97-29445. Airworthiness Directives; Dornier Model 328-100 Series Airplanes  

  • [Federal Register Volume 62, Number 218 (Wednesday, November 12, 1997)]
    [Rules and Regulations]
    [Pages 60642-60643]
    From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
    [FR Doc No: 97-29445]
    
    
    -----------------------------------------------------------------------
    
    DEPARTMENT OF TRANSPORTATION
    
    Federal Aviation Administration
    
    14 CFR Part 39
    
    [Docket No. 96-NM-219-AD; Amendment 39-10199; AD 97-23-11]
    RIN 2120-AA64
    
    
    Airworthiness Directives; Dornier Model 328-100 Series Airplanes
    
    AGENCY: Federal Aviation Administration, DOT.
    
    ACTION: Final rule.
    
    -----------------------------------------------------------------------
    
    SUMMARY: This amendment adopts a new airworthiness directive (AD), 
    applicable to certain Dornier Model 328-100 series airplanes, that 
    requires modifying the main landing gear (MLG) bay areas by installing 
    additional slush protection covers in those areas. This amendment is 
    prompted by the identification of a problem during flight test 
    analysis, which indicated that slush can accumulate in the MLG bay 
    areas. The actions specified by this AD are intended to prevent the 
    accumulation of slush in the MLG bay areas, which could freeze and 
    interfere with the landing gear or render it inoperative.
    
    DATES: Effective December 17, 1997.
        The incorporation by reference of certain publications listed in 
    the regulations is approved by the Director of the Federal Register as 
    of December 17, 1997.
    
    ADDRESSES: The service information referenced in this AD may be 
    obtained from Dornier Deutsche Aerospace, P.O. Box 1103, D-82230 
    Wessling, Federal Republic of Germany. This information may be examined 
    at the Federal Aviation Administration (FAA), Transport Airplane 
    Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; 
    or at the Office of the Federal Register, 800 North Capitol Street, 
    NW., suite 700, Washington, DC.
    
    FOR FURTHER INFORMATION CONTACT: International Branch, ANM-116, FAA, 
    Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
    Washington 98055-4056; telephone (425) 227-2110; fax (425) 227-1149.
    
    SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
    Aviation Regulations (14 CFR part 39) to include an airworthiness 
    directive (AD) that is applicable to certain Dornier Model 328-100 
    series airplanes was published in the Federal Register on March 12, 
    1997 (62 FR 11390). That action proposed to require modifying the main 
    landing gear (MLG) bay areas by installing additional slush protection 
    covers in those areas.
    
    Comments
    
        Interested persons have been afforded an opportunity to participate 
    in the making of this amendment. No comments were submitted in response 
    to the proposal or the FAA's determination of the cost to the public.
    
    Conclusion
    
        The FAA has determined that air safety and the public interest 
    require the adoption of the rule as proposed.
    
    Cost Impact
    
        The FAA estimates that 40 Dornier Model 328-100 series airplanes of 
    U.S. registry will be affected by this AD, that it will take 
    approximately 8 work hours per airplane to accomplish the required 
    actions, and that the average labor rate is $60 per work hour. The cost 
    of required parts will be negligible. Based on these figures, the cost 
    impact of the AD on U.S. operators is estimated to be $19,200, or $480 
    per airplane.
        The cost impact figure discussed above is based on assumptions that 
    no operator has yet accomplished any of the requirements of this AD 
    action, and that no operator would accomplish those actions in the 
    future if this AD were not adopted.
    
    Regulatory Impact
    
        The regulations adopted herein will not have substantial direct 
    effects on the States, on the relationship between the national 
    government and the States, or on the distribution of power and 
    responsibilities among the various levels of government. Therefore, in 
    accordance with Executive Order 12612, it is determined that this final 
    rule does not have sufficient federalism implications to warrant the 
    preparation of a Federalism Assessment.
        For the reasons discussed above, I certify that this action (1) is 
    not a ``significant regulatory action'' under Executive Order 12866; 
    (2) is not a ``significant rule'' under DOT Regulatory Policies and 
    Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
    significant economic impact, positive or negative, on a substantial 
    number of small entities under the criteria of the Regulatory 
    Flexibility Act. A final evaluation has been prepared for this action 
    and it is contained in the Rules Docket. A copy of it may be obtained 
    from the Rules Docket at the location provided under the caption 
    ADDRESSES.
    
    List of Subjects in 14 CFR Part 39
    
        Air transportation, Aircraft, Aviation safety, Incorporation by 
    reference, Safety.
    
    [[Page 60643]]
    
    Adoption of the Amendment
    
        Accordingly, pursuant to the authority delegated to me by the 
    Administrator, the Federal Aviation Administration amends part 39 of 
    the Federal Aviation Regulations (14 CFR part 39) as follows:
    
    PART 39--AIRWORTHINESS DIRECTIVES
    
        1. The authority citation for part 39 continues to read as follows:
    
        Authority: 49 U.S.C. 106(g), 40113, 44701.
    
    
    Sec. 39.13  [Amended]
    
        2. Section 39.13 is amended by adding the following new 
    airworthiness directive:
    
    97-23-11  Dornier: Amendment 39-10199. Docket 96-NM-219-AD.
    
        Applicability: Model 328-100 series airplanes, serial numbers 
    3005 through 3063 inclusive, certificated in any category.
    
        Note 1: This AD applies to each airplane identified in the 
    preceding applicability provision, regardless of whether it has been 
    otherwise modified, altered, or repaired in the area subject to the 
    requirements of this AD. For airplanes that have been modified, 
    altered, or repaired so that the performance of the requirements of 
    this AD is affected, the owner/operator must request approval for an 
    alternative method of compliance in accordance with paragraph (b) of 
    this AD. The request should include an assessment of the effect of 
    the modification, alteration, or repair on the unsafe condition 
    addressed by this AD; and, if the unsafe condition has not been 
    eliminated, the request should include specific proposed actions to 
    address it.
    
        Compliance: Required as indicated, unless accomplished 
    previously.
        To prevent the accumulation of slush in the main landing gear 
    (MLG) bay areas that could freeze and interfere with the landing 
    gear and result in it becoming inoperative, accomplish the 
    following:
        (a) Within 90 days after the effective date of this AD, modify 
    the MLG bay areas by installing additional slush protection covers 
    in those areas in accordance with Dornier Service Bulletin SB-328-
    30-132, dated October 11, 1995.
        (b) An alternative method of compliance or adjustment of the 
    compliance time that provides an acceptable level of safety may be 
    used if approved by the Manager, International Branch, ANM-116, FAA, 
    Transport Airplane Directorate. Operators shall submit their 
    requests through an appropriate FAA Principal Maintenance Inspector, 
    who may add comments and then send it to International Branch, ANM-
    116.
    
        Note 2: Information concerning the existence of approved 
    alternative methods of compliance with this AD, if any, may be 
    obtained from the International Branch, ANM-116.
    
        (c) Special flight permits may be issued in accordance with 
    sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
    CFR 21.197 and 21.199) to operate the airplane to a location where 
    the requirements of this AD can be accomplished.
        (d) The modification shall be done in accordance with Dornier 
    Service Bulletin SB-328-30-132, dated October 11, 1995. This 
    incorporation by reference was approved by the Director of the 
    Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
    51. Copies may be obtained from Dornier Deutsche Aerospace, P.O. Box 
    1103, D-82230 Wessling, Federal Republic of Germany. Copies may be 
    inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
    Avenue, SW., Renton, Washington; or at the Office of the Federal 
    Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
    
        Note 3: The subject of this AD is addressed in German 
    airworthiness directive 95-412, dated November 2, 1995.
    
        (e) This amendment becomes effective on December 17, 1997.
    
        Issued in Renton, Washington, on November 3, 1997.
    Darrell M. Pederson,
    Acting Manager, Transport Airplane Directorate, Aircraft Certification 
    Service.
    [FR Doc. 97-29445 Filed 11-10-97; 8:45 am]
    BILLING CODE 4910-13-U
    
    
    

Document Information

Effective Date:
12/17/1997
Published:
11/12/1997
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule.
Document Number:
97-29445
Dates:
Effective December 17, 1997.
Pages:
60642-60643 (2 pages)
Docket Numbers:
Docket No. 96-NM-219-AD, Amendment 39-10199, AD 97-23-11
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
PDF File:
97-29445.pdf
CFR: (1)
14 CFR 39.13