03-30042. Approval and Promulgation of Air Quality Implementation Plans; Delaware; MOBILE6-based Motor Vehicle Emission Budgets for the Delaware Portion of the Philadelphia-Wilmington-Trenton Ozone Nonattainment Area

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Proposed rule.

SUMMARY:

EPA proposes to approve a revision to the Delaware State Implementation Plan (SIP). Specifically, EPA is proposing approving amendments to the 2005 highway (on road) motor vehicle emission inventory for the Delaware portion of the Philadelphia-Wilmington-Trenton area's (the Philadelphia area) 1-hour ozone attainment plan as a revision to the Delaware SIP. This revision also serves to amend the 2005 motor vehicle emission budgets (MVEBs) used for determining transportation conformity under the Clean Air Act. The revised MVEBs were developed using MOBILE6, the most recent version of EPA's mobile source emission factor model. Revision of the MVEBs was a requirement of EPA's prior approval of Delaware's 1-hour ozone attainment demonstration plan for the Philadelphia severe ozone nonattainment area. In the final rules section of this Federal Register, EPA is approving Delaware's SIP submittal as a direct final rule without prior proposal because the Agency views this as a noncontroversial submittal and anticipates no adverse comments. A detailed rationale for the approval is set forth in the direct final rule. If no adverse comments are received in response to this action, no further activity is contemplated. If EPA receives adverse comments, the direct final rule will be withdrawn and public comments received will be addressed in a subsequent final rule based on this proposed rule. EPA will not institute a second comment period. Any parties interested in commenting on this action should do so at this time.

DATES:

Comments must be received in writing by January 5, 2004.

ADDRESSES:

Comments may be submitted either by mail or electronically. Written comments should be mailed to Robert Kramer, Chief, Energy, Radiation and Indoor Environment Branch, Mailcode 3AP23, U.S. Environmental Protection Agency, Region III, 1650 Arch Street, Philadelphia, Pennsylvania 19103. Electronic comments should be sent either to [e-mail] or to http://www.regulations.gov,, which is an alternative method for submitting electronic comments to EPA. To submit comments, please follow the detailed instructions described in the SUPPLEMENTARY INFORMATION section. Copies of the documents relevant to this action are available for public inspection during normal business hours at the Air Protection Division, U.S. Environmental Protection Agency, Region III, 1650 Arch Street, Philadelphia, Pennsylvania 19103; and at the Delaware Department of Natural Resources and Environmental Control, 156 South State Street, Dover, Delaware 19901.

FOR FURTHER INFORMATION CONTACT:

Larry Budney, [phone], or by e-mail at [e-mail].

SUPPLEMENTARY INFORMATION:

For further information, please see the information provided in the direct final action, with the same title, that is located in the “Rules and Regulations” section of this Federal Register publication. You may submit comments either electronically or by mail. To ensure proper receipt by EPA, identify the appropriate rulemaking identification number DE072-1042 in the subject line on the first page of your comment. Please ensure that your comments are submitted within the specified comment period. Comments received after the close of the comment period will be marked “late.” EPA is not required to consider these late comments.

1. Electronically. If you submit an electronic comment as prescribed below, EPA recommends that you include your name, mailing address, and an e-mail address or other contact information in the body of your comment. Also include this contact information on the outside of any disk or CD ROM you submit, and in any cover letter accompanying the disk or CD ROM. This ensures that you can be identified as the submitter of the comment and allows EPA to contact you in case EPA cannot read your comment due to technical difficulties or needs further information on the substance of your comment. EPA's policy is that EPA will not edit your comment, and any identifying or contact information provided in the body of a comment will be included as part of the comment that is placed in the official public docket. If EPA cannot read your comment due to technical difficulties and cannot contact you for clarification, EPA may not be able to consider your comment.

i. E-mail. Comments may be sent by electronic mail (e-mail) to [e-mail], attention DE072-1042. EPA's e-mail system is not an “anonymous access” system. If you send an e-mail comment directly without going through Regulations.gov, EPA's e-mail system automatically captures your e-mail address. E-mail addresses that are automatically captured by EPA's e-mail system are included as part of the comment that is placed in the official public docket.

ii. Regulations.gov. Your use of Regulation.gov is an alternative method of submitting electronic comments to EPA. Go directly to http://www.regulations.gov,, then select “Environmental Protection Agency” at the top of the page and use the “go” button. The list of current EPA actions available for comment will be listed. Please follow the online instructions for submitting comments. The system is an “anonymous access” system, which means EPA will not know your identity, e-mail address, or other contact information unless you provide it in the body of your comment.

iii. Disk or CD ROM. You may submit comments on a disk or CD ROM that you mail to the mailing address identified in the ADDRESSES section of this document. These electronic submissions will be accepted in WordPerfect, Word or ASCII file format. Avoid the use of special characters and any form of encryption.

2. By Mail. Written comments should be addressed to the EPA Regional office listed in the ADDRESSES section of this document.

For public commenters, it is important to note that EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing at the EPA Regional Office, as EPA receives them and without change, unless the comment contains copyrighted material, confidential business information (CBI), or other information whose disclosure is restricted by statute. When EPA identifies a comment containing copyrighted material, EPA will provide a reference to that material in the version of the comment that is placed in the official public rulemaking file. The entire printed comment, including the copyrighted material, will be available at the Regional Office for public inspection.

Submittal of CBI Comments

Do not submit information that you consider to be CBI electronically to EPA. You may claim information that you submit to EPA as CBI by marking any part or all of that information as CBI (if you submit CBI on disk or CD ROM, mark the outside of the disk or CD ROM as CBI and then identify electronically within the disk or CD ROM the specific information that is CBI). Information so marked will not be disclosed except in accordance with procedures set forth in 40 CFR part 2. In addition to one complete version of the comment that includes any information claimed as CBI, a copy of the comment that does not contain the information claimed as CBI must be submitted for inclusion in the official public regional rulemaking file. If you submit the copy that does not contain CBI on disk or CD ROM, mark the outside of the disk or CD ROM clearly that it does not contain CBI. Information not marked as CBI will be included in the public file and available for public inspection without prior notice. If you have any questions about CBI or the procedures for claiming CBI, please consult the person identified in the FOR FURTHER INFORMATION CONTACT section.

Considerations When Preparing Comments to EPA

You may find the following suggestions helpful for preparing your comments:

1. Explain your views as clearly as possible.

2. Describe any assumptions that you used.

3. Provide any technical information and/or data you used that support your views.

4. If you estimate potential burden or costs, explain how you arrived at your estimate.

5. Provide specific examples to illustrate your concerns.

6. Offer alternatives.

7. Make sure to submit your comments by the comment period deadline identified.

8. To ensure proper receipt by EPA, identify the appropriate regional file/rulemaking identification number in the subject line on the first page of your response. It would also be helpful if you provided the name, date, and Federal Register citation related to your comments.

Please note that if EPA receives adverse comment on an amendment, paragraph, or section of this rule and if that provision may be severed from the remainder of the rule, EPA may adopt as final those provisions of the rule that are not the subject of an adverse comment.

Dated: November 20, 2003.

Thomas Voltaggio,

Acting Regional Administrator, Region III.