03-27268. Revisions to the California State Implementation Plan, Bay Area Air Quality Management District

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Proposed rule.

SUMMARY:

EPA is proposing to approve revisions to the Bay Area Air Quality Management District portion of the California State Implementation Plan (SIP). These revisions concern volatile organic compound (VOC) emissions from solvent and surface cleaning operations during large appliance and metal furniture coating, miscellaneous metal parts coating, plastic parts and products coating, and marine vessel coating. We are proposing to approve local rules to regulate these emission sources under the Clean Air Act as amended in 1990 (CAA or the Act).

DATES:

Any comments on this proposal must arrive by December 1, 2003.

ADDRESSES:

Mail comments to Andy Steckel, Rulemaking Office Chief (AIR-4), U.S. Environmental Protection Agency, Region IX, 75 Hawthorne Street, San Francisco, CA 94105-3901 or e-mail to [e-mail].

You can inspect copies of the submitted SIP revisions and EPA's technical support documents (TSDs) at our Region IX office during normal business hours. You may also see copies of the submitted SIP revisions at the following locations:

California Air Resources Board, Stationary Source Division, Rule Evaluation Section, 1001 “I” Street, Sacramento, CA 95814; and,

Bay Area Air Quality Management District, 939 Ellis Street, San Francisco, CA 94109.

A copy of the rule may also be available via the Internet at http://www.arb.ca.gov/​drdb/​drdbltxt.htm. Please be advised that this is not an EPA Web site and may not contain the same version of the rule that was submitted to EPA.

FOR FURTHER INFORMATION CONTACT:

Jerald S. Wamsley, EPA Region IX, [phone], or e-mail at [e-mail].

SUPPLEMENTARY INFORMATION:

This proposal addresses the following BAAQMD rules: Rule 8-14, Surface Preparation and Coating of Large Appliances and Metal Furniture; Rule 8-19, Surface Preparation and Coating of Miscellaneous Metal Parts and Products; Rule 8-31, Surface Preparation and Coating of Plastic Parts and Products; and Rule 8-43, Surface Preparation and Coating of Marine Vessels. In the Rules and Regulations section of this Federal Register, we are approving these local rules in a direct final action without prior proposal because we believe these SIP revisions are not controversial. If we receive adverse comments, however, we will publish a timely withdrawal of the direct final rule and address the comments in subsequent action based on this proposed rule. Please note that if we receive adverse comment on an amendment, paragraph, or section of this rule and if that provision may be severed from the remainder of the rule, we may adopt as final those provisions of the rule that are not the subject of an adverse comment.

We do not plan to open a second comment period, so anyone interested in commenting should do so at this time. If we do not receive adverse comments, no further activity is planned. For further information, please see the direct final action.

Dated: October 6, 2003.

Laura Yoshii,

Acting Regional Administrator, Region IX.