02-1507. Special Conditions: Avions Marcel Dassault-Breguet Aviation (AMD/BA) Model Falcon 10 Airplane; High-Intensity Radiated Fields (HIRF)
-
Start Preamble
Start Printed Page 2793
AGENCY:
Federal Aviation Administration, DOT.
ACTION:
Final special conditions; request for comments.
SUMMARY:
These special conditions are issued for Avions Marcel Dassault-Breguet Aviation (AMD/BA) Model Falcon 10 airplanes modified by Duncan Aviation, Inc. These modified airplanes will have novel and unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. The modification incorporates the installation of an air data display unit that displays critical flight parameters to the flightcrew. The applicable airworthiness standards do not contain adequate or appropriate safety standards for the protection of these systems from the effects of high-intensity radiated fields. The special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that provided by the existing airworthiness standards.
DATES:
The effective date of these special conditions is January 9, 2002. Comments must be received on or before February 21, 2002.
ADDRESSES:
Comments on these special conditions may be mailed in duplicate to: Federal Aviation Administration, Transport Airplane Directorate, Attn: Rules Docket (ANM-113), Docket No. NM209, 1601 Lind Avenue SW., Renton, Washington, 98055-4056; or delivered in duplicate to the Transport Airplane Directorate at the above address. Comments must be marked: Docket No. NM209. Comments may be inspected in the Rules Docket weekdays, except Federal holidays, between 7:30 a.m. and 4:00 p.m.
Start Further InfoFOR FURTHER INFORMATION CONTACT:
Meghan Gordon, FAA, Standardization Branch, ANM-113, Transport Airplane Directorate, Aircraft Certification Service, 1601 Lind Avenue SW., Renton, Washington, 98055-4056; telephone (425) 227-2138; facsimile (425) 227-1149.
End Further Info End Preamble Start Supplemental InformationSUPPLEMENTARY INFORMATION:
The FAA has determined that notice and opportunity for prior public comment hereon are impracticable because these procedures would significantly delay issuance of the approval design and thus delivery of the affected airplanes. In addition, the substance of these special conditions has been subject to the public comment process in several prior instances with no substantive comments received. The FAA therefore finds that good cause exists for making these special conditions effective upon issuance.
Comments Invited
The FAA invites interested persons to participate in this rulemaking by submitting written comments, data, or views. The most helpful comments reference a specific portion of the special conditions, explain the reason for any recommended change, and include supporting data. We ask that you send us two copies of written comments.
We will file in the docket all comments we receive, as well as a report summarizing each substantive public contact with FAA personnel concerning these special conditions. The docket is available for public inspection before and after the comment closing date. If you wish to review the docket in person, go to the address in the ADDRESSES section of this preamble between 7:30 a.m. and 4:00 p.m., Monday through Friday, except Federal holidays.
We will consider all comments we receive on or before the closing date for comments. We will consider comments filed late if it is possible to do so without incurring expense or delay. We may change these special conditions in light of the comments we receive.
If you want the FAA to acknowledge receipt of your comments on this proposal, include with your comments a pre-addressed, stamped postcard on which the docket number appears. We will stamp the date on the postcard and mail it back to you.
Background
On November 7, 2001, Duncan Aviation Inc., 15745 South Airport Road, Battle Creek, MI, 49015, applied for a supplemental type certificate (STC) to modify the Avions Marcel Dassault-Breguet Aviation (AMD/BA) Model Falcon 10 airplane listed on Type Certificate A33EU. The Model Falcon 10 is a twin engine, small transport airplane. It is capable of carrying two flightcrew members and up to nine passengers. This model is powered by two Airesearch Manufacturing Company of Arizona Model TPE731-2-1C engines. The modification incorporates the installation of an air data display system that displays critical flight parameters to the flightcrew. These systems can be susceptible to disruption to command and/or response signals as a result of electrical and magnetic interference. This disruption of signals could result in loss of all critical flight displays and announcement functions or present misleading information to the pilot.
Type Certification Basis
Under the provisions of 14 CFR 21.101, Duncan Aviation must show that the AMD/BA Model Falcon 10 airplanes, as changed, continue to meet the applicable provisions of the regulations incorporated by reference in Type Certificate No. A33EU, or the applicable regulations in effect on the date of application for the change. The regulations incorporated by reference in the type certificate are commonly referred to as the “original type certification basis.” The certification basis for the modified AMD/BA Model Falcon 10 airplane includes 14 CFR part 25, dated February 1, 1965, including Amendments 25-1 through 25-20, as listed in the Type Certificate Data Sheet (TCDS) A33EU.
If the Administrator finds that the applicable airworthiness regulations (i.e., part 25, as amended) do not contain adequate or appropriate safety standards for the AMD/BA Model Start Printed Page 2794Falcon 10 airplane because of a novel or unusual design feature, special conditions are prescribed under the provisions of § 21.16.
In addition to the applicable airworthiness regulations and special conditions, the Model Falcon 10 airplane must comply with the part 25 fuel vent and exhaust emission requirements of 14 CFR part 34 and the part 25 noise certification requirements of 14 CFR part 36.
Special conditions, as defined in § 11.19, are issued in accordance with § 11.38 and become part of the type certification basis in accordance with § 21.101(b)(2).
Special conditions are initially applicable to the model for which they are issued. Should Duncan Aviation, Inc. apply for a supplemental type certificate to modify any other model included on the same type certificate to incorporate the same novel or unusual design feature, these special conditions would also apply to the other model under the provisions of § 21.101(a)(1).
Novel or Unusual Design Features
The AMD/BA Model Falcon 10 airplane will incorporate the following novel or unusual design feature: an air data display unit that displays critical flight parameters to the flightcrew. These systems can be susceptible to disruption to command and/or response signals as a result of electrical and magnetic interference. This disruption of signals could result in loss of all critical flight displays and announcement functions or present misleading information to the pilot.
Discussion
There is no specific regulation that addresses protection requirements for electrical and electronic systems from HIRF. Increased power levels from ground-based radio transmitters and the growing use of sensitive avionic/electronic and electrical systems to command and control airplanes have made it necessary to provide adequate protection.
To ensure that a level of safety is achieved equivalent to that intended by the regulations incorporated by reference, special conditions are needed for the AMD/BA Model Falcon 10 as modified by Duncan Aviation Inc. These special conditions require that new avionic/electronic and electrical systems such as the air data display unit, that perform critical functions, be designed and installed to preclude component damage and interruption of function due to both the direct and indirect effects of HIRF.
High-Intensity Radiated Fields (HIRF)
With the trend toward increased power levels from ground-based transmitters, plus the advent of space and satellite communications, coupled with electronic command and control of the airplane, the immunity of critical digital avionics systems to HIRF must be established.
It is not possible to precisely define the HIRF to which the airplane will be exposed in service. There is also uncertainty concerning the effectiveness of airframe shielding for HIRF. Furthermore, coupling of electromagnetic energy to cockpit-installed equipment through the cockpit window apertures is undefined. Based on surveys and analysis of existing HIRF emitters, an adequate level of protection exists when compliance with the HIRF protection special condition is shown with either paragraph 1 or paragraph 2, below:
1. A minimum threat of 100 volts rms per meter electric field strength from 10 KHz to 18 GHz.
a. The threat must be applied to the system elements and their associated wiring harnesses without the benefit of airframe shielding.
b. Demonstration of this level of protection is established through system tests and analysis.
2. A threat external to the airframe of the field strengths indicated in Table 1 for the frequency ranges indicated. Both peak and average field strength components from Table 1 are to be demonstrated.
Table 1
Frequency Field Strength (volts per meter) Peak Average 10kHz-100 kHz 50 50 100kHz-500 kHz 50 50 500 kHz-2MHz 50 50 2 MHz-30 MHz 100 100 30 MHz-70 MHz 50 50 70 MHz-100 MHz 50 50 100 MHz-200 MHz 100 100 200 MHz-400 MHz 100 100 400 MHz-700 MHz 700 50 700 MHz-1 GHz 700 100 1 GHz-2 GHz 2000 200 2 GHz-4 GHz 3000 200 4 GHz-6 GHz 3000 200 6 GHz-8 GHz 1000 200 8 GHz-12 GHz 3000 300 12 GHz-18 GHz 2000 200 18 GHz-40 GHz 600 200 Note.—The field strengths are expressed in terms of peak of the root-mean-square (rms) over the complete modulation period. The threat levels identified above are the result of an FAA review of existing studies on the subject of HIRF, in light of the ongoing work of the Electromagnetic Effects Harmonization Working Group of the Aviation Rulemaking Advisory Committee.
Applicability
As discussed above, these special conditions are applicable to the Avions Marcel Dassault-Breguet Aviation (AMD/BA) Model Falcon 10 airplane modified by Duncan Aviation, Inc. Should Duncan apply at a later date for a supplemental type certificate to modify any other model included on the same type certificate to incorporate the same novel or unusual design feature, these special conditions would apply to that model as well under the provisions of § 21.101(a)(1).
Conclusion
This action affects only certain novel or unusual design features on AMD/BA Model Falcon 10 airplanes modified by Duncan Aviation, Inc. It is not a rule of general applicability and affects only the applicant who applied to the FAA for approval of these features on the airplane.
The substance of the special conditions for this airplane has been subjected to the notice and comment period in several prior instances and has been derived without substantive change from those previously issued. It is unlikely that prior public comment would result in a significant change from the substance contained herein. For this reason, and because a delay would significantly affect the certification of the airplane, which is imminent, the FAA has determined that prior public notice and comment are unnecessary and impracticable, and good cause exists for adopting these special conditions upon issuance. The FAA is requesting comments to allow interested persons to submit views that may not have been submitted in response to the prior opportunities for comment described above.
Start List of SubjectsList of Subjects in 14 CFR Part 25
- Aircraft
- Aviation safety
- Reporting and recordkeeping requirements
The authority citation for these special conditions is as follows:
The Special Conditions
Accordingly, pursuant to the authority delegated to me by the Administrator, the following special conditions are issued as part of the type certification basis for Avions Marcel Dassault-Breguet Aviation (AMD/BA) Model Falcon 10 airplanes modified by Duncan Aviation, Inc.
1. Protection from Unwanted Effects of High-Intensity Radiated Fields Start Printed Page 2795(HIRF). Each electrical and electronic system that performs critical functions must be designed and installed to ensure that the operation and operational capability of these systems to perform critical functions are not adversely affected when the airplane is exposed to high intensity radiated fields.
2. For the purpose of these special conditions, the following definition applies: Critical Functions: Functions whose failure would contribute to or cause a failure condition that would prevent the continued safe flight and landing of the airplane.
Start SignatureIssued in Renton, Washington, on January 9, 2002.
Ali Bahrami,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 02-1507 Filed 1-18-02; 8:45 am]
BILLING CODE 4910-13-U
Document Information
- Effective Date:
- 1/9/2002
- Published:
- 01/22/2002
- Department:
- Federal Aviation Administration
- Entry Type:
- Rule
- Action:
- Final special conditions; request for comments.
- Document Number:
- 02-1507
- Dates:
- The effective date of these special conditions is January 9, 2002. Comments must be received on or before February 21, 2002.
- Pages:
- 2793-2795 (3 pages)
- Docket Numbers:
- Docket No. NM209, Special Conditions No. 25-195-SC
- Topics:
- Aircraft, Aviation safety, Reporting and recordkeeping requirements
- PDF File:
- 02-1507.pdf
- CFR: (1)
- 14 CFR 25