2012-25458. Airworthiness Directives; Airbus Airplanes  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration (FAA), DOT.

    ACTION:

    Notice of proposed rulemaking (NPRM).

    SUMMARY:

    We propose to adopt a new airworthiness directive (AD) for all Airbus Model A310-203 airplanes. This proposed AD was prompted by a report of an analysis that demonstrated a reduced fatigue life for the side link bolts, center sway link bolts, and thrust link bolts on the forward engine mounts. This proposed AD would require repetitive replacement of those Start Printed Page 63269bolts. We are proposing this AD to prevent deterioration of the structural integrity of the bolts, which could result in possible damage to an engine or wing.

    DATES:

    We must receive comments on this proposed AD by November 30, 2012.

    ADDRESSES:

    You may send comments by any of the following methods:

    • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
    • Fax: (202) 493-2251.
    • Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
    • Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

    For service information identified in this proposed AD, contact Airbus SAS—EAW (Airworthiness Office), 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; email account.airworth-eas@airbus.com; Internet http://www.airbus.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

    Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov;​; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone (425) 227-2125; fax (425) 227-1147.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Comments Invited

    We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2012-1071; Directorate Identifier 2012-NM-070-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.

    We will post all comments we receive, without change, to http://www.regulations.gov,, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.

    Discussion

    The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2012-0056, dated April 3, 2012 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:

    Post type-certification analyses performed in the frame of the Extended Service Goal (ESG) exercise, demonstrated a reduced fatigue life for the side link bolts, centre sway link bolts and thrust link bolts of the General Electric (GE) CF6-80A3 forward engine mounts.

    This condition, if left uncorrected, could result in a deterioration of the structural integrity of the front engine mount bolts [and possible damage to an engine or wing].

    For the reasons described above, this [EASA] AD requires [repetitive] replacement of all side link bolts, centre sway link bolts and all thrust link bolts of GE CF6-80A3 powered aeroplanes.

    You may obtain further information by examining the MCAI in the AD docket.

    Relevant Service Information

    Airbus has issued Mandatory Service Bulletin A310-71-2037, including Appendices 01 and 02, dated September 30, 2011. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.

    FAA's Determination and Requirements of This Proposed AD

    This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.

    Costs of Compliance

    Based on the service information, we estimate that this proposed AD would affect about 30 products of U.S. registry. We also estimate that it would take about 139 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $4,810 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $498,750, or $16,625 per product.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

    We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    Regulatory Findings

    We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify this proposed regulation:

    1. Is not a “significant regulatory action” under Executive Order 12866;

    2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);Start Printed Page 63270

    3. Will not affect intrastate aviation in Alaska; and

    4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    The Proposed Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

    Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]

    2. The FAA amends § 39.13 by adding the following new AD:

    Airbus: Docket No. FAA-2012-1071; Directorate Identifier 2012-NM-070-AD.

    (a) Comments Due Date

    We must receive comments by November 30, 2012.

    (b) Affected ADs

    None.

    (c) Applicability

    This AD applies to all Airbus Model A310-203 airplanes, certificated in any category.

    (d) Subject

    Air Transport Association (ATA) of America Code 71; Powerplant.

    (e) Reason

    This AD was prompted by a report of an analysis that demonstrated a reduced fatigue life for the side link bolts, center sway link bolts, and thrust link bolts on the forward engine mounts. We are issuing this AD to prevent deterioration of the structural integrity of the bolts, which could result in possible damage to an engine or wing.

    (f) Compliance

    You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

    (g) Actions

    Within 18 months after the effective date of this AD, replace all side link bolts on left hand (LH) and right hand (RH) side of the engines, and all center sway link bolts and thrust link bolts of both engines, having any part number (P/N) identified in paragraphs (g)(1) through (g)(6) of this AD, with new bolts having the same part number, in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A310-71-2037, including Appendices 01 and 02, dated September 30, 2011. Repeat the bolt replacements thereafter at intervals not exceeding 134 months.

    (1) P/N 9021M88P01

    (2) P/N 9021M88P02

    (3) P/N 9205M81P01

    (4) P/N 9021M88P03

    (5) P/N 9021M88P04

    (6) P/N 9205M82P01

    (h) Other FAA AD Provisions

    The following provisions also apply to this AD:

    (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone (425) 227-2125; fax (425) 227-1147. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.

    (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

    (i) Related Information

    (1) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2012-0056, dated April 3, 2012; and Airbus Mandatory Service Bulletin A310-71-2037, including Appendices 01 and 02, dated September 30, 2011; for related information.

    (2) For service information identified in this AD, contact Airbus SAS—EAW (Airworthiness Office), 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; email account.airworth-eas@airbus.com; Internet http://www.airbus.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

    Start Signature

    Issued in Renton, Washington, on October 4, 2012.

    Dionne Palermo,

    Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

    End Signature End Part End Supplemental Information

    [FR Doc. 2012-25458 Filed 10-15-12; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Comments Received:
0 Comments
Published:
10/16/2012
Department:
Federal Aviation Administration
Entry Type:
Proposed Rule
Action:
Notice of proposed rulemaking (NPRM).
Document Number:
2012-25458
Dates:
We must receive comments on this proposed AD by November 30, 2012.
Pages:
63268-63270 (3 pages)
Docket Numbers:
Docket No. FAA-2012-1071, Directorate Identifier 2012-NM-070-AD
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
2012-25458.pdf
Supporting Documents:
» U.S. DOT/FAA - See Attachments
» U.S. DOT/FAA - See Attachments
» U.S. DOT/FAA - See Attachments
CFR: (1)
14 CFR 39.13