E9-8310. Airworthiness Directives; Turbomeca S.A. ARRIUS 2F Turboshaft Engines

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: Rubs between the pipe and the bulkhead may lead to premature wearing and finally rupture of the P3 air pipe. The loss of P3 air pressure would then force the fuel control system to idle which could have a detrimental effect in critical phases of flight. We are proposing this AD to prevent an uncommanded power loss, which could result in an emergency autorotation landing or accident.

DATES:

We must receive comments on this proposed AD by May 13, 2009.

ADDRESSES:

You may send comments by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.
• Mail: Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue, SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
• Fax: [phone].

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone [phone]) is the same as the Mail address provided in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT:

James Lawrence, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; e-mail: [e-mail]; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2009-0330; Directorate Identifier 2008-NE-43-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of the Web site, anyone can find and read the comments in any of our dockets, including, if provided, the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).

Discussion

The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2008-0134R1, dated February 17, 2009, (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:

On several ARRIUS 2F engines, the clearance between the P3 air pipe P/N 0319719180 and the rear right bulkhead P/N 0319998240 has been found to be too small.

Investigations have shown that both P3 air pipe and rear right bulkhead were compliant to the design. The Turbomeca Engineering Department concluded that the tolerance of assembly established during the design could result in some rubbing between parts.

Rubs between the pipe and the bulkhead may lead to premature wearing and finally rupture of the P3 air pipe. The loss of P3 air pressure would then force the fuel control system to idle which could have a detrimental effect in critical phases of flight.

For the reason stated above, this Airworthiness Directive (AD) requires the inspection of the P3 air pipe (first section) and RH rear half-wall and, in case it is found damaged or non-compliant (idem), the replacement or readjustment of parts.

You may obtain further information by examining the MCAI in the AD docket.

Relevant Service Information

Turbomeca S.A. has issued Mandatory Service Bulletin (MSB) No. 319 75 4810, dated May 14, 2008. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.

FAA's Determination and Requirements of This Proposed AD

This product has been approved by the aviation authority of France, and is approved for operation in the United States. Pursuant to our bilateral agreement with France, they have notified us of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all information provided by France and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.

Costs of Compliance

Based on the service information, we estimate that this proposed AD would affect about 94 engines installed on helicopters of U.S. registry. We also estimate that it would take about 1 work-hour per engine to comply with this proposed AD. The average labor rate is $80 per work-hour. Required parts would cost about $705 per engine. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $73,790. Our cost estimate is exclusive of possible warranty coverage.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The FAA amends § 39.13 by adding the following new AD:

Turbomeca S.A.: Docket No. FAA-2009-0330; Directorate Identifier 2008-NE-43-AD.

Comments Due Date

(a) We must receive comments by May 13, 2009.

Affected Airworthiness Directives (ADs)

(b) None.

Applicability

(c) This AD applies to Turbomeca S.A. ARRIUS 2F turboshaft engines with P3 air pipe, part number 0319719180, installed. These engines are installed on, but not limited to, Eurocopter EC120B helicopters.

Reason

(d) Rubs between the pipe and the bulkhead may lead to premature wearing and finally rupture of the P3 air pipe. The loss of P3 air pressure would then force the fuel control system to idle which could have a detrimental effect in critical phases of flight. We are issuing this AD to prevent an uncommanded power loss, which could result in an emergency autorotation landing or accident.

Actions and Compliance

(e) Unless already done, do the following actions within 100 operating hours after the effective date of this AD. Use paragraphs 2.B.(1) through 2.C.(2) of Turbomeca Mandatory Service Bulletin No. 319 75 4810, dated May 14, 2008.

(1) Visually inspect P3 air pipe (first section) and RH rear half-wall.

(2) Inspect play between P3 air pipe (first section) and RH rear half-wall.

(3) Replace P3 air pipe (first section) if any damage is found.

(4) Readjust the first section of the P3 air pipe if the inspected clearance is found to be not compliant.

(5) If the play after readjusting the first section of the P3 air pipe is still less than 0.5 mm, repeat paragraphs (e)(1) through (e)(4) of this AD within intervals of 100 hours time-since-last inspection.

(6) Replace RH rear half-wall if any damage is found.

FAA AD Differences

(f) None.

Other FAA AD Provisions

(g) Alternative Methods of Compliance (AMOCs): The Manager, Engine Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19.

Related Information

(h) Refer to MCAI EASA Airworthiness Directive 2008-0134R1, dated February 17, 2009, and Turbomeca S.A. Mandatory Service Bulletin No. 319 75 4810, dated May 14, 2008, for related information. Contact Turbomeca, 40220 Tarnos, France; telephone [phone]; telex 570 042; fax [phone], for a copy of this service information.

(i) Contact James Lawrence, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; e-mail: [e-mail]; telephone [phone]; fax [phone], for more information about this AD.

Issued in Burlington, Massachusetts, on April 6, 2009.

Peter A. White,

Assistant Manager, Engine and Propeller Directorate, Aircraft Certification Service.