[Federal Register Volume 64, Number 101 (Wednesday, May 26, 1999)]
[Proposed Rules]
[Pages 28418-28420]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 99-13318]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 99-SW-30-AD]
Airworthiness Directives; Bell Helicopter Textron, A Division of
Textron Canada, Model 206L, L-1, L-3, and L-4 Helicopters
AGENCY: Federal Aviation Administration, DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: This document proposes the supersedure of an existing
airworthiness directive (AD) applicable to Bell Helicopter Textron, A
Division of Textron Canada (BHTC) Model 206L, L-1, L-3, and L-4
helicopters. This action would require the same type of actions
required by the existing AD. In addition, the proposal would require an
increase in the Retirement Index Number (RIN) multiplier for the mast,
a correction in the model number, and other nonsubstantive changes.
This proposal is prompted by further tests and analyses that indicate
the RIN multiplier for the Model 206L-4 needs to be increased and the
discovery of other errors in the existing AD. The actions specified by
the proposed AD are intended to prevent fatigue failure of the mast or
trunnion, which could result in loss of the main rotor system and
subsequent loss of control of the helicopter.
DATES: Comments must be received on or before July 26, 1999.
ADDRESSES: Submit comments in triplicate to the Federal Aviation
Administration (FAA), Office of the Regional Counsel, Southwest Region,
Attention: Rules Docket No. 99-SW-30-AD, 2601 Meacham Blvd., Room 663,
Fort Worth, Texas 76137. Comments may be inspected at this location
between 9:00 a.m. and 3:00 p.m., Monday through Friday, except Federal
holidays.
The service information referenced in the proposed rule may be
obtained from Bell Helicopter Textron, a Division of Textron Canada,
12,800 Rue de L-Avenir, Mirabel, Quebec, Canada J7J1R4, ATTN: Product
Support Engineering Light Helicopters. This information may be examined
at the FAA, Office of the Regional Counsel, Southwest Region, 2601
Meacham Blvd., Room 663, Fort Worth, Texas.
FOR FURTHER INFORMATION CONTACT: Jurgen Priester, Aerospace Engineer,
Rotorcraft Certification Office, Rotorcraft Directorate, FAA, 2601
Meacham Blvd., Fort Worth, Texas 76137, telephone (817) 222-5159, fax
(817) 222-5959.
SUPPLEMENTARY INFORMATION:
Comments Invited
Interested persons are invited to participate in the making of the
proposed rule by submitting such written data, views, or arguments as
they may desire. Communications should identify the Rules Docket number
and be submitted in triplicate to the address specified above. All
communications received on or before the closing date for comments,
specified above, will be considered before taking action on the
proposed rule. The proposals contained in this notice may be changed in
light of the comments received.
Comments are specifically invited on the overall regulatory,
economic, environmental, and energy aspects of the proposed rule. All
comments submitted will be available, both before and after the closing
date for comments, in the Rules Docket for examination by interested
persons. A report summarizing each FAA-public contact concerned with
the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments
submitted in response to this notice must submit a self-addressed,
stamped postcard on which the following statement is made: ``Comments
to Docket No. 99-SW-30-AD. The postcard will be date stamped and
returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request
to the FAA, Office of the Regional Counsel, Southwest Region,
Attention: Rules Docket No. 99-SW-30-AD, 2601 Meacham Blvd., Room 663,
Fort Worth, Texas 76137.
Discussion
On March 14, 1997, the FAA issued AD 97-07-07, Amendment 39-9981
(62 FR 16073). The AD required the creation of a component history card
or equivalent record using the RIN system for certain masts and
trunnions within the next 100 hours time-in-service (TIS) and a system
for tracking increases to the accumulated RIN. That AD also established
a retirement life for the trunnion based solely on a RIN of 24,000 and
a retirement life for the mast based on a maximum RIN of 44,000 or the
flight-hour service life limit, whichever occurs first. That AD was
prompted by fatigue analyses and tests that show certain masts and
trunnions fail sooner than originally anticipated because of the
unanticipated higher number of torque events performed with those masts
and trunnions in addition to the TIS accrued under other operating
conditions. That condition, if not corrected, could result in fatigue
failure of the mast or trunnion, which could result in loss of the main
rotor system and subsequent loss of control of the helicopter.
Since the issuance of that AD, the FAA has discovered that the AD
contained errors in two paragraphs. Paragraph (c)(2) incorrectly
requires the operator to increase the mast RIN count for the Model
206L-4 by 1, when it should actually be increased by 2, for each torque
event. Paragraph (c)(1)(i) contains an omission of the letter ``L''
from one helicopter model number. This AD would correct paragraph
(c)(2) to avoid a miscalculation of the mast RIN and to correctly
identify the Model 206L. This AD would also add nonsubstantive changes
to the text. Paragraphs (b) and (c) would state that the RIN may be
recorded on an ``equivalent record'' in lieu of a component history
card. Paragraph (d) and (e) would state that this AD revises the
Limitations section of the maintenance manual.
Explanation of Relevant Service Information
Bell Helicopter Textron, Inc. has issued Alert Service Bulletin No.
206L-94-99, Revision A, dated May 1, 1995 (ASB), which describes
procedures for calculating the retirement life based on the RIN count.
FAA's Conclusions
These helicopter models are manufactured in Canada and are type
certificated for operation in the United States under the provisions of
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and
the applicable bilateral airworthiness agreement. Pursuant to this
bilateral airworthiness agreement, Transport Canada has kept the FAA
informed of the situation described above. The FAA has examined the
findings of Transport Canada, reviewed all available information, and
determined that AD action is necessary for products of this
[[Page 28419]]
type design that are certificated for operation in the United States.
Since an unsafe condition has been identified that is likely to
exist or develop on BHTC Model 206L, L-1, L-3, and L-4 helicopters of
the same type designs registered in the United States, the proposed AD
would supersede AD 97-07-07 to prevent miscalculation of a RIN for
Model 206L-4 main rotor masts. This AD would require creation of a
component history card or equivalent record using a RIN system,
establishing a system for tracking increases to the accumulated RIN,
and a maximum accumulated RIN for masts and trunnions. The actions
would be required to be accomplished in accordance with the ASB
described previously.
The FAA estimates that 711 helicopters of U.S. registry would be
affected by this AD, that it would take approximately (1) 8 work hours
per helicopter to replace the mast and 10 work hours per helicopter to
replace the trunnion due to the new method of determining the
retirement life required by this AD; (2) 2 work hours per helicopter to
create the component history card of equivalent record (record); (3) 10
work hours per helicopter to maintain the record each year, and that
the average labor rate is $60 per work hour. Required parts would cost
approximately $9,538 per mast and $2,083 per trunnion. Based on these
figures, the cost impact of the AD on U.S. operators for the first year
is estimated to be $2,016,989, and each subsequent year to be
$1,945,889. These costs assume replacement of the mast and trunnion in
one-sixth of the fleet each year, creation and maintenance of the
records for all the fleet the first year, and creation of one-sixth of
the fleet's records and maintenance of the records for all the fleet
each subsequent year. The estimated cost impact amounts are based on
assumptions that no operator has yet accomplished any of the
requirements of this AD action, and that no operator would accomplish
those actions in the future if this AD were not adopted.
The regulations proposed herein would not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this
proposal would not have sufficient federalism implications to warrant
the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this proposed
regulation (1) is not a ``significant regulatory action'' under
Executive Order 12866; (2) is not a ``significant rule'' under the DOT
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
and (3) if promulgated, would not have a significant economic impact,
positive or negative, on a substantial number of small entities under
the criteria of the Regulatory Flexibility Act. A copy of the draft
regulatory evaluation prepared for this action is contained in the
Rules Docket. A copy of it may be obtained by contacting the Rules
Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration proposes to amend
part 39 of the Federal Aviation Regulations (14 CFR part 39) as
follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by removing Amendment 39-9981, Docket
No. 95-SW-36-AD (62 FR 16073, dated April 4, 1997) and by adding a new
airworthiness directive (AD) to read as follows:
Bell Helicopter Textron, A Division of Textron Canada: Docket No.
99-SW-30-AD. Supersedes AD 97-07-07, Amendment 39-9981, Docket 95-
SW-36-AD.
Applicability: Model 206L, 206L-1, 206L-3, and 206L-4
helicopters, with main rotor mast (mast), part number (P/N) 206-040-
535-001, -005, -101, or -105, installed, or main rotor trunnion
(trunnion), P/N 206-011-120-103, installed, certificated in any
category.
Note 1: This AD applies to each helicopter identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For helicopters that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (f) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required within 100 hours time-in-service, unless
accomplished previously.
To prevent fatigue failure of the mast or trunnion, which could
result in loss of the main rotor system and subsequent loss of
control of the helicopter, accomplish the following:
(a) Create a component history card or an equivalent record for
the affected mast and trunnion.
(b) Determine the accumulated Retirement Index Number (RIN) to
date based on the number of takeoffs and external load lifts (torque
events) for parts in service in accordance with paragraphs 1 and 2
of the Accomplishment Instructions of Bell Helicopter Textron, Inc.
Alert Service Bulletin No. 206L-94-99, Revision A, dated May 1, 1995
(ASB). Record this accumulated RIN on the component history card or
equivalent record.
(c) After complying with paragraphs (a) and (b) of this AD,
during each operation thereafter, maintain a count of the number of
external load lifts and the number of takeoffs performed and at the
end of each day's operations, increase the accumulated RIN on the
component history card or equivalent record as follows:
(1) For the trunnion,
(i) Increase the RIN for the Model 206L, 206L-1, and 206L-3
helicopters by 1 for each torque event.
(ii) Increase the RIN for the Model 206L-4 helicopters by 2 for
each torque event.
(2) For the mast,
(i) Increase the RIN for the Model 206L, 206L-1, 206L-3
helicopters by 1 for each torque event.
(ii) Increase the RIN for the Model 206L-4 helicopters by 2 for
each torque event.
Note 2: Previous Model 206L-4 mast RIN calculations may have
increased the RIN by only 1 for each torque event. This AD increases
the Model 206L-4 mast RIN by 2 for each torque event.
(d) Remove the trunnion from service on or before attaining the
maximum accumulated RIN (24,000) in accordance with Table 1 of the
Accomplishment Instructions of the ASB. This AD revises the
Limitations section of the maintenance manual by establishing a
retirement life of 24,000 RIN for the trunnion.
(e) Remove the mast from service on or before attaining the
maximum accumulated RIN (44,000) or the flight hour service life
limit, whichever occurs first, in accordance with Table 2 of the
Accomplishment Instructions the ASB. This AD revises the Limitations
section of the maintenance manual by establishing a retirement life
of 44,000 RIN for the mast.
(f) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, Rotorcraft Certification Office,
Rotorcraft Directorate, FAA. Operators shall submit their requests
through an appropriate FAA Principal Maintenance Inspector, who may
add comments and then send it to the Manager, Rotorcraft
Certification Office.
Note 3: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
[[Page 28420]]
obtained from the Rotorcraft Certification Office.
(g) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the helicopter to a location where
the requirements of this AD can be accomplished.
Issued in Fort Worth, Texas, on May 18, 1999.
Mark R. Schilling,
Acting Manager, Rotorcraft Directorate, Aircraft Certification Service.
[FR Doc. 99-13318 Filed 5-25-99; 8:45 am]
BILLING CODE 4910-13-P
