2024-02872. Information Collection Being Reviewed by the Federal Communications Commission  

  • Start Preamble

    AGENCY:

    Federal Communications Commission.

    ACTION:

    Notice and request for comments.

    SUMMARY:

    As part of its continuing effort to reduce paperwork burdens, and as required by the Paperwork Reduction Act of 1995 (PRA), the Federal Communications Commission (FCC or Commission) invites the general public and other Federal agencies to take this opportunity to comment on the following information collections. Comments are requested concerning: whether the proposed collection of information is necessary for the proper performance of the functions of the Commission, including whether the information shall have practical utility; the accuracy of the Commission's burden estimate; ways to enhance the quality, utility, and clarity of the information collected; ways to minimize the burden of the collection of information on the respondents, including the use of automated collection techniques or other forms of information technology; and ways to further reduce the information collection burden on small business concerns with fewer than 25 employees. The FCC may not conduct or sponsor a collection of information unless it displays a currently valid Office of Management and Budget (OMB) control number. No person shall be subject to any penalty for failing to comply with a collection of information subject to the PRA that does not display a valid OMB control number.

    DATES:

    Written PRA comments should be submitted on or before April 15, 2024. If you anticipate that you will be submitting comments but find it difficult to do so within the period of time allowed by this notice, you should advise the contact listed below as soon as possible.

    ADDRESSES:

    Direct all PRA comments to Cathy Williams, FCC, via email to PRA@fcc.gov and to Cathy.Williams@fcc.gov.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    For additional information about the information collection, contact Cathy Williams at (202) 418–2918.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    OMB Control Number: 3060–1189.

    Title: Signal Boosters, Sections 1.1307(b)(1), 20.3, 20.21(a)(2), 20.21(a)(5), 20.21(e)(2), 20.21(e)(8)(I)(G), 20.21(e)(9)(I)(H), 20.21(f), 20.21(h), 22.9, 24.9, 27.9. 90.203, 90.219(b)(l)(I), 90.219(d)(5), and 90.219(e)(5).

    Form Number: N/A.

    Type of Review: Extension of a currently approved collection.

    Respondents: Business or other for-profit entities, Not for profit institutions and Individuals or household.

    Number of Respondents and Responses: 632,534 respondents and 635,214 responses.

    Estimated Time per Response:.5 hours–40 hours.

    Frequency of Response: Recordkeeping requirement, On occasion reporting requirement and Third-party disclosure requirement.

    Obligation to Respond: Required to obtain or retain benefits. The statutory authority for this information collection is contained in 47 U.S.C. 154(i), 303(g), 303(r) and 332.

    Total Annual Burden: 324,465 hours.

    Total Annual Cost: No cost.

    Needs and Uses: The Commission is seeking approval from the Office of Management and Budget (OMB) approval for a three-year time period for this information collection requirements approved under this collection. The following information collection requirements are approved under this collection: Labeling Requirements: Sections 20.21(a)(5), 20.21(f), 90.219(e)(5)—In order to avoid consumer confusion and provide consumers with needed information, the Commission adopted labeling requirements for Consumer and Industrial Signal Boosters. Consumer Signal Boosters must be labeled to identify the device as a “consumer” device and make the consumer aware that the device must be registered; may only be operated with the consent of the consumer's wireless provider; may only be operated with approved antennas and cables; and that E911 communications may be affected for calls served by using the device. Industrial Signal Boosters must include a label stating that the device is not a consumer device, is designed for installation by FCC licensees or a qualified installer, and the operator Start Printed Page 10074 must have a FCC license or consent of a FCC licensee to operate the device. Accordingly, all signal boosters marketed on or after March 1, 2014, must include the advisories (1) in on-line point-of-sale marketing materials; (2) in any print or on-line owner's manual and installation instructions; (3) on the outside packaging of the device; and (4) on a label affixed to the device. Part 90 signal boosters marketed or sold on or after March 1, 2014, must include a label stating that the device is not a consumer device; the operator must have a FCC license or consent of a FCC licensee to operate the device; the operator must register Class B signal boosters; and unauthorized use may result in significant forfeitures.

    Section 20.21(f)(1)(iv)(A)(2)—In order to ensure that consumers are properly informed about which devices are suitable for their use and how to comply with our rules, the Commission required that all Consumer Signal Boosters certified for fixed, in-building operation include a label directing consumers that the device may only be operated in a fixed, in-building location. The Verizon Petitioners state that this additional labeling requirement is necessary to inform purchasers of fixed Consumer Signal Boosters that they may not lawfully be installed and operated in a moving vehicle or outdoor location. We recognize that our labeling requirement imposes additional costs on entities that manufacture Consumer Signal Boosters; however, on balance, we find that such costs are outweighed by the benefits of ensuring that consumers purchase appropriate devices. Accordingly, all fixed Consumer Signal Boosters, both Provider-Specific and Wideband, manufactured or imported on or after one year from the effective date of the rule change must include the following advisory (1) in on-line point-of-sale marketing materials, (2) in any print or on-line owner's manual and installation instructions, (3) on the outside packaging of the device, and (4) on a label affixed to the device: “This device may be operated ONLY in a fixed location for in-building use.”

    Section 1.1307(b)(1)—Radiofrequency (RF). This rule requires that a label is affixed to the transmitting antenna that provides adequate notice regarding potential RF safety hazards and references the applicable FCC-adopted limits for RF exposure. Provider Reporting Requirement: In order to facilitate review of wireless providers' behavior regarding Consumer Signal Boosters, the R&O requires that on March 1, 2015, and March 1, 2016, all nationwide wireless providers publicly indicate their status regarding consent for each Consumer Signal Booster that has received FCC certification as listed in a Public Notice to be released by the Wireless Telecommunications Bureau 30 days prior to each reporting date. For each listed Consumer Signal Booster, wireless providers should publicly indicate whether they (1) consent to use of the device; (2) do not consent to use of the device; or (3) are still considering whether or not they will consent to the use of the device.

    Registration Requirements: Section 20.21(a)(2)—The rules require signal booster operators to register Consumer Signal Boosters, existing and new, with their serving wireless providers prior to operation. This is a mandatory requirement to continue or begin operation of a Consumer Signal Booster. The registration requirement will aid in interference resolution and facilitate provider control over Consumer Signal Boosters. The information collection contained in Section 20.21(a)(2) affects individuals or households; thus, there are impacts under the Privacy Act. However, the government is not directly collecting this information and the R&O directs carriers to protect the information to the extent it is considered Customer Proprietary Network Information (CPNI).

    Section 20.21(h)—By March 1, 2014, all providers who voluntarily consent to *19619 the use of Consumer Signal Boosters on their networks must establish a free registration system for their subscribers. At a minimum, providers must collect (1) the name of the Consumer Signal Booster owner and/or operator, if different individuals; (2) the make, model, and serial number of the device; (3) the location of the device; and (4) the date of initial operation. Otherwise, the Commission permits providers to develop their own registration systems to facilitate provider control and interference resolution, providers should collect only such information that is reasonably related to achieving these dual goals. Wireless providers may determine how to collect such information and how to keep it up-to-date. Section 90.219(d)(5)—This rule requires operators of Part 90 Class B signal boosters to register these devices in a searchable on-line database that will be maintained and operated by the Wireless Telecommunications Bureau via delegated authority from the Commission. The Commission believes this will be a valuable tool to resolve interference should it occur.

    Certification Requirements: Sections 20.3, 20.21(e)(2), 20.21(e)(8)(i)(G), 20.21(e)(9)(i)(H), 90.203—These rules, in conjunction with the R&O, require that signal booster manufacturers demonstrate that they meet the new technical specifications using the existing and unchanged equipment authorization application, including submitting a technical document with the application for FCC equipment authorization that shows compliance of all antennas, cables and/or coupling devices with the requirements of § 20.21(e). The R&O further provides that manufacturers must make certain certifications when applying for device certification. Manufacturers must provide an explanation of all measures taken to ensure that the technical safeguards designed to inhibit harmful interference and protect wireless networks cannot be deactivated by the user. The R&O requires that manufacturers of Provider-Specific Consumer Signal Boosters may only be certificated with the consent of the licensee so the manufacturer must certify that it has obtained such consent as part of the equipment certification process. The R&O also requires that if a manufacturer claims that a device will not affect E911 communications, the manufacturer must certify this claim during the equipment certification process. Note: The “application for equipment” certification requirements are met under OMB Control Number 3060–0057, FCC Form 731.

    Antenna Kitting Documentation Requirement: Sections 20.21(e)(8)(i)(G), 20.21(e)(9)(i)(H)—The rules require that all consumer boosters must be sold with user manuals specifying all antennas and cables that meet the requirements of this section. Part 90 Licensee Consent Documentation Requirement: Section 90.219(b)(1)(i)—This rule requires that non-licensees seeking to operate part 90 signal boosters must obtain the express consent of the licensee(s) of the frequencies for which the device or system is intended to amplify. The rules further require that such consent must be maintained in a recordable format that can be presented to a FCC representative or other relevant licensee investigating interference.

    Cross-reference to Other Rule Parts: Sections 22.9, 24.9, and 27.9—Operation of a consumer signal booster under Parts 22, 24, and 27 of the Commission's rules must also comply with section 20.21 of the Commission's rules, including all relevant information collections.

    Start Signature

    Federal Communications Commission.

    Marlene Dortch,

    Secretary, Office of the Secretary.

    End Signature End Supplemental Information

    [FR Doc. 2024–02872 Filed 2–12–24; 8:45 am]

    BILLING CODE 6712–01–P

Document Information

Published:
02/13/2024
Department:
Federal Communications Commission
Entry Type:
Notice
Action:
Notice and request for comments.
Document Number:
2024-02872
Dates:
Written PRA comments should be submitted on or before April 15, 2024. If you anticipate that you will be submitting comments but find it difficult to do so within the period of time allowed by this notice, you should advise the contact listed below as soon as possible.
Pages:
10073-10074 (2 pages)
Docket Numbers:
OMB 3060-1189, FR ID 201556
PDF File:
2024-02872.pdf