00-28235. Airworthiness Directives; Bell Helicopter Textron Canada Model 430 Helicopters

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Final rule.

SUMMARY:

This amendment adopts a new airworthiness directive (AD) for Bell Helicopter Textron Canada (BHTC) Model 430 helicopters that requires calibration of the fuel quantity indicating system. This amendment is prompted by an operator report of an inaccurate fuel quantity indicating system. The actions specified by this AD are intended to prevent an inaccurate fuel quantity indicating system reading, engine flameout due to fuel starvation, and a subsequent forced landing.

DATES:

Effective December 12, 2000.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of December 12, 2000.

ADDRESSES:

The service information referenced in this AD may be obtained from Bell Helicopter Textron Canada, 12,800 Rue de l'Avenir, Mirabel, Quebec JON1LO, telephone [phone] or [phone], fax [phone]. This information may be examined at the FAA, Office of the Regional Counsel, Southwest Region, 2601 Meacham Blvd., Room 663, Fort Worth, Texas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT:

Paul Madej, Aviation Safety Engineer, FAA, Rotorcraft Directorate, Standards Staff, Fort Worth, Texas 76193-0110, telephone [phone], fax [phone].

SUPPLEMENTARY INFORMATION:

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an AD for BHTC Model 430 helicopters was published in the Federal Register on August 9, 2000 (65 FR 48643). That action proposed to require calibration of the fuel quantity indicating system.

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were received on the proposal or the FAA's determination of the cost to the public. The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

The FAA estimates that 50 helicopters of U.S. registry will be affected by this AD, that it will take approximately 2 work hours per helicopter to accomplish the required actions, and that the average labor rate is $60 per work hour. Based on these figures, the total cost impact of the AD on U.S. operators is estimated to be $6,000.

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. Section 39.13 is amended by adding a new airworthiness directive to read as follows:

2000-22-13  Bell Helicopter Textron Canada: Amendment 39-11959. Docket No. 2000-SW-11-AD.

Applicability: Model 430 helicopters, serial numbers 49001 through 49059, certificated in any category.

Note 1:

This AD applies to each helicopter identified in the preceding applicability provision, regardless of whether it has been otherwise modified, altered, or repaired in the area subject to the requirements of this AD. For helicopters that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required at the next scheduled fuel system calibration or at the next annual inspection, whichever occurs first, unless accomplished previously.

To prevent an inaccurate fuel quantity indicating system reading, engine flameout due to fuel starvation, and a subsequent forced landing, accomplish the following:

(a) Calibrate the fuel quantity indicating system in accordance with steps 1 through 21 of the Accomplishment Instructions, Bell Helicopter Textron Alert Service Bulletin No. 430-99-13, dated December 13, 1999 (ASB).

(b) Insert BHT-430-MM-10, Chapter 95, Revision 2, dated December 10, 1999, into the Maintenance Manual.

(c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Regulations Group, Rotorcraft Directorate, FAA. Operators shall submit their requests through an FAA Principal Maintenance Inspector, who may concur or comment and then send it to the Manager, Regulations Group.

Note 2:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Regulations Group.

(d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the helicopter to a location where the requirements of this AD can be accomplished.

(e) Calibrate the fuel quantity indicating system in accordance with steps 1 through 21 of the Accomplishment Instructions, Bell Helicopter Textron Alert Service Bulletin No. 430-99-13, dated December 13, 1999. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Bell Helicopter Textron Canada, 12,800 Rue de l'Avenir, Mirabel, Quebec JON1LO, telephone [phone] or [phone], fax [phone]. Copies may be inspected at the FAA, Office of the Regional Counsel, Southwest Region, 2601 Meacham Blvd., Room 663, Fort Worth, Texas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

(f) This amendment becomes effective on December 12, 2000.

Note 3:

The subject of this AD is addressed in Transport Canada (Canada) AD No. CF-2000-04, dated February 8, 2000.

Issued in Fort Worth, Texas, on October 27, 2000.

Henry A. Armstrong,

Manager, Rotorcraft Directorate, Aircraft Certification Service.