2012-9898. Agency Information Collection Activities; Submission to OMB for Review and Approval; Comment Request; National Emission Standards for Hazardous Air Pollutants (NESHAP) for Nine Metal Fabrication and Finishing Area Sources

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Notice.

SUMMARY:

In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. The ICR which is abstracted below describes the nature of the collection and the estimated burden and cost.

DATES:

Additional comments may be submitted on or before May 25, 2012.

ADDRESSES:

Submit your comments, referencing docket ID number EPA-HQ-OECA-2012-0034, to: (1) EPA online using www.regulations.gov (our preferred method), or by email to [e-mail], or by mail to: EPA Docket Center (EPA/DC), Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, mail code 28221T, 1200 Pennsylvania Avenue NW., Washington, DC 20460; and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street NW., Washington, DC 20503.

FOR FURTHER INFORMATION CONTACT:

Learia Williams, Monitoring, Assistance, and Media Programs Division, Office of Compliance, Mail Code 2227A, Environmental Protection Agency, 1200 Pennsylvania Avenue NW., Washington, DC 20460; telephone number: [phone]; fax number: [phone]; email address: [e-mail].

SUPPLEMENTARY INFORMATION:

EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On February 8, 2012 (77 FR 6557), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to both EPA and OMB within 30 days of this notice.

EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2012-0034, which is available for public viewing online at http://www.regulations.gov,, or in person viewing at the Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), EPA West, Room 3334, 1301 Constitution Avenue NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is [phone], and the telephone number for the Enforcement and Compliance Docket is [phone].

Use EPA's electronic docket and comment system at http://www.regulations.gov to submit or view public comments, access the index listing of the contents of the docket, and to access those documents in the docket that are available electronically. Once in the system, select “docket search,” then key in the docket ID number identified above. Please note that EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing at http://www.regulations.gov as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about the electronic docket, go to www.regulations.gov.

Title: National Emissions Standards for Hazardous Air Pollutants (NESHAP) for Nine Metal Fabrication and Finishing Area Sources (Renewal)

ICR Numbers: EPA ICR Number 2298.03, OMB Control Number 2060-0622

ICR Status: This ICR is scheduled to expire on April 31, 2012. Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB.

Abstract: The affected entities are subject to the General Provisions of the NESHAP at 40 CFR part 63, subpart A, and any changes, or additions to the General Provisions specified at 40 CFR part 63, subpart XXXXXX.

These regulations apply to owners or operators of any existing or new metal fabrication and finishing facility that is an area source of hazardous air pollutants (HAP) emissions and uses or has the potential to emit metal fabrication or finishing metal HAP (MFHAP), defined to be the compounds of cadmium, chromium, lead, manganese, and nickel, or any of these metals in the elemental form with the exception of lead.

Owners or operators of the affected facilities must submit initial notification, annual compliance certifications (which include annual reports of exceedences if any have occurred.) Owners or operators are also required to maintain records of the occurrence and duration of any startup, shutdown, or malfunction in the operation of an affected facility, or any period during which the monitoring system is inoperative. Reports, at a minimum, are required semiannually.

All reports are sent to the delegated state or local authority. In the event that there is no such delegated authority, the reports are sent directly to the EPA regional office. This information is being collected to assure compliance with 40 CFR part 63, subpart XXXXXX, as authorized in section 112 and 114(a) of the Clean Air Act. The required information consists of emissions data and other information that have been determined to be private.

An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB Control Number. The OMB Control Numbers for the EPA regulations are listed in 40 CFR part 9 and 48 CFR chapter 15, and are identified on the form and/or instrument, if applicable.

Burden Statement: The annual public reporting and recordkeeping burden for this collection of information is estimated to average 11 hours per response. “Burden” means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and maintaining information, and disclosing and providing information; adjust the existing ways to comply with any previously applicable instructions and requirements which have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information.

Respondents/Affected Entities: Owners or operators of nine metal fabrication and finishing area sources.

Estimated Number of Respondents: 1,933.

Frequency of Response: Initially, occasionally, and annually.

Estimated Total Annual Hour Burden: 20,562.

Estimated Total Annual Cost: $1,972,260, which includes $1,972,260 in labor costs; there are no capital/startup or operating and maintenance costs.

Changes in the Estimates: There is an increase in the total costs as currently identified in the OMB Inventory of Approved Burdens. This increase is not due to any program changes. The change in the cost estimates occurred due to the most updated labor rates for both respondents and the Agency. Despite the increase in burden costs, there is a decrease in the labor hours in this ICR compared to the previous ICR due to a mathematical error in determining the person-hours per respondent.

John Moses,

Director, Collection Strategies Division.