[Federal Register Volume 62, Number 229 (Friday, November 28, 1997)]
[Proposed Rules]
[Pages 63286-63288]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 97-31157]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 97-NM-154-AD]
RIN 2120-AA64
Airworthiness Directives; Dornier Model 328-100 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: This document proposes the adoption of a new airworthiness
directive (AD) that is applicable to all Dornier Model 328 series
airplanes. This proposal would require a one-time inspection of the
date stamp affixed to the wing deicing boots to determine the cure
date, and replacement of the deicing boot with a new boot, if
necessary. This proposal is prompted by issuance of mandatory
continuing airworthiness information by a foreign civil airworthiness
authority. The actions specified by the proposed AD are intended to
prevent delamination of the wing deicing boots, and resultant inflation
of the deicing boots to a distorted aerodynamic shape during flight,
which could result in reduced controllability of the airplane.
DATES: Comments must be received by December 29, 1997.
ADDRESSES: Submit comments in triplicate to the Federal Aviation
Administration (FAA), Transport Airplane Directorate, ANM-103,
Attention: Rules Docket No. 97-NM-154-AD, 1601 Lind Avenue, SW.,
Renton, Washington 98055-4056. Comments may be inspected at this
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except
Federal holidays.
The service information referenced in the proposed rule may be
obtained from Dornier Deutsche Aerospace, P.O. Box 1103, D-82230
Wessling, Federal Republic of Germany. This information may be examined
at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW.,
Renton, Washington.
FOR FURTHER INFORMATION CONTACT: International Branch, ANM-116, FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington 98055-4056; telephone (425) 227-2110; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
Interested persons are invited to participate in the making of the
proposed rule by submitting such written data, views, or arguments as
they may desire. Communications shall identify the Rules Docket number
and be submitted in triplicate to the address specified above. All
communications received on or before the closing date for comments,
specified above, will be considered before taking action on the
proposed rule. The proposals contained in this notice may be changed in
light of the comments received.
Comments are specifically invited on the overall regulatory,
economic, environmental, and energy aspects of the proposed rule. All
comments submitted will be available, both before and after the closing
date for comments, in the Rules Docket for examination by interested
persons. A report summarizing each FAA-public contact concerned with
the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments
submitted in response to this notice must submit a self-addressed,
stamped postcard on which the following statement is made: ``Comments
to Docket Number 97-NM-154-AD.'' The
[[Page 63287]]
postcard will be date stamped and returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request
to the FAA, Transport Airplane Directorate, ANM-103, Attention: Rules
Docket No. 97-NM-154-AD, 1601 Lind Avenue, SW., Renton, Washington
98055-4056.
Discussion
The Luftfahrt-Bundesamt (LBA), which is the airworthiness authority
for Germany, notified the FAA that an unsafe condition may exist on all
Dornier Model 328-100 series airplanes. The LBA advises that it has
received two reports indicating that, during routine inspections, a
wing deicing boot was found to be delaminated. The cause of the
delamination of certain boots (i.e., those having cure dates of January
31, 1994, or earlier) has been attributed to the curing process used
during manufacture. This condition, if not detected and corrected in a
timely manner, could allow a deicing boot to inflate to a distorted
aerodynamic shape during flight, which could result in reduced
controllability of the airplane.
Explanation of Relevant Service Information
Dornier has issued Service Bulletin SB-328-30-171, dated September
20, 1996, including Annexes 1 and 2 (undated), which describes
procedures for performing a one-time visual inspection of the date
stamp affixed to the wing deicing boots to determine the cure date; and
replacement of the boot with a new boot, if the cure date is January
31, 1994, or earlier. The LBA classified this service bulletin as
mandatory and issued German airworthiness directive 96-320, dated
November 7, 1996, in order to assure the continued airworthiness of
these airplanes in Germany.
FAA's Conclusions
This airplane model is manufactured in Germany and is type
certificated for operation in the United States under the provisions of
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and
the applicable bilateral airworthiness agreement. Pursuant to this
bilateral airworthiness agreement, the LBA has kept the FAA informed of
the situation described above. The FAA has examined the findings of the
LBA, reviewed all available information, and determined that AD action
is necessary for products of this type design that are certificated for
operation in the United States.
Explanation of Requirements of Proposed Rule
Since an unsafe condition has been identified that is likely to
exist or develop on other airplanes of the same type design registered
in the United States, the proposed AD would require accomplishment of
the actions specified in the service bulletin described previously.
Cost Impact
The FAA estimates that 50 airplanes of U.S. registry would be
affected by this proposed AD, that it would take approximately 1 work
hour per airplane to accomplish the proposed actions, and that the
average labor rate is $60 per work hour. Based on these figures, the
cost impact of the proposed AD on U.S. operators is estimated to be
$3,000, or $60 per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the proposed requirements of
this AD action, and that no operator would accomplish those actions in
the future if this AD were not adopted.
Regulatory Impact
The regulations proposed herein would not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this
proposal would not have sufficient federalism implications to warrant
the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this proposed
regulation (1) is not a ``significant regulatory action'' under
Executive Order 12866; (2) is not a ``significant rule'' under the DOT
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
and (3) if promulgated, will not have a significant economic impact,
positive or negative, on a substantial number of small entities under
the criteria of the Regulatory Flexibility Act. A copy of the draft
regulatory evaluation prepared for this action is contained in the
Rules Docket. A copy of it may be obtained by contacting the Rules
Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration proposes to amend
part 39 of the Federal Aviation Regulations (14 CFR part 39) as
follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
Dornier: Docket 97-NM-154-AD.
Applicability: All Model 328-100 series airplanes, certificated
in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
otherwise modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (c) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent delamination of the wing deicing boots and resultant
inflation of the deicing boots to a distorted aerodynamic shape
during flight, which could result in reduced controllability of the
airplane, accomplish the following:
(a) Within 120 days after the effective date of this AD, perform
a one-time visual inspection of the date stamp affixed to each wing
deicing boot to determine the cure date, in accordance with Dornier
Service Bulletin SB-328-30-171, dated September 20, 1996, including
Annexes 1 and 2 (undated). If the cure date of any deicing boot is
January 31, 1994, or earlier, or if the cure date of the deicing
boot cannot be determined, prior to further flight, replace the
deicing boot with a new deicing boot having a cure date later than
January 31, 1994, in accordance with the service bulletin.
(b) As of the effective date of this AD, no person shall install
on any airplane a wing deicing boot having a cure date of January
31, 1994, or earlier.
(c) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, nternational Branch, ANM-116, FAA,
Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager, International
Branch, ANM-116.
[[Page 63288]]
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the International Branch, ANM-116.
(d) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
Note 3: The subject of this AD is addressed in German
airworthiness directive 96-320, dated November 7, 1996.
Issued in Renton, Washington, on November 20, 1997.
Stewart R. Miller,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 97-31157 Filed 11-26-97; 8:45 am]
BILLING CODE 4910-13-U
