hot iron, or other method prior to arrival at a port of entry. The brands must not be less than 2 inches or more than 3 inches high, and must be applied to the animal's right hip, high on the tailhead (over the junction of the sacral and first coccygeal vertebrae).

    Under paragraph (e)(3), sexually intact bovines must be permanently and humanely identified using one of the following methods:

    • An “MX” mark applied with a freeze brand, hot iron, or other method prior to arrival at a port of entry. The brand must not be less than 2 inches or more than 3 inches high, and must be applied to the animal's right hip, high on the tailhead (over the junction of the sacral and first coccygeal vertebrae);
    • A tattoo with the letters MX applied to the inside of one ear of the animal; or
    • Other means of permanent identification upon request if deemed adequate by the Administrator to humanely identify the animal in a distinct and legible way as having been imported from Mexico.

    Several issues have arisen as a result of the branding requirements. The small size of the brands means that the brands may blotch when applied to the animals, making the brands difficult to read and potentially requiring the animal to be re-branded. In addition the “MX” brand required for spayed heifers and the “MX” brand for sexually intact cattle can be easily confused, resulting in doubt over whether animals have been correctly branded and in some cases causing them to be rejected for importation at the ports. The Government of Mexico has requested that we modify the requirements to address these issues.

    Accordingly, we are proposing to amend the requirements in § 93.427. In paragraph (c)(1), we would require steers and spayed heifers to be marked with a single “M” brand between 3 and 5 inches (7.5 and 12.5 cm) tall and wide to be placed on the right hip within 4 inches (10 cm) of the midline of the tailhead. This should be interpreted as the top of the brand being within 4 inches of the midline of the tailhead and placed above the hook and pin bones. The brand should also be within 18 inches (45.7 cm) of the anus.

    Increasing the size of the brands and simplifying them to a simple “M” would help reduce or eliminate branding errors, which in turn would reduce the need for rebranding and the incidence of cattle rejections at port-of-entry inspection. The change to the description of the placement of the brand clarifies the requirement by making the description more specific.

    Similarly, in paragraph (e)(3)(i) we would amend the branding option for sexually intact bovines from Mexico to provide for those animals to be branded with a single “M” brand between 3 and 5 inches (7.5 and 12.5 cm) tall and wide, located on the upper right front shoulder of the animal.

    As with the change for steers and spayed heifers, increasing the size of the brand for sexually intact animals would reduce or eliminate branding errors. Start Printed Page 15757Changing the placement of the brand for sexually intact bovines from the hip to the shoulders would allow steers and spayed heifers to be visually distinguished from breeding cattle while allowing the use of the simplified brand for both categories of animals. We are not proposing to change the tattoo option for sexually intact bovines in paragraph (e)(3)(ii) because the MX tattoo has not posed a problem with confusion or errors as the brands have.

    Executive Orders 12866 and 13771 and Regulatory Flexibility Act

    This proposed rule has been determined to be not significant for the purposes of Executive Order 12866 and, therefore, has not been reviewed by the Office of Management and Budget. Further, APHIS considers this rule to be a deregulatory action under Executive Order 13771 as the action may result in cost savings.

    In accordance with 5 U.S.C. 603, we have performed an initial regulatory flexibility analysis, which is summarized below, regarding the economic effects of this proposed rule on small entities. Copies of the full analysis are available by contacting the person listed under FOR FURTHER INFORMATION CONTACT or on the Regulations.gov website (see ADDRESSES above for instructions for accessing Regulations.gov).

    This proposed rule would amend the regulations in 9 CFR part 93 to change the identification requirements of bovines imported from Mexico. At present, cattle from Mexico carry at least two forms of identification, generally a brand and an approved eartag. Cattle imported from Mexico for other than immediate slaughter, are required to be branded with an “M” for steers, an “Mx” for spayed heifers, and an “MX” brand or tattoo for breeding bovines. APHIS is proposing that all bovines imported from Mexico be branded with a single “M” to avoid branding uncertainties. In order to distinguish between feeder and breeding cattle, the brand for steers and spayed heifers would be placed on the back hip and the brand for breeding cattle would be placed on the shoulder. Cattle imported from Mexico would still require an approved eartag.

    The new identification requirements would reduce if not eliminate questionable brands, reducing the need for rebranding and the incidence of cattle rejections at port-of-entry inspection. Revenue from hides accounts for about 75 percent of the byproduct-value of beef cattle. Damage from rebranding can reduce hide value. Also, re-inspection due to questionable brands increases transactions costs. Currently, a $4.00 inspection fee per head is billed to the broker who in turn charges the exporter. The single “M” brand would both minimize hide damage and the need for re-inspections. Because the approved eartag is a current requirement, we do not anticipate any additional costs would be incurred.

    Entities that may be impacted by the proposed rule fall into various categories of the North American Industry Classification System. The majority of these businesses are small entities.

    Based on a sample of the percentage of cattle in fiscal year 2015 that initially were not allowed entry from Mexico because of branding concerns, the decrease in the value of hides when rebranded, and the cost of re-inspection, we estimate annual cost savings attributable to the proposed rule may range from $113,900 to $248,700. There would also be unquantified cost savings from the expected reduction in delays at ports of entry due to branding issues. In accordance with guidance on complying with Executive Order 13771, the primary estimate of the cost savings for this rule is $181,300. This value is the mid-point of the above range in cost savings annualized in perpetuity using a 7 percent discount rate.

    Executive Order 12988

    This proposed rule has been reviewed under Executive Order 12988, Civil Justice Reform. If this proposed rule is adopted: (1) All State and local laws and regulations that are inconsistent with this rule will be preempted; (2) no retroactive effect will be given to this rule; and (3) administrative proceedings will not be required before parties may file suit in court challenging this rule.

    Paperwork Reduction Act

    In accordance with section 3507(d) of the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), the burden requirements included in this proposed rule are approved by the Office of Management and Budget under control number 0579-0040.

    E-Government Act Compliance

    The Animal and Plant Health Inspection Service is committed to compliance with the E-Government Act to promote the use of the internet and other information technologies, to provide increased opportunities for citizen access to Government information and services, and for other purposes. For information pertinent to E-Government Act compliance related to this proposed rule, please contact Ms. Kimberly Hardy, APHIS' Information Collection Coordinator, at (301) 851-2483.

    Start List of Subjects

    List of Subjects in Part 93

    • Animal diseases
    • Imports
    • Livestock
    • Poultry and poultry products
    • Quarantine
    • Reporting and recordkeeping requirements
    End List of Subjects

    Accordingly, we propose to amend 9 CFR part 93 as follows:

    Start Part

    PART 93—IMPORTATION OF CERTAIN ANIMALS, BIRDS, FISH, AND POULTRY, AND CERTAIN ANIMAL, BIRD, AND POULTRY PRODUCTS; REQUIREMENTS FOR MEANS OF CONVEYANCE AND SHIPPING CONTAINERS

    End Part Start Amendment Part

    1. The authority citation for part 93 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 7 U.S.C. 1622 and 8301-8317; 21 U.S.C. 136 and 136a; 31 U.S.C. 9701; 7 CFR 2.22, 2.80, and 371.4.

    End Authority Start Amendment Part

    2. Section 93.427 is amended by revising paragraphs (c)(1) and (e)(3)(i) to read as follows:

    End Amendment Part
    Cattle and other bovines from Mexico.
    * * * * *

    (c) * * *

    (1) Each steer or spayed heifer imported into the United States from Mexico shall be identified with a distinct, permanent, and legible “M” mark applied with a freeze brand, hot iron, or other method prior to arrival at a port of entry, unless the steer or spayed heifer is imported for slaughter in accordance with § 93.429. The “M” mark shall be between 3 inches (7.5 cm) and 5 inches (12.5 cm) high and wide, and shall be applied to each animal's right hip, within 4 inches (10 cm) of the midline of the tailhead (that is, the top of the brand should be within 4 inches (10 cm) of the midline of the tailhead, and placed above the hook and pin bones). The brand should also be within 18 inches (45.7 cm) of the anus.

    * * * * *

    (e) * * *

    (3) * * *

    (i) An “M” mark properly applied with a freeze brand, hot iron, or other method, and easily visible on the live animal and on the carcass before skinning. Such a mark must be between 3 inches (7.5 cm) and 5 inches (12.5 cm) high and wide, and must be applied to the upper right front shoulder of each animal; or

    * * * * *
    Start Signature
    Start Printed Page 15758

    Done in Washington, DC, this 9th day of April 2018.

    Kevin Shea,

    Administrator, Animal and Plant Health Inspection Service.

    End Signature End Supplemental Information

    [FR Doc. 2018-07585 Filed 4-11-18; 8:45 am]

    BILLING CODE 3410-34-P

Document Information

Published:
04/12/2018
Department:
Animal and Plant Health Inspection Service
Entry Type:
Proposed Rule
Action:
Proposed rule.
Document Number:
2018-07585
Dates:
We will consider all comments that we receive on or before June 11, 2018.
Pages:
15756-15758 (3 pages)
Docket Numbers:
Docket No. APHIS-2016-0050
RINs:
0579-AE38: Branding Requirements for Bovines Imported Into the United States From Mexico
RIN Links:
https://www.federalregister.gov/regulations/0579-AE38/branding-requirements-for-bovines-imported-into-the-united-states-from-mexico
PDF File:
2018-07585.Pdf
Supporting Documents:
» Branding Requirements for Bovines Imported Into The United States From Mexico: Initial Regulatory Flexibility Analysis