2024-23073. Crystalline Silicon Photovoltaic Cells, Whether or Not Assembled Into Modules, From the People's Republic of China: Continuation of Antidumping Duty Order and Countervailing Duty Order
-
AGENCY:
Enforcement and Compliance, International Trade Administration, Department of Commerce.
SUMMARY:
As a result of the determinations by the U.S. Department of Commerce (Commerce) and the U.S. International Trade Commission (ITC) that the revocation of the antidumping duty (AD) order and countervailing duty (CVD) order on certain crystalline silicon photovoltaic cells, whether or not assembled into modules (solar cells), from the People's Republic of China (China) would likely lead to the continuation or recurrence of dumping and net countervailable subsidies, and material injury to an industry in the United States, Commerce is publishing a notice of continuation of these AD and CVD orders.
DATES:
Applicable September 20, 2024.
FOR FURTHER INFORMATION CONTACT:
Jose Rivera (CVD) and Howard Smith (AD), AD/CVD Operations, Enforcement and Compliance, International Trade Administration, U.S. Department of Commerce, 1401 Constitution Avenue NW, Washington, DC 20230; telephone: (202) 482-0842, or (202) 482-5193, respectively.
SUPPLEMENTARY INFORMATION:
Background
On December 7, 2012, Commerce published in the Federal Register the AD Order and CVD Order on solar cells from China.[1] On February 1, 2024, Commerce initiated the second sunset review of the Orders,[2] pursuant to section 751(c) of the Tariff Act of 1930, as amended (the Act). As a result of its review, Commerce determined that revocation of the Orders would likely lead to the continuation or recurrence of dumping and net countervailable subsidies, and therefore, notified the ITC of the magnitude of the margins of dumping and subsidy rates likely to prevail should the Orders be revoked.[3]
On September 20, 2024, the ITC published its determination, pursuant to sections 751(c) and 752(a) of the Act, that revocation of the Orders would likely lead to continuation or recurrence of material injury to an industry in the United States within a reasonably foreseeable time.[4]
Scope of the Orders
The merchandise covered by the Orders are crystalline silicon photovoltaic cells, and modules, laminates, and panels, consisting of crystalline silicon photovoltaic cells, whether or not partially or fully ( print page 81042) assembled into other products, including, but not limited to, modules, laminates, panels and building integrated materials.
The Orders covers crystalline silicon photovoltaic cells of thickness equal to or greater than 20 micrometers, having a p/n junction formed by any means, whether or not the cell has undergone other processing, including, but not limited to, cleaning, etching, coating, and/or addition of materials (including, but not limited to, metallization and conductor patterns) to collect and forward the electricity that is generated by the cell.
Merchandise under consideration may be described at the time of importation as parts for final finished products that are assembled after importation, including, but not limited to, modules, laminates, panels, building-integrated modules, building-integrated panels, or other finished goods kits. Such parts that otherwise meet the definition of merchandise under consideration are included in the scope of the Orders.
Excluded from the scope of the Orders are thin film photovoltaic products produced from amorphous silicon (a-Si), cadmium telluride (CdTe), or copper indium gallium selenide (CIGS).
Also excluded from the scope of the Orders are crystalline silicon photovoltaic cells, not exceeding 10,000 mm2 in surface area, that are permanently integrated into a consumer good whose function is other than power generation and that consumes the electricity generated by the integrated crystalline silicon photovoltaic cell. Where more than one cell is permanently integrated into a consumer good, the surface area for purposes of this exclusion shall be the total combined surface area of all cells that are integrated into the consumer good.
Additionally, excluded from the scope of the Orders are panels with surface area from 3,450 mm2 to 33,782 mm2 with one black wire and one red wire (each of type 22 AWG or 24 AWG not more than 206 mm in length when measured from panel extrusion), and not exceeding 2.9 volts, 1.1 amps, and 3.19 watts. For the purposes of this exclusion, no panel shall contain an internal battery or external computer peripheral ports.
Also excluded from the scope of the Orders are:
1. Off grid CSPV panels in rigid form with a glass cover, with the following characteristics:
(A) a total power output of 100 watts or less per panel;
(B) a maximum surface area of 8,000 cm2 per panel;
(C) do not include a built-in inverter;
(D) must include a permanently connected wire that terminates in either an 8mm male barrel connector, or a two-port rectangular connector with two pins in square housings of different colors;
(E) must include visible parallel grid collector metallic wire lines every 1-4 millimeters across each solar cell; and
(F) must be in individual retail packaging (for purposes of this provision, retail packaging typically includes graphics, the product name, its description and/or features, and foam for transport); and
2. Off grid CSPV panels without a glass cover, with the following characteristics:
(A) a total power output of 100 watts or less per panel;
(B) a maximum surface area of 8,000 cm2 per panel;
(C) do not include a built-in inverter;
(D) must include visible parallel grid collector metallic wire lines every 1-4 millimeters across each solar cell; and
(E) each panel is
1. permanently integrated into a consumer good;
2. encased in a laminated material without stitching, or
3. has all of the following characteristics: (i) the panel is encased in sewn fabric with visible stitching, (ii) includes a mesh zippered storage pocket, and (iii) includes a permanently attached wire that terminates in a female USB-A connector.
In addition, the following CSPV panels are excluded from the scope of the Orders:
(1) off-grid CSPV panels in rigid form with a glass cover, with each of the following physical characteristics, whether or not assembled into a fully completed off-grid hydropanel whose function is conversion of water vapor into liquid water:
(A) A total power output of no more than 80 watts per panel;
(B) A surface area of less than 5,000 square centimeters (cm2) per panel;
(C) Do not include a built-in inverter;
(D) Do not have a frame around the edges of the panel;
(E) Include a clear glass back panel; and
(F) Must include a permanently connected wire that terminates in a two-port rectangular connector.
Modules, laminates, and panels produced in a third-country from cells produced in China are covered by the Orders; however, modules, laminates, and panels produced in China from cells produced in a third-country are not covered by the Orders.
Additionally excluded from the scope of the Order are off-grid small portable crystalline silicon photovoltaic panels, with or without a glass cover, with the following characteristics: (1) a total power output of 200 watts or less per panel; (2) a maximum surface area of 16,000 cm2 per panel; (3) no built-in inverter; (4) an integrated handle or a handle attached to the package for ease of carry; (5) one or more integrated kickstands for easy installation or angle adjustment; and (6) a wire of not less than 3 meters either permanently connected or attached to the package that terminates in an 8mm diameter male barrel connector.
Also excluded from the scope of the Orders are off-grid crystalline silicon photovoltaic panels in rigid form with a glass cover, with each of the following physical characteristics, whether or not assembled into a fully completed off-grid hydropanel whose function is conversion of water vapor into liquid water:
(A) A total power output of no more than 180 watts per panel at 155 degrees Celsius;
(B) A surface area of less than 16,000 square centimeters (cm2 ) per panel;
(C) Include a keep-out area of approximately 1,200 cm2 around the edges of the panel that does not contain solar cells;
(D) Do not include a built-in inverter;
(E) Do not have a frame around the edges of the panel;
(F) Include a clear glass back panel;
(G) Must include a permanently connected wire that terminates in a two-port rounded rectangular, sealed connector;
(H) Include a thermistor installed into the permanently connected wire before the two-port connector; and
(I) Include exposed positive and negative terminals at opposite ends of the panel, not enclosed in a junction box.
Merchandise covered by this Order is currently classified in the Harmonized Tariff System of the United States (HTSUS) under subheadings 8501.71.0000, 8501.72.1000, 8501.72.2000, 8501.72.3000, 8501.72.9000, 8501.80.1000, 8501.80.2000, 8501.80.3000, 8501.80.9000, 8507.20.8010, 8507.20.8031, 8507.20.8041, 8507.20.8061, 8507.20.8091, 8541.42.0010, and 8541.43.0010. These HTSUS subheadings are provided for convenience and customs purposes; the written description of the scope of the Orders are dispositive.
Continuation of the Orders
As a result of the determinations by Commerce and the ITC that revocation of the Orders would likely lead to ( print page 81043) continuation or recurrence of dumping and net countervailable subsidies, and material injury to an industry in the United States, pursuant to section 751(d)(2) of the Act, Commerce hereby orders the continuation of the Orders. U.S. Customs and Border Protection will continue to collect AD and CVD cash deposits at the rates in effect at the time of entry for all imports of subject merchandise.
The effective date of the continuation of the Orders will be September 20, 2024.[5] Pursuant to section 751(c)(2) of the Act and 19 CFR 351.218(c)(2), Commerce intends to initiate the next five-year reviews of the Orders not later than 30 days prior to fifth anniversary of the date of the last determination by the ITC.
Administrative Protective Order (APO)
This notice also serves as a final reminder to parties subject to an APO of their responsibility concerning the return or destruction of proprietary information disclosed under APO in accordance with 19 CFR 351.305(a)(3), which continues to govern business proprietary information in this segment of the proceeding. Timely written notification of the return or destruction of APO materials, or conversion to judicial protective order, is hereby requested. Failure to comply with the regulations and terms of an APO is a violation which is subject to sanction.
Notification to Interested Parties
These five-year (sunset) reviews and this notice are issued in accordance with sections 751(c) and 751(d)(2) of the Act, and published in accordance with section 777(i) of the Act and 19 CFR 351.218(f)(4).
Dated: October 1, 2024.
Ryan Majerus,
Deputy Assistant Secretary for Policy and Negotiations, performing the non-exclusive functions and duties of the Assistant Secretary for Enforcement and Compliance.
Footnotes
1. See Crystalline Silicon Photovoltaic Cells, Whether or Not Assembled into Modules, from the People's Republic of China: Countervailing Duty Order,77 FR 73017 (December 7, 2012) ( CVD Order); and Crystalline Silicon Photovoltaic Cells, Whether or Not Assembled Into Modules, from the People's Republic of China: Amended Final Determination of Sales at Less Than Fair Value, and Antidumping Duty Order,77 FR 73018 (December 7, 2012) ( AD Order) (collectively, the Orders).
Back to Citation2. See Initiation of Five-Year (Sunset) Reviews,89 FR 6499 (February 1, 2024).
Back to Citation3. See Crystalline Silicon Photovoltaic Cells, Whether or Not Assembled Into Modules, from the People's Republic of China: Final Results of the Expedited Second Sunset Review of the Antidumping Duty Order,89 FR 48391 (June 6, 2024), and accompanying Issues and Decision Memorandum (IDM); see also Crystalline Silicon Photovoltaic Cells, Whether or Not Assembled Into Modules, from the People's Republic of China: Final Results of the Expedited Second Sunset Review of the Countervailing Duty Order,89 FR 48559 (June 7, 2024), and accompanying IDM.
Back to Citation4. See Citation to ITC Notice,89 FR 78900 (September 20, 2024) ( ITC Final Determination).
Back to Citation5. See ITC Final Determination.
Back to Citation[FR Doc. 2024-23073 Filed 10-4-24; 8:45 am]
BILLING CODE 3510-DS-P
Document Information
- Published:
- 10/07/2024
- Department:
- International Trade Administration
- Entry Type:
- Notice
- Document Number:
- 2024-23073
- Dates:
- Applicable September 20, 2024.
- Pages:
- 81041-81043 (3 pages)
- Docket Numbers:
- A-570-979, C-570-980
- PDF File:
- 2024-23073.pdf