95-13502. Airworthiness Directives; Fokker Model F28 Mark 0100 Series Airplanes  

  • [Federal Register Volume 60, Number 109 (Wednesday, June 7, 1995)]
    [Rules and Regulations]
    [Pages 29981-29982]
    From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
    [FR Doc No: 95-13502]
    
    
    
    -----------------------------------------------------------------------
    
    
    DEPARTMENT OF TRANSPORTATION
    14 CFR Part 39
    
    [Docket No. 94-NM-241-AD; Amendment 39-9253; AD 95-12-03]
    
    
    Airworthiness Directives; Fokker Model F28 Mark 0100 Series 
    Airplanes
    
    AGENCY: Federal Aviation Administration, DOT.
    
    ACTION: Final rule.
    
    -----------------------------------------------------------------------
    
    SUMMARY: This amendment adopts a new airworthiness directive (AD), 
    applicable to certain Fokker Model F28 Mark 0100 series airplanes, that 
    requires installation of reinforcement plates at certain fuselage 
    stations. This amendment is prompted by a report indicating that cracks 
    were found in the frame strips at certain fuselage stations on a Model 
    F28 Mark 0100 series airplane test article due to fatigue-related 
    stress. The actions specified by this AD are intended to prevent such 
    fatigue-related cracking, which could result in reduced structural 
    integrity of the fuselage pressure vessel.
    
    DATES: Effective July 7, 1995.
        The incorporation by reference of certain publications listed in 
    the regulations is approved by the Director of the Federal Register as 
    of July 7, 1995.
    
    ADDRESSES: The service information referenced in this AD may be 
    obtained from Fokker Aircraft USA, Inc., 1199 North Fairfax Street, 
    Alexandria, Virginia 22314. This information may be examined at the 
    Federal Aviation Administration (FAA), Transport Airplane Directorate, 
    Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the 
    Office of the Federal Register, 800 North Capitol Street, NW., suite 
    700, Washington, DC.
    
    FOR FURTHER INFORMATION CONTACT: Tim Dulin, Aerospace Engineer, 
    Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 
    1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206) 
    227-2141; fax (206) 227-1320.
    
    SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
    Aviation Regulations (14 CFR part 39) to include an airworthiness 
    directive (AD) that is applicable to certain Fokker Model F28 Mark 0100 
    series airplanes was published in the Federal Register on March 3, 1995 
    (60 FR 11944). That action proposed to require installation of 
    reinforcement plates at left and right fuselage stations 14911 and 
    17011.
        Interested persons have been afforded an opportunity to participate 
    in the making of this amendment. Due consideration has been given to 
    the single comment received.
        The commenter supports the proposed rule.
        After careful review of the available data, including the comment 
    noted above, the FAA has determined that air safety and the public 
    interest require the adoption of the rule as proposed.
        The FAA estimates that 45 airplanes of U.S. registry will be 
    affected by this AD, that it will take approximately 160 work hours per 
    airplane to accomplish the required actions, and that the average labor 
    rate is $60 per work hour. Required parts will cost approximately 
    $3,800 per airplane. Based on these figures, the total cost impact of 
    the AD on U.S. operators is estimated to be $603,000, or $13,400 per 
    airplane.
        The total cost impact figure discussed above is based on 
    assumptions that no operator has yet accomplished any of the 
    requirements of this AD action, and that no operator would accomplish 
    those actions in the future if this AD were not adopted.
        The regulations adopted herein will not have substantial direct 
    effects on the States, on the relationship between the national 
    government and the States, or on the distribution of power and 
    responsibilities among the various levels of government. Therefore, in 
    accordance with Executive Order 12612, it is determined that this final 
    rule does not have sufficient federalism implications to warrant the 
    preparation of a Federalism Assessment.
        For the reasons discussed above, I certify that this action (1) is 
    not a ``significant regulatory action'' under Executive Order 12866; 
    (2) is not a ``significant rule'' under DOT Regulatory Policies and 
    Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
    significant economic impact, positive or negative, on a substantial 
    number of small entities under the criteria of the Regulatory 
    Flexibility Act. A final evaluation has been prepared for this action 
    and it is contained in the Rules Docket. A copy of it may be obtained 
    from the Rules Docket at the location provided under the caption 
    ADDRESSES.
    
    List of Subjects in 14 CFR Part 39
    
        Air transportation, Aircraft, Aviation safety, Incorporation by 
    reference, Safety.
    
    Adoption of the Amendment
    
        Accordingly, pursuant to the authority delegated to me by the 
    Administrator, the Federal Aviation Administration amends part 39 of 
    the Federal Aviation Regulations (14 CFR part 39) as follows:
    
    PART 39--AIRWORTHINESS DIRECTIVES
    
        1. The authority citation for part 39 continues to read as follows:
    
        Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C. 
    106(g); and 14 CFR 11.89.
    
    
    Sec. 39.13  [Amended]
    
        2. Section 39.13 is amended by adding the following new 
    airworthiness directive:
    
    95-12-03  Fokker: Amendment 39-9253. Docket 94-NM-241-AD.
    
        Applicability: Model F28 Mark 0100 series airplanes, serial 
    numbers 11244 through 11371 inclusive, certificated in any category.
    
        Note 1: This AD applies to each airplane identified in the 
    preceding applicability provision, regardless of whether it has been 
    modified, altered, or repaired in the area subject to the 
    requirements of this AD. For airplanes that have been modified, 
    altered, or repaired so that the performance of the requirements of 
    this AD is affected, the owner/operator must use the authority 
    provided in paragraph (b) to request approval from the FAA. This 
    approval may address either no action, if the current configuration 
    eliminates the unsafe condition; or different actions necessary to 
    address the unsafe condition described in this AD. Such a request 
    should include an assessment of the effect of the changed 
    configuration on the unsafe condition addressed by this AD. In no 
    case does the presence of any modification, alteration, or repair 
    remove any airplane from the applicability of this AD.
    
        Compliance: Required as indicated, unless accomplished 
    previously.
        To prevent cracking in the frame strips at fuselage stations 
    14911 and 17011, which could result in reduced structural integrity 
    of the fuselage pressure vessel, accomplish the following:
        (a) Prior to the accumulation of 24,000 total flight cycles, or 
    within 6 months after the effective date of this AD, whichever 
    occurs [[Page 29982]] later, install reinforcement plates at left 
    and right fuselage stations 14911 and 17011, in accordance with 
    Fokker Service Bulletin SBF100-53-072, dated March 12, 1993.
        (b) An alternative method of compliance or adjustment of the 
    compliance time that provides an acceptable level of safety may be 
    used if approved by the Manager, Standardization Branch, ANM-113, 
    FAA, Transport Airplane Directorate. Operators shall submit their 
    requests through an appropriate FAA Principal Maintenance Inspector, 
    who may add comments and then send it to the Manager, 
    Standardization Branch, ANM-113.
    
        Note 2: Information concerning the existence of approved 
    alternative methods of compliance with this AD, if any, may be 
    obtained from the Standardization Branch, ANM-113.
        (c) Special flight permits may be issued in accordance with 
    sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
    CFR 21.197 and 21.199) to operate the airplane to a location where 
    the requirements of this 0AD can be accomplished.
        (d) The installation shall be done in accordance with Fokker 
    Service Bulletin SBF100-53-072, dated March 12, 1993. This 
    incorporation by reference was approved by the Director of the 
    Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
    51. Copies may be obtained from Fokker Aircraft USA, Inc., 1199 
    North Fairfax Street, Alexandria, Virginia 22314. Copies may be 
    inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
    Avenue, SW., Renton, Washington; or at the Office of the Federal 
    Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
        (e) This amendment becomes effective on July 7, 1995.
    
        Issued in Renton, Washington, on May 26, 1995.
    Darrell M. Pederson,
    Acting Manager, Transport Airplane Directorate, Aircraft Certification 
    Service.
    [FR Doc. 95-13502 Filed 6-6-95; 8:45 am]
    BILLING CODE 4910-13-U
    
    

Document Information

Effective Date:
7/7/1995
Published:
06/07/1995
Department:
Transportation Department
Entry Type:
Rule
Action:
Final rule.
Document Number:
95-13502
Dates:
Effective July 7, 1995.
Pages:
29981-29982 (2 pages)
Docket Numbers:
Docket No. 94-NM-241-AD, Amendment 39-9253, AD 95-12-03
PDF File:
95-13502.pdf
CFR: (1)
14 CFR 39.13