01-14004. Airworthiness Directives; McDonnell Douglas DC-9-81, -82, -83, and -87 Series Airplanes, and Model MD-88 Airplanes

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model DC-9-81, -82, -83, and -87 series airplanes, and Model MD-88 airplanes. This proposal would require replacing the interface connectors of the cabin fluorescent lighting ballast in the wiring harness of the overhead stowage compartment with new connectors. This action is necessary to prevent electrical shorting and arcing due to the presence of water in the lighting ballast interface connectors, which could result in smoke in the main cabin. This action is intended to address the identified unsafe condition.

DATES:

Comments must be received by July 20, 2001.

ADDRESSES:

Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2000-NM-162-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to [phone]. Comments may also be sent via the Internet using the following address: [e-mail]. Comments sent via fax or the Internet must contain “Docket No. 2000-NM-162-AD” in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 for Windows or ASCII text.

The service information referenced in the proposed rule may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024). This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California.

FOR FURTHER INFORMATION CONTACT:

Elvin Wheeler, Aerospace Engineer, Systems and Equipment Branch, ANM-130L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

Comments Invited

Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this notice may be changed in light of the comments received.

Submit comments using the following format:

• Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.
• For each issue, state what specific change to the proposed AD is being requested.
• Include justification (e.g., reasons or data) for each request.

Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this notice must submit a self-addressed, stamped postcard on which the following statement is made: “Comments to Docket Number 2000-NM-162-AD.” The postcard will be date stamped and returned to the commenter.

Availability of NPRMs

Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2000-NM-162-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.

Discussion

As part of its practice of re-examining all aspects of the service experience of a particular aircraft whenever an accident occurs, the FAA has become aware of incidents of smoke in the main cabin on certain McDonnell Douglas Model DC-9-81, -82, -83, and -87 series airplanes, and Model MD-88 airplanes. Investigation revealed the presence of water in the lighting ballast interface connectors, which can cause electrical shorts and arcing of the connectors. This condition, if not corrected, could result in smoke in main cabin.

Other Related Rulemaking

The FAA, in conjunction with Boeing and operators of McDonnell Douglas Model DC-9-81, -82, -83, and -87 series airplanes, and Model MD-88 airplanes, is continuing to review all aspects of the service history of those airplanes to identify potential unsafe conditions and to take appropriate corrective actions. This proposed airworthiness directive (AD) is one of a series of actions identified during that process. The process is continuing and the FAA may consider additional rulemaking actions as further results of the review become available.

Explanation of Relevant Service Information

The FAA has reviewed and approved McDonnell Douglas Alert Service Bulletin MD80-33A096, Revision 02, dated November 1, 1999. The service bulletin describes procedures for replacing the interface connectors of the cabin fluorescent lighting ballast in the wiring harness of the overhead stowage compartment with new connectors. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition.

Explanation of Requirements of Proposed Rule

Since an unsafe condition has been identified that is likely to exist or develop on other products of this same type design, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously.

Differences Between the Proposed AD and the Referenced Service Bulletin

Operators should note that, even though the effectivity listing of the referenced service bulletin only lists “MD-80” series airplanes, the manufacturer's fuselage numbers listed in the effectivity listing include Model MD-88 airplanes. Therefore, the applicability of the proposed AD includes Model MD-88 airplanes, as well as Model DC-9-81, -82, -83, and -87 series airplanes.

Cost Impact

There are approximately 747 airplanes of the affected design in the worldwide fleet. The FAA estimates that 486 airplanes of U.S. registry would be affected by this proposed AD, that it would take approximately 15 work hours per airplane to accomplish the proposed actions, and that the average labor rate is $60 per work hour. Required parts would cost $510 per airplane. Based on these figures, the cost impact of the inspections proposed AD on U.S. operators is estimated to be $685,260, or $1,410 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this proposed AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this proposed regulation (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Safety

The Proposed Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

McDonnell Douglas: Docket 2000-NM-162-AD.

Applicability: Model DC-9-81, -82, -83, and -87 series airplanes, and Model MD-88 airplanes, as listed in McDonnell Douglas Alert Service Bulletin MD80-33A096, Revision 02, dated November 1, 1999; certificated in any category.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent electrical shorting and arcing due to the presence of water in the lighting ballast interface connectors, which could result in smoke in the main cabin, accomplish the following:

Modification

(a) Within 18 months after the effective date of this AD, replace the interface connectors of the cabin fluorescent lighting ballast in the wiring harness of the overhead stowage compartment with new connectors, in accordance with McDonnell Douglas Alert Service Bulletin MD80-33A096, Revision 02, dated November 1, 1999.

Note 2:

Replacement of connectors prior to the effective date of this AD in accordance with McDonnell Douglas MD80 Service Bulletin 33-96, dated December 15, 1993; or Revision 1, dated February 28, 1994; is considered acceptable for compliance with the requirements of paragraph (a) of this AD.

Spares

(b) As of the effective date of this AD, no person shall install any connector, part number MB10R6, on any airplane.

Alternative Methods of Compliance

(c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO.

Note 3:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO.

Special Flight Permits

(d) Special flight permits may be issued in accordance with §§ 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Issued in Renton, Washington, on May 25, 2001.

Vi L. Lipski,

Manager, Transport Airplane Directorate, Aircraft Certification Service.