-
Start Preamble
Start Printed Page 58191
AGENCY:
Federal Aviation Administration (FAA), DOT.
ACTION:
Notice of proposed rulemaking (NPRM).
SUMMARY:
We propose to adopt a new airworthiness directive (AD) for Airbus Helicopters Deutschland GmbH (Airbus Helicopters) Model MBB-BK 117 C-2 helicopters. This proposed AD would require establishing or reducing the life limit of various parts. This proposed AD is prompted by recalculations. The actions of this proposed AD are intended to address an unsafe condition on these products.
DATES:
We must receive comments on this proposed AD by January 18, 2019.
ADDRESSES:
You may send comments by any of the following methods:
- Federal eRulemaking Docket: Go to http://www.regulations.gov. Follow the online instructions for sending your comments electronically.
- Fax: 202-493-2251.
- Mail: Send comments to the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590-0001.
- Hand Delivery: Deliver to the “Mail” address between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Examining the AD Docket
You may examine the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-0980; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the European Aviation Safety Agency (EASA) AD, the economic evaluation, any comments received, and other information. The street address for Docket Operations (telephone 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
For service information identified in this proposed rule, contact Airbus Helicopters, 2701 N Forum Drive, Grand Prairie, TX 75052; telephone (972) 641-0000 or (800) 232-0323; fax (972) 641-3775; or at http://www.helicopters.airbus.com/website/en/ref/Technical-Support_73.html. You may review the referenced service information at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177.
Start Further InfoFOR FURTHER INFORMATION CONTACT:
Matt Fuller, Senior Aviation Safety Engineer, Safety Management Section, Rotorcraft Standards Branch, FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone (817) 222-5110; email matthew.fuller@faa.gov.
End Further Info End Preamble Start Supplemental InformationSUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to participate in this rulemaking by submitting written comments, data, or views. We also invite comments relating to the economic, environmental, energy, or federalism impacts that might result from adopting the proposals in this document. The most helpful comments reference a specific portion of the proposal, explain the reason for any recommended change, and include supporting data. To ensure the docket does not contain duplicate comments, commenters should send only one copy of written comments, or if comments are filed electronically, commenters should submit only one time.
We will file in the docket all comments that we receive, as well as a report summarizing each substantive public contact with FAA personnel concerning this proposed rulemaking. Before acting on this proposal, we will consider all comments we receive on or before the closing date for comments. We will consider comments filed after the comment period has closed if it is possible to do so without incurring expense or delay. We may change this proposal in light of the comments we receive.
Discussion
EASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD No. 2017-0174, dated September 12, 2017 (EASA AD 2017-0174), to correct an unsafe condition for Airbus Helicopters Model MBB-BK 117 C-2 helicopters. EASA advises that recalculation by Airbus Helicopters has resulted in new or reduced life limits for certain parts. EASA AD 2017-0174 states the life limits are mandatory for continued airworthiness and failing to replace life-limited parts as specified could result in an unsafe condition. To address this condition, EASA AD 2017-0174 requires replacing the affected parts before exceeding their new or reduced life limit.
FAA's Determination
These helicopters have been approved by the aviation authority of Germany and are approved for operation in the United States. Pursuant to our bilateral agreement with Germany, EASA, its technical representative, has notified us of the unsafe condition described in its AD. We are proposing this AD because we evaluated all known relevant information and determined that an unsafe condition is likely to exist or develop on other products of the same type design.
Related Service Information
We reviewed Airbus Helicopters Alert Service Bulletin ASB MBB-BK117 C-2-04A-008, Revision 0, dated April 27, 2017, for Model MBB-BK 117 C-2 and C-2e helicopters. This service information specifies entering into the helicopter records the reduced and new airworthiness life limits for certain part-numbered main rotor head, swash plate, rotor flight controls, cyclic controls, and upper controls parts.
Proposed AD Requirements
This proposed AD would require establishing and reducing the life limit of the following parts: Main rotor head—nut, upper and lower quadruple nut, bolts, and inner sleeve; swash plate control ring assembly; rotor flight control collective bellcrank-K; cyclic Start Printed Page 58192control rod tube; and upper control forked lever.
Costs of Compliance
We estimate that this proposed AD would affect 128 helicopters of U.S. Registry. We estimate that operators may incur the following costs in order to comply with this AD. Labor costs are estimated at $85 per work-hour.
Replacing a nut would take about 5 work-hours and parts would cost about $3,352 for an estimated replacement cost of $3,777.
Replacing a quadruple nut upper would take about 5 work-hours and parts would cost about $3,283 for an estimated replacement cost of $3,708.
Replacing a quadruple nut lower would take about 5 work-hours and parts would cost about $3,405 for an estimated replacement cost of $3,830.
Replacing a bolt would take about 2 work-hours and parts would cost about $370 for an estimated replacement cost of $540.
Replacing an inner sleeve would take about 2 work-hours and parts would cost about $20,073 for an estimated replacement cost of $20,243.
Replacing a control ring assembly would take about 5 work-hours and parts would cost about $11,141 for an estimated replacement cost of $11,566.
Replacing a bellcrank-K (collective) would take about 4 work-hours and parts would cost about $3,400 for an estimated replacement cost of $3,740.
Replacing a control rod tube would take about 4 work-hours and parts would cost about $1,084 for an estimated replacement cost of $1,424.
Replacing a forked lever would take about 3 work-hours and parts would cost about $6,049 for an estimated replacement cost of $6,304.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska to the extent that it justifies making a regulatory distinction; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared an economic evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
Start List of SubjectsList of Subjects in 14 CFR Part 39
- Air transportation
- Aircraft
- Aviation safety
- Incorporation by reference
- Safety
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
Start PartPART 39—AIRWORTHINESS DIRECTIVES
End Part Start Amendment Part1. The authority citation for part 39 continues to read as follows:
End Amendment Part[Amended]2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):
End Amendment PartAirbus Helicopters Deutschland GmbH: Docket No. FAA-2018-0980; Product Identifier 2017-SW-123-AD.
(a) Applicability
This AD applies to Airbus Helicopters Deutschland GmbH Model MBB-BK 117 C-2 helicopters with a part listed in Table 1 to paragraph (e) of this AD installed, certificated in any category.
Note 1 to paragraph (a) of this AD:
Helicopters with an MBB-BK117 C-2e designation are Model MBB-BK117 C-2 helicopters.
(b) Unsafe Condition
This AD defines the unsafe condition as a part remaining in service beyond its fatigue life. This condition could result in failure of a part and loss of control of the helicopter.
(c) Comments Due Date
We must receive comments by January 18, 2019.
(d) Compliance
You are responsible for performing each action required by this AD within the specified compliance time unless it has already been accomplished prior to that time.
(e) Required Actions
Before further flight, remove from service any part that has reached or exceeded its new or reduced life limit as listed in Table 1 to paragraph (e) of this AD. Thereafter, remove from service each part on or before reaching its new or reduced life limit as listed in Table 1 to paragraph (e) of this AD. For purposes of this AD, a “landing” is counted any time the helicopter lifts off into the air and then lands again regardless of the duration of the landing and regardless of whether the engine is shut down.
Start Printed Page 58193(f) Alternative Methods of Compliance (AMOCs)
(1) The Manager, Safety Management Section, Rotorcraft Standards Branch, FAA, may approve AMOCs for this AD. Send your proposal to: Matt Fuller, Senior Aviation Safety Engineer, Safety Management Section, Rotorcraft Standards Branch, FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone (817) 222-5110; email 9-ASW-FTW-AMOC-Requests@faa.gov.
(2) For operations conducted under a 14 CFR part 119 operating certificate or under 14 CFR part 91, subpart K, we suggest that you notify your principal inspector, or lacking a principal inspector, the manager of the local flight standards district office or certificate holding district office before operating any aircraft complying with this AD through an AMOC.
(g) Additional Information
(1) Airbus Helicopters Alert Service Bulletin ASB MBB-BK117 C-2-04A-008, Revision 0, dated April 27, 2017, which is not incorporated by reference, contains additional information about the subject of this AD. For service information identified in this AD, contact Airbus Helicopters, 2701 N Forum Drive, Grand Prairie, TX 75052; telephone (972) 641-0000 or (800) 232-0323; fax (972) 641-3775; or at http://www.helicopters.airbus.com/website/en/ref/Technical-Support_73.html. You may review the referenced service information at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177.
(2) The subject of this AD is addressed in European Aviation Safety Agency (EASA) AD No. 2017-0174, dated September 12, 2017. You may view the EASA AD on the internet at http://www.regulations.gov in the AD Docket.
(h) Subject
Joint Aircraft Service Component (JASC) Code: 6220, Main Rotor Head; 6230 Main Rotor Mast/Swashplate; and 6710, Main Rotor Control.
Start SignatureIssued in Fort Worth, Texas, on November 6, 2018.
James A. Grigg,
Acting Director, Compliance & Airworthiness Division, Aircraft Certification Service.
BILLING CODE 4910-13-P
BILLING CODE 4910-13-C
[FR Doc. 2018-24995 Filed 11-16-18; 8:45 am]
BILLING CODE 4910-13-P
Document Information
- Published:
- 11/19/2018
- Department:
- Federal Aviation Administration
- Entry Type:
- Proposed Rule
- Action:
- Notice of proposed rulemaking (NPRM).
- Document Number:
- 2018-24995
- Dates:
- We must receive comments on this proposed AD by January 18, 2019.
- Pages:
- 58191-58193 (3 pages)
- Docket Numbers:
- Docket No. FAA-2018-0980, Product Identifier 2017-SW-123-AD
- RINs:
- 2120-AA64: Airworthiness Directives
- RIN Links:
- https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
- Topics:
- Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
- PDF File:
- 2018-24995.pdf
- Supporting Documents:
- » 2017-SW-123-AD Disposition of Comments (no comments)
- » U.S. DOT/FAA - Supplemental AD Documents
- CFR: (1)
- 14 CFR 39.13