05-11102. Agency Information Collection Activities; Submission for OMB Review and Approval; Comment Request; NESHAP for Friction Materials Manufacturing (Renewal), ICR Number 2025.03, OMB Control Number 2060-0481

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Notice.

SUMMARY:

In compliance with the Paperwork Reduction Act, this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. This ICR is scheduled to expire on July 31, 2005. Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB. This ICR describes the nature of the information collection and its estimated burden and cost.

DATES:

Additional comments may be submitted on or before July 5, 2005.

ADDRESSES:

Submit your comments, referencing docket ID number OECA-2004-0031, to (1) EPA online using EDOCKET (our preferred method), by e-mail to [e-mail], or by mail to: EPA Docket Center, Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, Mail Code 2201T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., Washington, DC 20503.

FOR FURTHER INFORMATION CONTACT:

Learia Williams, Compliance Assessment and Media Programs Division, Office of Compliance, (Mail Code 2223A), Environmental Protection Agency, 1200 Pennsylvania Ave., NW., Washington, DC 20460; telephone number: [phone]; fax number: [phone]; e-mail address: [e-mail].

SUPPLEMENTARY INFORMATION:

EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On December 1, 2004 (69 FR 69909), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments.

EPA has established a public docket for this ICR under Docket ID No. OECA-2004-0031, which is available for public viewing at the Enforcement and Compliance Docket and Information Center in the EPA Docket Center (EPA/DC), EPA West, Room B102, 1301 Constitution Avenue, NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is [phone], and the telephone number for the Enforcement and Compliance Docket and Information Center Docket is: [phone]. An electronic version of the public docket is available through EPA Dockets (EDOCKET) at http://www.epa.gov/​edocket. Use EDOCKET to submit or view public comments, access the index listing of the contents of the public docket, and to access those documents in the public docket that are available electronically. When in the system, select “search,” then key in the docket ID number identified above.

Any comments related to this ICR should be submitted to EPA and OMB within 30 days of this notice. EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing in EDOCKET as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. When EPA identifies a comment containing copyrighted material, EPA will provide a reference to that material in the version of the comment that is placed in EDOCKET. The entire printed comment, including the copyrighted material, will be available in the public docket. Although identified as an item in the official docket, information claimed as CBI, or whose disclosure is otherwise restricted by statute, is not included in the official public docket, and will not be available for public viewing in EDOCKET. For further information about the electronic docket, see EPA's Federal Register notice describing the electronic docket at 67 FR 38102 (May 31, 2002), or go to http://www.epa.gov/​edocket.

The First Federal Register dated Wednesday, December 1, 2004, published on page 69910 under “List of ICRs Planned to be Submitted” number (2) NESHAP for Friction Materials Manufacturing (40 CFR part 63, subpart OOOO), should have read NESHAP for Friction Materials Manufacturing (40 CFR part 63, subpart QQQQQ). We are hereby correcting the subpart to reflect the change as QQQQQ in this Federal Register document.

Title: NESHAP for Friction Materials Manufacturing (Renewal).

Abstract: The National Emission Standards for Hazardous Air Pollutants (NESHAP), for Friction Materials Manufacturing were proposed on October 4, 2001 (66 FR 50768), and promulgated on October 18, 2002 (67 FR 64498). These standards apply to any new, reconstructed, or existing solvent mixers located at a friction materials manufacturing facility engaged in the manufacture of friction materials such as brake and clutch linings. A friction materials manufacturing facility is only subject to the regulation if it is a major source of hazardous air pollutant (HAP) if it emits or has the potential to emit any single HAP at a rate of 10 tons (9.07 megagrams) or more per year or any combination of HAP at a rate of 25 tons (22.68 megagrams) or more per year.

Owners or operators must submit notification reports upon the construction or reconstruction of any friction materials manufacturing facility. Semiannual reports for periods of operation during which the emission limitation is exceeded (or reports certifying that no exceedances have occurred) also are required. Records and reports will be required to be retained for a total of five years: two years at the site, and the remaining three years at an off-site location.

Notifications are used to inform the Agency or delegated authority when a source becomes subject to the standard. The reviewing authority may then inspect the source to check if the pollution control devices are properly installed and operated, and the standard is being met. The information generated by monitoring, recordkeeping and reporting requirements described in this ICR is used by the Agency to ensure that facilities that are affected by the standard continue to operate the control equipment and achieve continuous compliance with the regulation.

All reports are sent to the delegated state or local authority. In the event that there is no such delegated authority, the reports are sent directly to the EPA regional office.

An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB Control Number. The OMB Control Numbers for EPA's regulations are listed in 40 CFR part 9 and 48 CFR chapter 15, and are identified on the form and/or instrument, if applicable.

Burden Statement: The annual public reporting and recordkeeping burden for this collection of information is estimated to average 162 hours per response. Burden means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and maintaining information, and disclosing and providing information; adjust the existing ways to comply with any previously applicable instructions and requirements; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information.

Respondents/Affected Entities: Owners or operators of friction materials manufacturing facilities.

Estimated Number of Respondents: 4.

Frequency of Response: Initially, annually, semiannually and occasionally.

Estimated Total Annual Hour Burden: 1,296.

Estimated Total Annual Costs: $103,424, which includes $0 annualized capital/startup costs, $1,000 annual O&M costs, and $103,424 Respondent Labor Costs.

Changes in the Estimates: There is no change in the number of respondents identified in the active ICR, however, there is a decrease of 94 hours in the estimated burden currently identified in the OMB Inventory of Approved ICR Burdens. The decrease is attributed to the fact that the renewal ICR reflects that all four sources are in compliance with the standard and there are no new sources with reporting requirements.

Dated: May 23, 2005.

Oscar Morales,

Director, Collection Strategies Division.