06-1410. Airworthiness Directives; BAE Systems (Operations) Limited Model BAe 146 and Avro 146-RJ Airplanes  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration, Department of Transportation (DOT).

    ACTION:

    Final rule.

    SUMMARY:

    This amendment adopts a new airworthiness directive (AD), applicable to all BAE Systems (Operations) Limited Model BAe 146 and Avro 146-RJ airplanes, that requires installation of a linear fluid-filled damper between each elevator surface and the airplane structure on both the left and right sides of the airplane, along with related structural and system modifications. The actions specified by this AD are intended to prevent pitch oscillation (vertical bouncing) of the fuselage due to excessive ice buildup on the elevator servo tab, and consequent reduced controllability of the airplane. This action is intended to address the identified unsafe condition.

    DATES:

    Effective March 24, 2006.

    The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of March 24, 2006.

    ADDRESSES:

    The service information referenced in this AD may be obtained from British Aerospace Regional Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 20171. This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Todd Thompson, Aerospace Engineer; International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-1175; fax (425) 227-1149.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to all BAE Systems (Operations) Limited Model BAe 146 and Avro 146-RJ airplanes was published as a supplemental notice of proposed rulemaking (NPRM) in the Federal Register on December 8, 2005 (70 FR 72942). That action proposed to require installation of a linear fluid-filled damper between each elevator surface and the airplane structure on both the left and right sides of the airplane, along with related structural and system modifications. That action also revised and updated applicable service information and revised the compliance time to accurately reflect the compliance time specified by the service information.

    Comments

    Interested persons have been afforded an opportunity to participate in the making of this amendment. We received no comments on the supplemental NPRM or on the determination of the cost to the public.

    Conclusion

    We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed, except for certain minor editorial changes that have no effect on any legal or technical aspect of the AD.

    Cost Impact

    The FAA estimates that 55 airplanes of U.S. registry will be affected by this AD. Accomplishment of the required actions specified in the referenced BAE Systems (Operations) Limited modification service bulletins will require an approximate number of work hours as shown in the following table, at an average labor rate of $65 per work hour.Start Printed Page 8449

    Work Hours and Costs

    BAE Systems (operations) limited modification service bulletinParts costsWork hoursCost per airplane
    SB.27-167-01614C.D.G$2,93712$3,717
    SB.27-168-01614EH713403,313
    SB.27-169-01692A10,415810,935
    SB.27-170-01692E 1826202,126
    SB.27-171-01692F 2826121,606
    SB.27-174-01692GN.A.165
    1 (For Model BAE 146 airplanes only).
    2 (For Model Avro 146-RJ airplanes only).

    Based on these figures, the total cost impact of this AD on U.S. operators is estimated to be between $1,079,980 and $1,108,580, or between $19,636 and $20,156 per airplane.

    The cost impact figures discussed above are based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

    We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    Regulatory Impact

    The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

    For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    Adoption of the Amendment

    Start Amendment Part

    Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

    End Amendment Part Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. Section 39.13 is amended by adding the following new airworthiness directive:

    End Amendment Part

    2006-04-07 BAE Systems (Operations) Limited (Formerly British Aerospace Regional Aircraft): Amendment 39-14488. Docket 2002-NM-172-AD.

    Applicability: All Model BAe 146-100A, -200A, and -300A series airplanes and Model Avro 146-RJ70A, 146-RJ85A, and 146-RJ100A airplanes; certificated in any category.

    Compliance: Required as indicated, unless accomplished previously.

    To prevent pitch oscillation (vertical bouncing) of the fuselage due to excessive ice buildup on the elevator servo tab, and consequent reduced controllability of the airplane, accomplish the following:

    Linear Fluid-Filled Damper Installation

    (a) Within 24 months after the effective date of this AD, install linear fluid-filled dampers between each elevator surface and the airplane structure on both the left and right sides of the airplane and perform the related structural and system modifications, by doing all actions in accordance with the Accomplishment Instructions of the service bulletins specified in Table 1 of this AD; as applicable.

    Table 1.—Service Information

    BAE Systems (operations) limited modification service bulletinRevision levelDate
    SB.27-167-01614C.D.G2July 25, 2003.
    SB.27-168-01614EH2July 25, 2003.
    SB.27-169-01692A1July 11, 2002.
    SB.27-170-01692E, including Appendix 1, Revision 1, dated August 27, 2001 13May 16, 2003.
    SB.27-171-01692F, including Appendix 1, dated March 20, 2001 21July 10, 2002.
    SB.27-174-01692GOriginalDecember 10, 2001.
    1 (For Model BAE 146 airplanes only).
    2 (For Model Avro 146-RJ airplanes only).
    Start Printed Page 8450

    Credit for Prior Revisions of Service Information

    (b) Actions accomplished before the effective date of this AD in accordance with applicable service information listed in Table 2 of this AD are considered acceptable for compliance with the corresponding actions specified in paragraph (a) of this AD.

    Table 2.—Prior Revisions of Service Information

    BAE Systems (operations) limited modification service bulletinRevision levelDate
    SB.27-167-01614C.D.GOriginalJanuary 2, 2001.
    SB.27-167-01614C.D.G1July 11, 2002.
    SB.27-168-01614EHOriginalJanuary 22, 2001.
    SB.27-168-01614EH1July 11, 2002.
    SB.27-169-01692AOriginalDecember 10, 2001.
    27-170-01692E, including Appendix 1 1OriginalMarch 20, 2001.
    SB.27-170-01692E, including Appendix 1 11August 27, 2001.
    SB.27-170-01692E, including Appendix 1, Revision 1, dated August 27, 2001 12July 10, 2002.
    SB.27-171-01692F, including Appendix 1 2OriginalMarch 20, 2001.
    1 (For Model BAE 146 airplanes only).
    2 (For Model Avro 146-RJ airplanes only).

    No Reporting Requirement

    (c) Although all referenced service bulletins describe procedures for reporting accomplishment to the manufacturer, this AD does not require that action.

    Alternative Methods of Compliance

    (d)(1) In accordance with 14 CFR 39.19, the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate, is authorized to approve alternative methods of compliance for this AD.

    (2) Before using any AMOC approved in accordance with 14 CFR 39.19 on any airplane to which the AMOC applies, notify the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office.

    Note 1:

    The subject of this AD is addressed in British airworthiness directive 005-12-2001.

    Incorporation by Reference

    (e) Unless otherwise specified in this AD, the actions must be done in accordance with the service information specified in Table 3 of this AD, as applicable. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. To get copies of this service information, contact British Aerospace Regional Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 20171. To inspect copies of this service information, go to the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or to the National Archives and Records Administration (NARA). For information on the availability of this material at the NARA, call (202) 741-6030, or go to http://www.archives.gov/​federal_​register/​code_​of_​federal_​regulations/​ibr_​locations.html.

    Table 3.—Service Information Incorporated by Reference

    BAE Systems (operations) limited modification service bulletinRevision levelDate
    SB.27-167-01614C.D.G2July 25, 2003.
    SB.27-168-01614EH2July 25, 2003.
    SB.27-169-01692A1July 11, 2002.
    SB.27-170-01692E, including Appendix 1, Revision 1, dated August 27, 20013May 16, 2003.
    SB.27-171-01692F, including Appendix 1, dated March 20, 20011July 10, 2002.
    SB.27-174-01692GOriginalDecember 10, 2001.

    Effective Date

    (f) This amendment becomes effective on March 24, 2006.

    Start Signature

    Issued in Renton, Washington, on February 6, 2006.

    Ali Bahrami,

    Manager, Transport Airplane Directorate, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. 06-1410 Filed 2-16-06; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Effective Date:
3/24/2006
Published:
02/17/2006
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule.
Document Number:
06-1410
Dates:
Effective March 24, 2006.
Pages:
8448-8450 (3 pages)
Docket Numbers:
Docket No. 2002-NM-172-AD, Amendment 39-14488, AD 2006-04-07
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
06-1410.pdf
CFR: (1)
14 CFR 39.13