2013-25132. Airworthiness Directives; The Boeing Company Airplanes

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Final rule.

SUMMARY:

We are adopting a new airworthiness directive (AD) for all The Boeing Company Model 727 airplanes. This AD was prompted by reports indicating that a standard fuel tank access door was located where an impact-resistant access door was required, and stencils were missing from some impact-resistant access doors. This AD requires an inspection of the left- and right-hand wing fuel tank access doors to determine that impact-resistant access doors are installed in the correct locations, and to replace any door with an impact-resistant access door if necessary. This AD also requires an inspection for stencils and index markers on impact-resistant access doors, and application of new stencils or index markers if necessary. This AD also requires revising the maintenance program to incorporate changes to the airworthiness limitations section. We are issuing this AD to prevent foreign object penetration of the fuel tank, which could cause a fuel leak near an ignition source (e.g., hot brakes), consequently leading to a fuel-fed fire.

DATES:

This AD is effective December 5, 2013.

The Director of the Federal Register approved the incorporation by reference of certain publications listed in this AD as of December 5, 2013.

ADDRESSES:

For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone [phone], extension 1; fax [phone]; Internet https://www.myboeingfleet.com. You may review this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov;​; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The address for the Docket Office (phone: [phone]) is Document Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT:

Suzanne Lucier, Aerospace Engineer, Propulsion Branch, ANM-140S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: [phone]; fax: [phone]; email: [e-mail].

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to the specified products. The NPRM published in the Federal Register on August 1, 2013 (78 FR 46538). The NPRM proposed to require an inspection of the left- and right-hand wing fuel tank access doors to determine that impact-resistant access doors are installed in the correct locations, and to replace any door with an impact-resistant access door if necessary. The NPRM also proposed to require an inspection for stencils and index markers on impact-resistant access doors, and application of new stencils or index markers if necessary. The NPRM also proposed to require revising the maintenance program to incorporate changes to the airworthiness limitations section.

Comments

We gave the public the opportunity to participate in developing this AD. We have considered the comment received. The Boeing Company supported the NPRM (78 FR 46538, August 1, 2013).

Conclusion

We reviewed the relevant data, considered the comments received, and determined that air safety and the public interest require adopting this AD as proposed—except for minor editorial changes. We have determined that these minor changes:

• Are consistent with the intent that was proposed in the NPRM (78 FR 46538, August 1, 2013) for correcting the unsafe condition; and
• Do not add any additional burden upon the public than was already proposed in the NPRM (78 FR 46538, August 1, 2013).

Costs of Compliance

We estimate that this AD affects 139 airplanes of U.S. registry. We estimate the following costs to comply with this AD:

Estimated Costs

Action	Labor cost	Parts cost	Cost per product	Cost on U.S. operators
Inspection	Up to 3 work-hours × $85 per hour = $255	$0	$255	$35,445
Maintenance program revision	1 work-hour × $85 per hour = $85	0	85	11,815

We estimate the following costs to do any necessary replacements that would be required based on the results of the inspection. We have no way of determining the number of aircraft that might need these replacements:

On-Condition Costs

Action	Labor cost	Parts cost	Cost per product
Replacement per door	3 work-hours × $85 per hour = $255	$8,000	$8,255
Stencil and index marker	Up to 2 work-hours × $85 per hour = $170	0	170

According to the manufacturer, some of the costs of this AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all costs in our cost estimate.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

2013-22-03 The Boeing Company: Amendment 39-17635; Docket No. FAA-2013-0666; Directorate Identifier 2013-NM-060-AD.

(a) Effective Date

This AD is effective December 5, 2013.

(b) Affected ADs

None.

(c) Applicability

This AD applies to all The Boeing Company Model 727, 727C, 727-100, 727-100C, 727-200, and 727-200F series airplanes; certificated in any category.

(d) Subject

Joint Aircraft System Component (JASC)/Air Transport Association (ATA) of America Code 28, Fuel.

(e) Unsafe Condition

This AD was prompted by reports indicating that a standard fuel tank access door was located where an impact-resistant access door was required, and stencils were missing from some impact-resistant access doors. We are issuing this AD to prevent foreign object penetration of the fuel tank, which could cause a fuel leak near an ignition source (e.g., hot brakes), consequently leading to a fuel-fed fire.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Inspections

Within 72 months after the effective date of this AD, do the actions specified in paragraphs (g)(1) and (g)(2) of this AD, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 727-28-0134, dated January 12, 2012.

(1) Do either a general visual inspection or ultrasonic non-destructive test of the left- and right-hand wing fuel tank access doors to determine whether impact-resistant access doors are installed in the correct locations. If any standard access door is found, before further flight, replace with an impact-resistant access door, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 727-28-0134, dated January 12, 2012.

(2) Do a general visual inspection of the left- and right-hand wing fuel tank impact-resistant access doors to verify stencils and index markers are applied. If a stencil or index marker is missing, before further flight, apply stencil or index marker, as applicable, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 727-28-0134, dated January 12, 2012.

(h) Maintenance Program Revision

Within 60 days after the effective date of this AD, revise the maintenance program to incorporate Critical Design Configuration Control Limitation (CDCCL) Task 57-AWL-01, “Impact-Resistant Fuel Tank Access Door,” of Section 1, Airworthiness Limitations (AWLs) of Boeing 727-100/200 Airworthiness Limitations (AWLs) Document D6-8766-AWL, Revision September 2012.

(i) No Alternative CDCCLs

After accomplishing the revision required by paragraph (h) of this AD, no alternative CDCCLs may be used unless the CDCCLs are approved as an alternative method of compliance in accordance with the procedures specified in paragraph (j) of this AD.

(j) Alternative Methods of Compliance (AMOCs)

(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to: [e-mail].

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD if it is approved by the Boeing Commercial Airplanes Organization Designation Authorization (ODA) that has been authorized by the Manager, Seattle ACO to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane, and the approval must specifically refer to this AD.

(k) Related Information

For more information about this AD, contact Suzanne Lucier, Aerospace Engineer, Propulsion Branch, ANM-140S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: [phone]; fax: [phone]; email: [e-mail].

(l) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.

(i) Boeing Service Bulletin 727-28-0134, dated January 12, 2012.

(ii) Critical Design Configuration Control Limitation (CDCCL) Task 57-AWL-01, “Impact-Resistant Fuel Tank Access Door,” of Section 1, Airworthiness Limitations (AWLs) of Boeing 727-100/200 Airworthiness Limitations (AWLs) Document D6-8766-AWL, Revision September 2012.

(3) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone [phone], extension 1; fax [phone]; Internet https://www.myboeingfleet.com.

(4) You may view this service information at FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

Issued in Renton, Washington, on October 15, 2013.

Jeffrey E. Duven,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.