[Federal Register Volume 61, Number 197 (Wednesday, October 9, 1996)]
[Notices]
[Pages 52993-52994]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 96-25887]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
[Docket No. 96-105; Notice 1]
Notice of Receipt of Petition for Decision That Nonconforming
1989 Honda Prelude Passenger Cars are Eligible for Importation
AGENCY: National Highway Traffic Safety Administration, DOT.
ACTION: Notice of receipt of petition for decision that nonconforming
1989 Honda Prelude passenger cars are eligible for importation.
-----------------------------------------------------------------------
SUMMARY: This notice announces receipt by the National Highway Traffic
Safety Administration (NHTSA) of a petition for a decision that a 1989
Honda Prelude that was not originally manufactured to comply with all
applicable Federal motor vehicle safety standards is eligible for
importation into the United States because (1) it is substantially
similar to a vehicle that was originally manufactured for importation
into and sale in the United States and that was certified by its
manufacturer as complying with the safety standards, and (2) it is
capable of being readily altered to conform to the standards.
DATES: The closing date for comments on the petition is November 8,
1996.
ADDRESSES: Comments should refer to the docket number and notice
number, and be submitted to: Docket Section, Room 5109, National
Highway Traffic Safety Administration, 400 Seventh St., SW, Washington,
DC 20590. [Docket hours are from 9:30 am to 4 pm]
FOR FURTHER INFORMATION CONTACT: George Entwistle, Office of Vehicle
Safety Compliance, NHTSA (202-366-5306).
SUPPLEMENTARY INFORMATION:
Background
Under 49 U.S.C. 30141(a)(1)(A), a motor vehicle that was not
originally manufactured to conform to all applicable Federal motor
vehicle safety standards shall be refused admission into the United
States unless NHTSA has decided that the motor vehicle is substantially
similar to a motor vehicle originally manufactured for importation into
and sale in the United States, certified under 49 U.S.C. Sec. 30115,
and of the same model year as the model of the motor vehicle to be
compared, and is capable of being readily altered to conform to all
applicable Federal motor vehicle safety standards.
Petitions for eligibility decisions may be submitted by either
manufacturers or importers who have registered with NHTSA pursuant to
49 CFR Part 592. As specified in 49 CFR 593.7, NHTSA publishes notice
in the Federal Register of each petition that it receives, and affords
interested persons an opportunity to comment on the petition. At the
close of the comment period, NHTSA decides, on the basis of the
petition and any comments that it has received, whether the vehicle is
eligible for importation. The agency then publishes this decision in
the Federal Register.
Champagne Imports, Inc. of Lansdale, Pennsylvania, California
(``Champagne'') (Registered Importer 90-009) has petitioned NHTSA to
decide whether 1989 Honda Prelude passenger cars are eligible for
importation into the United States. The vehicle which Champagne
believes is substantially similar is the 1989 Honda Prelude that was
manufactured for importation into, and sale in, the United States and
certified by its manufacturer as conforming to all applicable Federal
motor vehicle safety standards.
The petitioner claims that it carefully compared the non-U.S.
certified 1989 Honda Prelude to its U.S. certified counterpart, and
found the two vehicles to be substantially similar with respect to
compliance with most Federal motor vehicle safety standards.
Champagne submitted information with its petition intended to
demonstrate that the non-U.S. certified 1989 Honda Prelude, as
originally manufactured, conforms to many Federal motor vehicle safety
standards in the same manner as its U.S. certified counterpart, or is
capable of being readily altered to conform to those standards.
Specifically, the petitioner claims that the non-U.S. certified
1989 Honda Prelude is identical to its U.S. certified counterpart with
respect to compliance with Standards Nos. 102 Transmission Shift Lever
Sequence * * *., 103 Defrosting and Defogging Systems, 104 Windshield
Wiping and Washing Systems, 105 Hydraulic Brake Systems, 106 Brake
Hoses, 109 New Pneumatic Tires, 112 Headlamp Concealment Devices, 113
Hood Latch Systems, 116 Brake Fluid, 124 Accelerator Control Systems,
201 Occupant Protection in Interior Impact, 202 Head Restraints, 203
Impact Protection for the Driver From the Steering Control System, 204
Steering Control Rearward Displacement, 205 Glazing Materials, 206 Door
Locks and Door Retention Components, 207 Seating Systems, 209 Seat Belt
Assemblies, 210 Seat Belt Assembly Anchorages, 212 Windshield
Retention, 216 Roof Crush Resistance, 219 Windshield Zone Intrusion,
and 302 Flammability of Interior Materials.
Petitioner also contends that the vehicle is capable of being
readily
[[Page 52994]]
altered to meet the following standards, in the manner indicated:
Standard No. 101 Controls and Displays: (a) Substitution of a lens
marked ``Brake'' for a lens with an ECE symbol on the brake failure
indicator lamp; (b) installation of a seat belt warning lamp that
displays the appropriate symbol; (c) recalibration of the speedometer/
odometer from kilometers to miles per hour.
Standard No. 108 Lamps, Reflective Devices and Associated
Equipment: (a) Installation of U.S.-model headlamp assemblies; (b)
installation of U.S.-model front and rear sidemarker/reflector
assemblies; (c) installation of U.S.-model taillamp assemblies; (d)
installation of a high mounted stop lamp.
Standard No. 110 Tire Selection and Rims: Installation of a tire
information placard.
Standard No. 111 Rearview Mirror: Replacement of the convex
passenger side rearview mirror.
Standard No. 114 Theft Protection: Installation of a warning buzzer
microswitch and a warning buzzer in the steering lock assembly.
Standard No. 118 Power-Operated Window Systems: Rewiring of the
power window system so that the window transport is inoperative when
the ignition is switched off.
Standard No. 208 Occupant Crash Protection: (a) Installation of a
U.S.-model seat belt in the driver's seating position, or a belt
webbing actuated microswitch inside the driver's seat belt retractor;
installation of an ignition switch-actuated seat belt warning lamp and
buzzer. The petitioner states that the vehicle is equipped with a
combination lap and shoulder restraint that adjusts by means of an
automatic retractor and releases by means of a single push button at
each front designated seating position, and with a combination lap and
shoulder restraint that releases by means of a single push button at
each rear designated seating position.
Standard No. 214 Side Impact Protection: Installation of
reinforcing beams.
Standard No. 301 Fuel System Integrity: Installation of a rollover
valve in the fuel tank vent line between the fuel tank and the
evaporative emissions collection canister.
Additionally, the petitioner states that the bumpers on the non-
U.S. certified 1989 Honda Prelude must be reinforced or replaced with
U.S.-model components to comply with the Bumper Standard found in 49
CFR Part 581.
The petitioner also states that a certification plate that meets
the requirements of 49 CFR Part 565 will be affixed to the vehicle.
Interested persons are invited to submit comments on the petition
described above. Comments should refer to the docket number and be
submitted to: Docket Section, National Highway Traffic Safety
Administration, Room 5109, 400 Seventh Street, S.W., Washington, DC
20590. It is requested but not required that 10 copies be submitted.
All comments received before the close of business on the closing
date indicated above will be considered, and will be available for
examination in the docket at the above address both before and after
that date. To the extent possible, comments filed after the closing
date will also be considered. Notice of final action on the petition
will be published in the Federal Register pursuant to the authority
indicated below.
Authority: 49 U.S.C. 30141(a)(1)(A) and (b)(1); 49 CFR 593.8;
delegations of authority at 49 CFR 1.50 and 501.8.
Issued on: October 3, 1996.
Marilynne Jacobs,
Director, Office of Vehicle Safety Compliance.
[FR Doc. 96-25887 Filed 10-8-96; 8:45 am]
BILLING CODE 4910-59-P
