[Federal Register Volume 60, Number 100 (Wednesday, May 24, 1995)]
[Notices]
[Page 27559]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 95-12670]
-----------------------------------------------------------------------
DEPARTMENT OF JUSTICE
Notice Pursuant to the National Cooperative Research and
Production Act of 1993--The Consortium for Non-Contact Gauging
Notice is hereby given that, on March 7, 1995, pursuant to section
6(a) of the National Cooperative Research and Production Act of 1993,
15 U.S.C. 4301 et seq. (``the Act''), the participants in the
Consortium for Non-Contact Gauging (``CNCG''), have filed written
notifications simultaneously with the Attorney General and the Federal
Trade Commission disclosing (1) the identities of the parties and (2)
the nature and objective of the venture. The notifications were filed
for the purpose of extending the protection of the Act limiting the
recovery of antitrust plaintiffs to actual damages under specified
circumstances. Pursuant to Section 6(b) of the Act, the identities of
the parties and its general area of planned activities are: Cleveland
Advanced Manufacturing Program, Cleveland, OH; Caterpillar
Incorporated, Peoria, IL; Chrysler Corporation, Detroit, MI;
CyberOptics Corporation, Minneapolis, MN; Eaton Corporation, Cleveland,
OH; GE Aircraft Engines, Cincinnati, OH; GE Corporate Research and
Development, Schenectady, NY; the Sheffield Measurement Division of
Giddings & Lewis, Dayton, OH; the Industrial Technology Institute, Ann
Arbor, MI; NASA Lewis Research Center, Cleveland, OH; the Ohio
Aerospace Institute, Cleveland, OH; the Department of Electrical &
Computer Engineering of the University of Cincinnati, Cincinnati, OH;
Central State University, Wilberforce, OH; and Intelligent Automation
Systems, Cambridge, MA. The nature and objective of the research
program, performed in accordance with CNCG, is to design and develop a
flexible, high-speed, high-accuracy measurement system based on
combining a low-resolution pre-inspection system, high-resolution
optical sensors, and a precision five-axis positioner with an
integrated control system to tie the subsystems together and link to
other shop systems. The proposed system is referred to as the Rapid
Agile Metrology for Manufacturing (RAMM) system.
Participation in this project remains open. Information regarding
participation in the project may be obtained from Eileen Picket, Ohio
Aerospace Institute, Cleveland, Ohio.
Constance K. Robinson,
Director of Operations, Antitrust Division.
[FR Doc. 95-12670 Filed 5-23-95; 8:45 am]
BILLING CODE 4410-01-M
