[Federal Register Volume 61, Number 55 (Wednesday, March 20, 1996)]
[Proposed Rules]
[Pages 11347-11349]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 96-6541]
========================================================================
Proposed Rules
Federal Register
________________________________________________________________________
This section of the FEDERAL REGISTER contains notices to the public of
the proposed issuance of rules and regulations. The purpose of these
notices is to give interested persons an opportunity to participate in
the rule making prior to the adoption of the final rules.
========================================================================
Federal Register / Vol. 61, No. 55 / Wednesday, March 20, 1996 /
Proposed Rules
[[Page 11347]]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 95-NM-234-AD]
Airworthiness Directives; McDonnell Douglas Model MD-11 and DC-10
Series Airplanes, and KC-10A (Military) Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: This document proposes the supersedure of an existing
airworthiness directive (AD), applicable to certain McDonnell Douglas
Model MD-11 and DC-10 series airplanes, and KC-10A (military)
airplanes. That AD currently requires functional testing to verify
proper installation of the electrical connectors to the engine
generator and fire bell shutoff switches, and correction of the
installation, if necessary. This action would require installation of
tethers on the electrical connectors to the engine generator and fire
bell shutoff switches, which would terminate the requirement to perform
functional tests repetitively. This proposal is prompted by the
development of a modification that minimizes the possibility of
improperly connecting (crossing) the electrical connectors to the fire
extinguishing handles. The actions specified by the proposed AD are
intended to prevent the wrong engine-driven generator from being shut
down unnecessarily in the event of an engine fire warning.
DATES: Comments must be received by May 13, 1996.
ADDRESSES: Submit comments in triplicate to the Federal Aviation
Administration (FAA), Transport Airplane Directorate, ANM-103,
Attention: Rules Docket No. 95-NM-234-AD, 1601 Lind Avenue, SW.,
Renton, Washington 98055-4056. Comments may be inspected at this
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except
Federal holidays.
The service information referenced in the proposed rule may be
obtained from McDonnell Douglas Corporation, 3855 Lakewood Boulevard,
Long Beach, California 90846, Attention: Technical Publications
Business Administration, Department C1-L51 (2-60). This information may
be examined at the FAA, Transport Airplane Directorate, 1601 Lind
Avenue, SW., Renton, Washington; or at the FAA, Transport Airplane
Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount
Boulevard, Lakewood, California.
FOR FURTHER INFORMATION CONTACT: Raymond Vakili, Aerospace Engineer,
Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification
Office, 3960 Paramount Boulevard, Lakewood, California 90712; telephone
(310) 627-5262; fax (310) 627-5262.
SUPPLEMENTARY INFORMATION:
Comments Invited
Interested persons are invited to participate in the making of the
proposed rule by submitting such written data, views, or arguments as
they may desire. Communications shall identify the Rules Docket number
and be submitted in triplicate to the address specified above. All
communications received on or before the closing date for comments,
specified above, will be considered before taking action on the
proposed rule. The proposals contained in this notice may be changed in
light of the comments received.
Comments are specifically invited on the overall regulatory,
economic, environmental, and energy aspects of the proposed rule. All
comments submitted will be available, both before and after the closing
date for comments, in the Rules Docket for examination by interested
persons. A report summarizing each FAA-public contact concerned with
the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments
submitted in response to this notice must submit a self-addressed,
stamped postcard on which the following statement is made: ``Comments
to Docket Number 95-NM-234-AD.'' The postcard will be date stamped and
returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request
to the FAA, Transport Airplane Directorate, ANM-103, Attention: Rules
Docket No. 95-NM-234-AD, 1601 Lind Avenue, SW., Renton, Washington
98055-4056.
Discussion
On November 7, 1994, the FAA issued AD 93-25-09 R1, amendment 39-
9070 (59 FR 56383, November 14, 1994), applicable to certain McDonnell
Douglas Model MD-11 and DC-10 series airplanes, and KC-10A (military)
airplanes. That AD requires that operators perform repetitive
functional tests to verify proper installation of the electrical
connectors to the engine generator and fire bell shutoff switches, and
correction of the installation, if necessary; and that operators submit
a report to the FAA that details the findings of discrepancies
identified during the accomplishment of the initial functional test.
That action was prompted by a report indicating that the electrical
connectors to the fire extinguishing handles were found to be connected
incorrectly (crossed) on one airplane. The requirements of that AD are
intended to prevent the wrong engine-driven generator from being shut
down unnecessarily in the event of an engine fire warning.
Since the issuance of that AD, the manufacturer has developed a
modification, which would eliminate the need for the functional tests
required by AD 93-25-09 R1. This modification would minimize the
possibility of improperly connecting (crossing) the electrical
connectors to the fire extinguishing handles.
The FAA has reviewed and approved McDonnell Douglas Service
Bulletin MD11-26-018, dated August 24, 1995 (for Model MD-11 series
airplanes), and McDonnell Douglas Service Bulletin DC10-26-047, dated
May 4, 1995 [for Model DC-10 series airplanes and KC-10A (military)
airplanes], which describe procedures for modification of the
electrical connectors to the engine generator and fire bell shutoff
switches. This modification entails installing tethers on the
electrical connectors to the engine generator and of the fire bell
shutoff switches located forward of the
[[Page 11348]]
overhead circuit breaker panel in the flight compartment.
Since an unsafe condition has been identified that is likely to
exist or develop on other products of this same type design, the
proposed AD would supersede AD 93-25-09 R1 to continue to require that
operators perform functional tests following any maintenance performed
on the fire extinguishing handle system to verify proper installation
of the electrical connectors to the engine generator and fire bell
shutoff switches, and correction of the installation, if necessary.
This newly proposed AD requires installation of tethers on the
electrical connectors to the engine generator and fire bell shutoff
switches, which would terminate the requirement to perform functional
tests repetitively. The actions would be required to be accomplished in
accordance with the applicable service bulletin described previously.
There are approximately 570 McDonnell Douglas Model MD-11 and DC-10
series airplanes, and KC-10A (military) airplanes of the affected
design in the worldwide fleet. The FAA estimates that 270 airplanes of
U.S. registry would be affected by this proposed AD.
The checks that are currently required by AD 93-25-09 R1 (and
retained by this proposed action) take approximately 0.5 work hour per
airplane to accomplish, at an average labor rate of $60 per work hour.
Based on these figures, the cost impact on U.S. operators of the
actions currently required is estimated to be $8,100, or $30 per
airplane.
The modification that is proposed by this AD action would take
approximately 6 work hours per airplane to accomplish, at an average
labor rate of $60 per work hour. Required parts would be nominal in
cost. Based on these figures, the cost impact on U.S. operators of the
proposed requirements of this AD is estimated to be $97,200, or $360
per airplane.
The cost impact figures discussed above are based on assumptions
that no operator has yet accomplished any of the current or proposed
requirements of this AD action, and that no operator would accomplish
those actions in the future if this AD were not adopted.
The regulations proposed herein would not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this
proposal would not have sufficient federalism implications to warrant
the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this proposed
regulation (1) is not a ``significant regulatory action'' under
Executive Order 12866; (2) is not a ``significant rule'' under the DOT
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
and (3) if promulgated, will not have a significant economic impact,
positive or negative, on a substantial number of small entities under
the criteria of the Regulatory Flexibility Act. A copy of the draft
regulatory evaluation prepared for this action is contained in the
Rules Docket. A copy of it may be obtained by contacting the Rules
Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration proposes to amend
part 39 of the Federal Aviation Regulations (14 CFR part 39) as
follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 USC 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by removing amendment 39-9070 (59 FR
56383, November 14, 1994), and by adding a new airworthiness directive
(AD), to read as follows:
McDonnell Douglas: Docket 95-NM-234-AD. Supersedes AD 93-25-09 R1,
Amendment 39-9070.
Applicability: Model MD-11 series airplanes as listed in
McDonnell Douglas MD-11 Alert Service Bulletin A26-16, dated
November 22, 1993; and Model DC-10 series airplanes and KC-10A
(military) airplanes as listed in McDonnell Douglas DC-10/KC-10A
Alert Service Bulletin A26-46, dated December 6, 1993; certificated
in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (e) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent the wrong engine-driven generator from being shut
down unnecessarily in the event of an engine fire warning,
accomplish the following:
(a) As of January 7, 1994 (the effective date of AD 93-25-09,
amendment 39-8775), prior to further flight following any
maintenance performed on the fire extinguishing handle system,
perform a functional test to verify proper installation of the
electrical connectors to the engine generator and fire bell shutoff
switches in accordance with the Accomplishment Instructions of
McDonnell Douglas MD-11 Alert Service Bulletin A26-16, dated
November 22, 1993 (for Model MD-11 series airplanes); or McDonnell
Douglas DC-10/KC-10A Alert Service Bulletin A26-46, dated December
6, 1993 [for Model DC-10 series airplanes, and KC-10A (military)
airplanes]; as applicable.
(b) If the electrical connectors are found to be properly
installed, repeat the functional test thereafter prior to further
flight following any maintenance performed on the fire extinguishing
handle system, until the requirements of paragraph (d) of this AD
are accomplished.
(c) If the electrical connectors are found to be improperly
installed, prior to further flight, correct the wiring installation
and repeat the functional test, in accordance with the
Accomplishment Instructions of McDonnell Douglas MD-11 Alert Service
Bulletin A26-16, dated November 22, 1993 (for Model MD-11 series
airplanes); or McDonnell Douglas DC-10/KC-10A Alert Service Bulletin
A26-46, dated December 6, 1993 [for Model DC-10 series airplanes,
and KC-10A (military) airplanes]; as applicable. Thereafter, repeat
the functional test prior to further flight following any
maintenance performed on the fire extinguishing handle system, until
the requirements of paragraph (d) of this AD are accomplished.
(d) Within 24 months after the effective date of this AD,
install tethers on the electrical connectors to the engine generator
and fire bell shutoff switches in accordance with McDonnell Douglas
Service Bulletin MD11-26-018, dated August 24, 1995 (for Model MD-11
series airplanes), or McDonnell Douglas Service Bulletin DC10-26-
047, dated May 4, 1995 [for Model DC-10 series airplanes and KC-10A
(military) airplanes], as applicable. This installation constitutes
terminating action for the functional tests required by this AD.
(e) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, Los Angeles Aircraft Certification
Office (ACO), FAA, Transport Airplane Directorate. Operators shall
submit their requests through an appropriate FAA Principal
Maintenance Inspector, who may add comments and then send it to the
Manager, Los Angeles ACO.
Note 2: Information concerning the existence of approved
alternative methods of
[[Page 11349]]
compliance with this AD, if any, may be obtained from the Los
Angeles ACO.
(f) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
Issued in Renton, Washington, on March 13, 1996.
James V. Devany,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 96-6541 Filed 3-19-96; 8:45 am]
BILLING CODE 4910-13-U
