2011-10138. Airworthiness Directives; Dassault-Aviation Model FALCON 7X Airplanes  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration (FAA), Department of Transportation (DOT).

    ACTION:

    Final rule.

    SUMMARY:

    We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

    Following investigation of an in service event, it has been determined that in case a short circuit occurs on a weight-on-wheels (WOW) proximity sensor wiring, both circuit breakers that supply power to that wiring will trip, causing simultaneous de-power of all WOW proximity sensors of that part of the system. The loss of the corresponding WOW information would lead to untimely inhibition of warnings that could compromise the pilot capacity to react to abnormal or failure landing conditions.

    * * * * *

    We are issuing this AD to require actions to correct the unsafe condition on these products.

    DATES:

    This AD becomes effective June 6, 2011.

    The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of June 6, 2011.

    ADDRESSES:

    You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on December 30, 2010 (75 FR 82327). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

    Following investigation of an in service event, it has been determined that in case a short circuit occurs on a weight-on-wheels (WOW) proximity sensor wiring, both circuit breakers that supply power to that wiring will trip, causing simultaneous de-power of all WOW proximity sensors of that part of the system. The loss of the corresponding WOW information would lead to untimely inhibition of warnings that could compromise the pilot capacity to react to abnormal or failure landing conditions.

    This AD requires the modification of the WOW System to improve its robustness against short circuit of the proximity sensors wiring by adding dedicated fuses to each Start Printed Page 24359WOW proximity sensor, in accordance with Dassault Aviation Service Bulletin (SB) F7X-065.

    You may obtain further information by examining the MCAI in the AD docket.

    Comments

    We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

    Conclusion

    We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

    Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

    We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a NOTE within the AD.

    Costs of Compliance

    We estimate that this AD will affect 21 products of U.S. registry. We also estimate that it will take about 9 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts will cost about $0 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $16,065, or $765 per product.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

    We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    Regulatory Findings

    This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify that this AD:

    1. Is not a ”significant regulatory action” under Executive Order 12866;

    2. Is not a ”significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

    3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

    Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov;​; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    Adoption of the Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

    Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new AD:

    End Amendment Part

    2011-09-18 Dassault-Aviation: Amendment 39-16680. Docket No. FAA-2010-1207; Directorate Identifier 2010-NM-140-AD.

    Effective Date

    (a) This airworthiness directive (AD) becomes effective June 6, 2011.

    Affected ADs

    (b) None.

    Applicability

    (c) This AD applies to Dassault-Aviation Model FALCON 7X airplanes, certificated in any category; except those having incorporated modification M1031.

    Subject

    (d) Air Transport Association (ATA) of America Code 32: Landing Gear.

    Reason

    (e) The mandatory continuing airworthiness information (MCAI) states:

    Following investigation of an in service event, it has been determined that in case a short circuit occurs on a weight-on-wheels (WOW) proximity sensor wiring, both circuit breakers that supply power to that wiring will trip, causing simultaneous de-power of all WOW proximity sensors of that part of the system. The loss of the corresponding WOW information would lead to untimely inhibition of warnings that could compromise the pilot capacity to react to abnormal or failure landing conditions.

    * * * * *

    Compliance

    (f) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

    Installation

    (g) Within 27 months after the effective date of this AD, or within 1,800 flight hours after the effective date of this AD, whichever occurs first, install dedicated fuses on WOW proximity sensors, in accordance with the Accomplishment Instructions of Dassault Mandatory Service Bulletin 7X-065, dated July 24, 2009.

    FAA AD Differences

    Note 1:

    This AD differs from the MCAI and/or service information as follows: No differences.

    Other FAA AD Provisions

    (h) The following provisions also apply to this AD:

    (1) Alternative Methods of Compliance (AMOCs): The Manager, International Start Printed Page 24360Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Information may be e-mailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.

    (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

    Related Information

    (i) Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2010-0031, dated March 3, 2010; and Dassault Mandatory Service Bulletin 7X-065, dated July 24, 2009; for related information.

    Material Incorporated by Reference

    (j) You must use Dassault Mandatory Service Bulletin 7X-065, dated July 24, 2009, to do the actions required by this AD, unless the AD specifies otherwise.

    (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51.

    (2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606; telephone 201-440-6700; Internet http://www.dassaultfalcon.com.

    (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221.

    (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/​federal_​register/​code_​of_​federal_​regulations/​ibr_​locations.html.

    Start Signature

    Issued in Renton, Washington, on April 20, 2011.

    Kalene C. Yanamura,

    Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. 2011-10138 Filed 4-29-11; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Comments Received:
0 Comments
Effective Date:
6/6/2011
Published:
05/02/2011
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule.
Document Number:
2011-10138
Dates:
This AD becomes effective June 6, 2011.
Pages:
24358-24360 (3 pages)
Docket Numbers:
Docket No. FAA-2010-1207, Directorate Identifier 2010-NM-140-AD, Amendment 39-16680, AD 2011-09-18
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
2011-10138.pdf
CFR: (1)
14 CFR 39.13