06-4053. Airworthiness Directives; Dassault Model Falcon 900EX Airplanes

AGENCY:

Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION:

Final rule.

SUMMARY:

The FAA is adopting a new airworthiness directive (AD) for certain Dassault Model Falcon 900EX airplanes. This AD requires inspecting the number 2 engine left- and right-hand forward mounts for missing rivets, and installing rivets if necessary. This AD results from reports of two missing rivets in the front section of the central engine mast discovered on airplanes in service and in production. We are issuing this AD to detect and correct missing rivets in the front section of the central engine mast, which could result in reduced structural integrity of the central engine mast, possible separation of the engine from the airplane during flight, and consequent loss of control of the airplane.

DATES:

This AD becomes effective June 7, 2006.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in the AD as of June 7, 2006.

ADDRESSES:

You may examine the AD docket on the Internet at http://dms.dot.gov or in person at the Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, Washington, DC.

Contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606, for service information identified in this AD.

FOR FURTHER INFORMATION CONTACT:

Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, WA 98055-4056; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

Examining the Docket

You may examine the airworthiness directive (AD) docket on the Internet at http://dms.dot.gov or in person at the Docket Management Facility office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Management Facility office (telephone [phone]) is located on the plaza level of the Nassif Building at the street address stated in the ADDRESSES section.

Discussion

The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to certain Dassault Model Falcon 900EX airplanes. That NPRM was published in the Federal Register on February 15, 2006 (71 FR 7874). That NPRM proposed to require inspecting the number 2 engine left- and right-hand forward mounts for missing rivets, and installing rivets if necessary.

Comments

We provided the public the opportunity to participate in the development of this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

Costs of Compliance

The following table provides the estimated costs for U.S. operators to comply with this AD.

Estimated Costs

Action	Work hours	Average labor rate per hour	Cost per airplane	Number of U.S.-registered airplanes	Fleet cost
Inspection for missing rivets	2	$65	$130	81	$10,530

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in subtitle VII, part A, subpart III, section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866;

(2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The Federal Aviation Administration (FAA) amends § 39.13 by adding the following new airworthiness directive (AD):

2006-09-04 Dassault Aviation: Amendment 39-14574. Docket No. FAA-2006-23886; Directorate Identifier 2005-NM-255-AD.

Effective Date

(a) This AD becomes effective June 7, 2006.

Affected ADs

(b) None.

Applicability

(c) This AD applies to Dassault Model Falcon 900EX airplanes, certificated in any category, having serial numbers 1 through 137 inclusive.

Unsafe Condition

(d) This AD results from reports of two missing rivets in the front section of the central engine mast discovered on airplanes in service and in production. We are issuing this AD to detect and correct missing rivets in the front section of the central engine mast, which could result in reduced structural integrity of the central engine mast, possible separation of the engine from the airplane during flight, and consequent loss of control of the airplane.

Compliance

(e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

Service Bulletin References

(f) The term “service bulletin,” as used in this AD, means the Accomplishment Instructions of Dassault Service Bulletin F900EX-220, Revision 1, dated July 29, 2005. Although the service bulletin referenced in this AD specifies to submit information to the manufacturer, this AD does not include such a requirement.

Inspection for and Installation of Missing Rivets

(g) Prior to accumulating 7,500 total flight hours, or within 6 months after the effective date of this AD, whichever is later: Do a general visual inspection of the number 2 engine left- and right-hand forward mounts for missing rivets, in accordance with the service bulletin. If any rivet is missing, before further flight, install the new rivet, in accordance with the service bulletin.

Note 1:

For the purposes of this AD, a general visual inspection is: “A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made from within touching distance unless otherwise specified. A mirror may be necessary to ensure visual access to all surfaces in the inspection area. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or droplight and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.”

Inspections and Installations According to Previous Issue of Service Bulletin

(h) Inspecting for and installing rivets is also acceptable for compliance with the requirements of paragraph (g) of this AD if done before the effective date of this AD in accordance with the Accomplishment Instructions of Dassault Service Bulletin F900EX-220, dated April 14, 2004.

Alternative Methods of Compliance (AMOCs)

(i)(1) The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19.

(2) Before using any AMOC approved in accordance with § 39.19 on any airplane to which the AMOC applies, notify the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office.

Related Information

(j) French airworthiness directive F-2005-066, dated April 27, 2005, also addresses the subject of this AD.

Material Incorporated by Reference

(k) You must use Dassault Service Bulletin F900EX-220, Revision 1, dated July 29, 2005, to perform the actions that are required by this AD, unless the AD specifies otherwise. The Director of the Federal Register approved the incorporation by reference of this document in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, NJ 07606, for a copy of this service information. You may review copies at the Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street, SW., Room PL-401, Nassif Building, Washington, DC; on the Internet at http://dms.dot.gov;​; or at the National Archives and Records Administration (NARA). For information on the availability of this material at the NARA, call [phone], or go to http://www.archives.gov/​federal_​register/​code_​of_​federal_​regulations/​ibr_​locations.html.

Issued in Renton, Washington, on April 20, 2006.

Kalene C. Yanamura,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.