2012-9123. Agency Information Collection Activities; Submission to OMB for Review and Approval; Comment Request; NESHAP for Wet-Formed Fiberglass Mat Production (Renewal)

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Notice.

SUMMARY:

In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. The ICR which is abstracted below describes the nature of the collection and the estimated burden and cost.

DATES:

Additional comments may be submitted on or before May 17, 2012.

ADDRESSES:

Submit your comments, referencing docket ID number EPA-HQ-OECA-2011-0250, to: (1) EPA online using www.regulations.gov (our preferred method), or by email to: [e-mail], or by mail to: EPA Docket Center (EPA/DC), Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, mail code 28221T, 1200 Pennsylvania Avenue NW., Washington, DC 20460; and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street NW., Washington, DC 20503.

FOR FURTHER INFORMATION CONTACT:

Learia Williams, Monitoring, Assistance, and Media Programs Division, Office of Compliance, Mail Code 2223A, Environmental Protection Agency, 1200 Pennsylvania Avenue NW., Washington, DC 20460; telephone number: [phone]; fax number: [phone]; email address: [e-mail].

SUPPLEMENTARY INFORMATION:

EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On May 9, 2011 (76 FR 26900), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to both EPA and OMB within 30 days of this notice.

EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2011-0250, which is available for public viewing online at http://www.regulations.gov,, or in person viewing at the Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), EPA West, Room 3334, 1301 Constitution Avenue NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is [phone], and the telephone number for the Enforcement and Compliance Docket is [phone].

Use EPA's electronic docket and comment system at http://www.regulations.gov to either submit or view public comments, access the index listing of the contents of the docket, and to access those documents in the docket that are available electronically. Once in the system, select “docket search,” then key in the docket ID number identified above. Please note that EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing at http://www.regulations.gov as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about the electronic docket, go to www.regulations.gov.

Title: NESHAP for Wet-formed Fiberglass Mat Production (Renewal).

ICR Numbers: EPA ICR Number 1964.05, OMB Control Number 2060-0496.

ICR Status: This ICR is scheduled to expire on June 30, 2012. Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB.

Abstract: The affected entities are subject to the General Provisions of the NESHAP at 40 CFR part 63, subpart A, and any changes, or additions to the Provisions specified at 40 CFR part 63, subpart HHHH. These standards apply to new and existing component processes at industrial facilities that manufactured wet-formed fiberglass mat including preparation of glass fibers, formation of fibers into a fiberglass mat, saturation with urea-formaldehyde binder solution, curing and drying the binder-coated fiberglass mat, cooling the mat, and trimming, cutting, and packaging. This information is being collected to assure compliance with 40 CFR part 63, subpart HHHH.

Owners or operators of the affected facilities must submit initial notification, performance tests, and periodic reports and results. Owners or operators are also required to maintain records of the occurrence and duration of any startup, shutdown, or malfunction in the operation of an affected facility, or any period during which the monitoring system is inoperative. Reports, at a minimum, are required semiannually.

All reports are sent to the delegated state or local authority. In the event that there is no such delegated authority, the reports are sent directly to the EPA regional office. This information is being collected to assure compliance with 40 CFR part 63, subpart HHHH, as authorized in section 112 and 114(a) of the Clean Air Act. The required information consists of emissions data and other information that has been determined to be private.

An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB Control Number. The OMB Control Number for EPA's regulations are listed in 40 CFR part 9 and 48 CFR chapter 15, and are identified on the form and/or instrument, if applicable.

Burden Statement: The annual public reporting and recordkeeping burden for this collection of information is estimated to average 107 hours per response. “Burden” means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and maintaining information, and disclosing and providing information; adjust the existing ways to comply with any previously applicable instructions and requirements which have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information.

Respondents/Affected Entities: Owners or operators of Wet-formed fiberglass mat production.

Estimated Number of Respondents: 14.

Frequency of Response: Initially, occasionally, annually, and semiannually.

Estimated Total Annual Hour Burden: 3,421.

Estimated Total Annual Cost: $327,771, which includes $327,771 in labor costs; there are no capital/startup or operation and maintenance (O&M) costs.

Changes in the Estimates: There is an adjustment increase in the total estimated burden hours and costs for both the respondents and the Agency as currently identified in the OMB Inventory of Approved Burdens. This increase is not due to any program changes. The increase in the burden and cost reflects the time and cost to conduct performance tests, which is required every five years of the rule, and to review test results. In addition, this ICR uses updated labor rates in estimating the costs for the respondents and the Agency.

John Moses,

Director, Collection Strategies Division.