01-9935. Airworthiness Directives; McDonnell Douglas Model DC-8 Series Airplanes

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Final rule.

SUMMARY:

This amendment adopts a new airworthiness directive (AD), applicable to certain McDonnell Douglas Model DC-8 series airplanes, that requires an inspection of the antifogging or heating wiring to detect chafing or damage, as applicable; inspection of the insulation blankets to detect damage; and repair, if necessary. This amendment also requires revising the clearview window heating wiring installations. This amendment is prompted by a report of an electrical short that resulted in damage to the antifogging circuit wiring and insulation blanket above the Captain's clearview window. The actions specified by this AD are intended to prevent chafed and damaged wires as a result of a sharp bend and restricted space between the fuselage frame and the clearview window in the full open position, which could result in an electrical short, damage to the antifogging circuit wiring and insulation blanket, and consequent smoke and fire in the flight deck.

DATES:

Effective May 31, 2001.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of May 31, 2001.

ADDRESSES:

The service information referenced in this AD may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024). This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT:

Elvin Wheeler, Aerospace Engineer, Systems and Equipment Branch, ANM-130L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model DC-8 series airplanes was published in the Federal Register on September 1, 2000 (65 FR 53201). That action proposed to require an inspection of the antifogging or heating wiring to detect chafing or damage, as applicable; inspection of the insulation blankets to detect damage; and repair, if necessary. That action also proposed to require revising the clearview window heating wiring installations.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact

There are approximately 163 airplanes of the affected design in the worldwide fleet. The FAA estimates that 113 airplanes of U.S. registry will be affected by this AD, that it will take approximately 2 work hours per airplane to accomplish the required detailed visual inspections, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the inspections required by this AD on U.S. operators is estimated to be $13,560, or $120 per airplane.

The FAA also estimates that 54 airplanes of U.S. registry specified as “Group 1” in McDonnell Douglas Alert Service Bulletin DC8-30A032, Revision 02, dated September 21, 1999, will be affected by this AD, that it will take approximately 5 work hours per airplane to accomplish the required wiring revision, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the wiring revision required by this AD on U.S. operators is estimated to be $16,200, or $300 per airplane.

The FAA also estimates that 59 airplanes of U.S. registry specified as “Group 2” in McDonnell Douglas Alert Service Bulletin DC8-30A032, Revision 02, dated September 21, 1999, will be affected by this AD, that it will take approximately 4 work hours per airplane to accomplish the required wiring revision, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the wiring revision required by this AD on U.S. operators is estimated to be $14,160, or $240 per airplane.

The cost impact figures discussed above are based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

2001-08-17 McDonnell Douglas: Amendment 39-12194.

Applicability: Model DC-8-11, DC-8-12, DC-8-21, DC-8-31, DC-8-32, DC-8-33, DC-8-41, DC-8-42, DC-8-43, DC-8-51, DC-8-52, DC-8-53, DC-88-55, DC-8F-54, DC-8F-55, DC-8-61, DC-8-61F, DC-8-62, DC-8-62F, DC-8-63, and DC-8-63F series airplanes, as listed in McDonnell Douglas Alert Service Bulletin DC8-30A032, Revision 02, dated September 21, 1999; certificated in any category.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent chafed and damaged wires as a result of a sharp bend and restricted space between the fuselage frame and the clearview window in the full open position, which could result in an electrical short, damage to the antifogging circuit wiring and insulation blanket, and consequent smoke and fire in the flight deck, accomplish the following:

Inspection and Modification

(a) Within 2 years after the effective date of this AD, perform a detailed visual inspection of the heating wiring (Group 1 airplanes) or antifogging wiring (Group 2 airplanes) to detect chafing or damage, as applicable; perform a general visual inspection of the insulation blankets to detect damage; and revise the clearview window heating wiring conduit installation; in accordance with McDonnell Douglas Alert Service Bulletin DC8-30A032, Revision 02, dated September 21, 1999. If any damaged insulation blanket or wire is detected, or if any chafed wire is detected, prior to further flight, repair in accordance with the service bulletin.

Note 2:

For the purposes of this AD, a detailed visual inspection is defined as: “An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.”

Note 3:

For the purposes of this AD, a general visual inspection is defined as: “A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or drop-light, and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.”

Alternative Methods of Compliance

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO.

Note 4:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO.

Special Flight Permits

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Incorporation by Reference

(d) The actions shall be done in accordance with McDonnell Douglas Alert Service Bulletin DC8-30A032, Revision 02, dated September 21, 1999. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Technical Publications Business Administration, Dept. C1-L51 (2-60). Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Effective Date

(e) This amendment becomes effective on May 31, 2001.

Issued in Renton, Washington, on April 17, 2001.

Donald L. Riggin,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.