E7-20137. Airworthiness Directives; Airbus Model A310 Series Airplanes  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration (FAA), Department of Transportation (DOT).

    ACTION:

    Final rule.

    SUMMARY:

    We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

    An incident occurred on one A300-600 aircraft at parking brake application. Both engines were running, the aircraft started moving again despite parking brake application. Captain tried to stop the aircraft via the pedals but, as the parking brake selector valve was selected, the aircraft could not be stopped (as per design, activation of the parking brake inhibits the other braking modes, and consequently prevents the recovery of the normal braking through the pedals). As part of the investigation, the pressure limiter was removed and examined. The expertise revealed a metallic wire aimed at reducing the section of one port of this equipment was found broken. A part of this wire partially obstructed the hole receiving this wire, thus delaying the build up of parking brake pressure.

    We are issuing this AD to require actions to correct the unsafe condition on these products.

    DATES:

    This AD becomes effective November 20, 2007.

    The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of November 20, 2007.

    ADDRESSES:

    You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Tom Stafford, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1622; fax (425) 227-1149.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on August 16, 2007 (72 FR 45976). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

    An incident occurred on one A300-600 aircraft at parking brake application. Both engines were running, the aircraft started moving again despite parking brake application. Captain tried to stop the aircraft via the pedals but, as the parking brake selector valve was selected, the aircraft could not be stopped (as per design, activation of the parking brake inhibits the other braking modes, and consequently prevents the recovery of the normal braking through the pedals). As part of the investigation, the pressure limiter was removed and examined. The expertise revealed a metallic wire aimed at reducing the section of one port of this equipment was found broken. A part of this wire partially obstructed the hole receiving this wire, thus delaying the build up of parking brake pressure. In order to avoid recurrence of the failure mode described above, EASA issued Airworthiness Directive (AD) 2006-0178 to require the replacement of the parking brake pressure limiter (FIN 323292).

    During embodiment of SB (Service Bulletin) 32-2133 on an A310 as per AD 2006-0178 (EASA AD 2006-0178 corresponds to FAA AD 2007-02-21, amendment 39-14908), an operator reported that the modified pressure limiter could not be fitted. Subsequent investigation concluded that A310 installation being slightly different from A300-600 aircraft, the approved solution was not directly adaptable to A310 aircraft. Start Printed Page 58490

    * * * This new AD, dealing with the same subject, requires the replacement of the brake pressure limiter by accomplishment of Airbus SB A310-32-2133, which has been revised to include the adaptation kit for A310 aircraft.

    You may obtain further information by examining the MCAI in the AD docket.

    Comments

    We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

    Conclusion

    We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

    Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

    We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a NOTE within the AD.

    Costs of Compliance

    We estimate that this AD will affect 68 products of U.S. registry. We also estimate that it will take about 6 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $80 per work-hour. Labor costs may be covered under warranty as described in the service information. Required parts will cost about $0 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $32,640, or $480 per product.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

    We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    Regulatory Findings

    We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify this AD:

    1. Is not a “significant regulatory action” under Executive Order 12866;

    2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

    3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

    Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov;​; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    Adoption of the Amendment

    Start Amendment Part

    Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

    End Amendment Part Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new AD:

    End Amendment Part

    2007-21-07 Airbus: Amendment 39-15225. Docket No. FAA-2007-28922; Directorate Identifier 2007-NM-132-AD.

    Effective Date

    (a) This airworthiness directive (AD) becomes effective November 20, 2007.

    Affected ADs

    (b) None.

    Applicability

    (c) This AD applies to Airbus Model A310 series airplanes, certificated in any category, except airplanes on which Airbus Service Bulletin A310-32-2133, Revision 02, dated February 26, 2007, has been embodied in service.

    Subject

    (d) Air Transport Association (ATA) of America Code 32: Landing gear.

    Reason

    (e) The mandatory continuing airworthiness information (MCAI) states:

    An incident occurred on one A300-600 aircraft at parking brake application. Both engines were running, the aircraft started moving again despite parking brake application. Captain tried to stop the aircraft via the pedals but, as the parking brake selector valve was selected, the aircraft could not be stopped (as per design, activation of the parking brake inhibits the other braking modes, and consequently prevents the recovery of the normal braking through the pedals). As part of the investigation, the pressure limiter was removed and examined. The expertise revealed a metallic wire aimed at reducing the section of one port of this equipment was found broken. A part of this wire partially obstructed the hole receiving this wire, thus delaying the build up of parking brake pressure. In order to avoid recurrence of the failure mode described above, EASA (European Aviation Safety Agency), issued Airworthiness Directive (AD) 2006-0178 to require the replacement of the parking brake pressure limiter (FIN 323292).

    During embodiment of SB (Service Bulletin) 32-2133 on an A310 as per AD 2006-0178 [EASA AD 2006-0178 corresponds to FAA AD 2007-02-21, amendment 39-14908], an operator reported that the modified pressure limiter could not be fitted. Subsequent investigation concluded that A310 installation being slightly different from A300-600 aircraft, the approved solution was not directly adaptable to A310 aircraft.

    * * * This new AD, dealing with the same subject, requires the replacement of the brake Start Printed Page 58491pressure limiter by accomplishment of Airbus SB A310-32-2133, which has been revised to include the adaptation kit for A310 aircraft.

    Actions and Compliance

    (f) Unless already done, do the following actions.

    (1) Within 10 months after the effective date of this AD, replace the parking brake pressure limiter (FIN 323292), in accordance with the instructions given in Airbus Service Bulletin A310-32-2133, Revision 02, dated February 26, 2007.

    (2) [Reserved]

    FAA AD Differences

    Note:

    This AD differs from the MCAI and/or service information as follows: No difference.

    Other FAA AD Provisions

    (g) The following provisions also apply to this AD:

    (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Stafford, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1622; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

    (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

    (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056.

    Related Information

    (h) Refer to MCAI EASA Airworthiness Directive 2007-0151, dated May 22, 2007; Airbus Service Bulletin A310-32-2133, Revision 02, dated February 26, 2007; and Messier-Bugatti Service Bulletin C24264-32-848, dated February 15, 2006, for related information.

    Material Incorporated by Reference

    (i) You must use Airbus Service Bulletin A310-32-2133, Revision 02, dated February 26, 2007, to do the actions required by this AD, unless the AD specifies otherwise.

    (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51.

    (2) For service information identified in this AD, contact Airbus, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France.

    (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

    Start Signature

    Issued in Renton, Washington, on October 3, 2007.

    Ali Bahrami,

    Manager, Transport Airplane Directorate, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. E7-20137 Filed 10-15-07; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Comments Received:
0 Comments
Effective Date:
11/20/2007
Published:
10/16/2007
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule.
Document Number:
E7-20137
Dates:
This AD becomes effective November 20, 2007.
Pages:
58489-58491 (3 pages)
Docket Numbers:
Docket No. FAA-2007-28922, Directorate Identifier 2007-NM-132-AD, Amendment 39-15225, AD 2007-21-07
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
e7-20137.pdf
CFR: (1)
14 CFR 39.13