[Federal Register Volume 61, Number 96 (Thursday, May 16, 1996)]
[Notices]
[Pages 24790-24791]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 96-12343]
=======================================================================
-----------------------------------------------------------------------
ENVIRONMENTAL PROTECTION AGENCY
[FRL-5506-1]
National Emission Standards for Hazardous Air Pollutants, Benzene
Emissions From Benzene Storage Vessels, and Coke Byproduct Recovery
Plants; Subparts Y and L, OMB No. 2060-0185; Agency Information
Collection Activities Under OMB Review
AGENCY: Environmental Protection Agency (EPA).
ACTION: Notice.
-----------------------------------------------------------------------
SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501
et seq.), this notice announces that the Information Collection Request
(ICR) abstracted below has been forwarded to the Office of Management
and Budget (OMB) for review and comment. The ICR describes the nature
of the information collection and its expected cost and burden.
DATES: Comments must be submitted on or before June 17, 1996.
FOR FURTHER INFORMATION OR A COPY CALL: Sandy Farmer, United States
Environmental Protection Agency, 202-260-2740, and refer to EPA ICR No.
1080.09.
SUPPLEMENTARY INFORMATION:
Title: National Emission Standards for Hazardous Air Pollutants,
Benzene Emissions from Benzene Storage Vessels, and Coke Byproduct
Recovery Plants--40 CFR Part 61, Subparts Y and L, OMB No. 2060-0185.
This is request for a revision of a currently approved collection.
Abstract:
Subpart L: Coke By-Product Recovery Plants
The standards require initial notification reports with respect to
construction, emissions tests, and startup; one-time reports on initial
performance tests; and periodic reports of emissions tests results.
Notifications inform the Agency or delegated authority when a
source becomes subject to the standard. The reviewing authority may
then inspect the source to check that pollution control devices are
properly installed and operated and the standards are being met.
Performance test reports are the Agency's record of a source's initial
capability to comply with the emission standard, and note the operating
conditions under which compliance was achieved. The regular reports are
used for problem identification, as a check on source operation and
maintenance, and for compliance determinations.
The Agency uses the information generated by the monitoring,
recordkeeping and reporting requirements to ensure that facilities
continue to operate the control equipment used to achieve compliance.
The information collected from recordkeeping and reporting requirements
is also used for targeting inspections, and is of sufficient quality to
be used as evidence in court. Based on reported information, EPA
decides how many plant inspections are needed, which plants to inspect,
and what records or processes to inspect at the plant. In the absence
of such information enforcement personnel would be unable to determine
whether the standards are being met on a continuous basis, as required
by the Clean Air Act.
Reporting requirements specific to benzene coke by-product recovery
plants, Subpart L, include a semiannual report by affected facilities.
The semiannual reports include results of leak monitoring and
performance tests. Respondents also are required to submit semiannual
reports of measurements for sources subject to a no detectable
emissions limit and semiannual reports summarizing the results of the
leak detection and repair program implemented at the plant. One report
would incorporate information for both process equipment and fugitive
sources. Exhausters are subject to quarterly monitoring requirements
unless the exhauster is equipped with a seal system that has a barrier
fluid, the exhauster seal is loaded and vented to a control device, or
a leakless exhauster is used.
The owner or operator choosing to use one of the alternative
control technologies (i.e., a carbon absorber or a vapor incinerator)
must record for the life of the control device, the design of the
control device, the sources which it is intended to control, and a plan
for the operation, maintenance and action needed to correct problems.
Such a record would assist the owner or operator to operate the device
properly throughout its life and would also assist the enforcement
personnel in determining whether the device had been properly
maintained and appropriate corrective action had been taken. The owner
or operator is required to record the results of each test for
determining compliance with the standard and any data that provide
reference values for parameters that are important to monitoring, such
as temperature of the firebox in a vapor incinerator and the benzene
concentration at the inlet to a carbon adsorber. Some of these data are
gathered during the compliance test, others separately (e.g., the
demonstrated bed life of a carbon adsorber).
The alternative control options also require reporting in
accordance with the General Provisions. These are submitted each time a
compliance test is performed. In addition, the rule requires reporting
of exceedances of the monitored parameters, with a brief description of
the corrective action taken.
Any owner or operator subject to the provisions of this part shall
maintain an up-to-date file of monitoring and recordings, and retain
them for at least two years following. Records of equipment and process
design are kept permanently.
Subpart Y: Benzene Storage Vessels
Respondents are all owners or operators of benzene storage vessels.
It is estimated that 126 existing plants are subject to the standard.
All owners and operators of new or reconstructed plants would also have
to respond.
In the General Provisions of 40 CFR Part 61 applicable to storage
vessels, require up to four separate one time-only reports for each
owner or operator: notification of construction or reconstruction,
initial source report, notification of physical/operational changes,
notification of anticipated and actual startup. The initial source
report is the only one of these reports that would be required from
existing sources under the standard.
Certain records and reports are necessary to assist EPA and State
agencies to which enforcement has been delegated in determining
compliance with the standard.
The standard is an equipment standard and owners or operators of
vessels equipped with the specified controls are required to submit,
along with the notifications required by the General Provisions, a
report that describes the control equipment used to comply with the
regulation. Thereafter, an annual visual inspection is required of the
primary seal of internal floating roof vessels (IFR's) (in cases where
no secondary seal is present, (An annual seal gap measurement of the
secondary seal system on external floating roof vessels (EFR's).) The
following
[[Page 24791]]
inspections are required every five years: (1) internal inspection to
seal system on IFR's equipped with primary and secondary seals in
situations where the owner to operator has decided to forego the annual
visual inspection; and (2) measurement of gaps between the tank wall
and primary seal on EFR's. An internal inspection in which the tank is
emptied and degassed is required at least every 10 years for IFR's.
Another control option allowed is for owners or operators to equip
vessels with closed-vent systems and 95-percent efficient control
devices. It is expected that very few, if any, vessels will be equipped
with these systems; however, owners or operators of vessels with such
systems are required to submit, for the Administrator's approval, an
operating plan describing system design specifications and an
operation, maintenance, and inspection plan for the system. In the
event the owner or operator has installed a flare, a report showing
compliance with visible emission provisions shall be furnished to the
Administrator. For closed-vent systems with control devices, quarterly
reports are required informing the Administrator of each occurrence
that results in excess emissions. Annual reports of the results of
these inspections and seal gap measurements are required. These reports
shall identify each storage vessel that is determined to be out of
compliance with the standard, the nature of the defects, and the date
the vessel was emptied or the repair was made. The owner or operator
must keep copies of all reports and records for two years.
The owner or operator of each benzine storage vessel shall, for the
life of the source, keep readily accessible records showing the
dimension of the vessel and an analysis showing the capacity of the
storage vessel. For each vessel with a closed vent system and 95-
percent efficient control device, records of the operating plan shall
be kept for the life of the control device. Records of monitored
parameters and maintenance shall be kept for two years.
An Agency may not conduct or sponsor, and a person is not required
to respond to, a collection of information unless it displays a
currently valid OMB control number. The OMB control numbers for EPA's
regulations are listed in 40 CFR Part 9 and 48 CFR Charter 15. The
Federal Register Notice required under 5 CFR 1320.8(d), soliciting
comments on this collection of information was published on September
28, 1995.
Burden Statement: The annual public reporting and recordkeeping
burden for this collection of information is estimated to average 11.85
hours per response. Burden means the total time, effort, or financial
resources expended by persons to generate, maintain, retain, or
disclose or provide information to or for a Federal agency. This
estimate includes the time needed to review instructions; develop,
acquire, install, and utilize technology and systems for the purposes
of collecting, validating, and verifying information, processing and
maintaining information, and disclosing and providing information;
adjust the existing ways to comply with any previously applicable
instructions and requirements; train personnel to be able to respond to
a collection of information; search data sources; complete and review
the collection of information; and transmit or otherwise disclose the
information.
Respondents/Affected Entities: 162.
Estimated Number of Respondents: 162.
Frequency of Collection: Quarterly and Semi-annual.
Estimated Total Annual Burden on Respondents: 8,628 Hours.
Send comments on the Agency's need for this information, the
accuracy of the provided burden estimates, and any suggested methods
for minimizing respondent burden, including through the use of
automated collection techniques to the following addresses. Please
refer to EPA ICR No. 1080.09 and OMB Control No. 2060-0185 in any
correspondence.
Ms. Sandy Farmer, U.S. Environmental Protection Agency, OPPE Regulatory
Information Division (2137), 401 M Street, SW., Washington, DC 20460
and
Office of Information and Regulatory Affairs, Office of Management and
Budget, Attention: Desk Officer for EPA, 725 17th Street NW.,
Washington, DC 20503.
Dated: May 9, 1996.
Joseph Retzer,
Director, Regulatory Information Division.
[FR Doc. 96-12343 Filed 5-15-95; 8:45 am]
BILLING CODE 6560-50-M
