2020-12155. Airworthiness Directives; Leonardo S.p.a. Helicopters  

  • Start Preamble

    AGENCY:

    Federal Aviation Administration (FAA), DOT.

    ACTION:

    Notice of proposed rulemaking (NPRM).

    SUMMARY:

    The FAA proposes to adopt a new airworthiness directive (AD) for Leonardo S.p.a. (Leonardo) Model AB139 and AW139 helicopters. This proposed AD would require removing certain main gearbox (MGB) input modules from service. This proposed AD was prompted by the discovery that a batch of duplex bearings, which are installed on the MGB input modules, are defective. The actions of this proposed AD are intended to address an unsafe condition on these products.

    DATES:

    The FAA must receive comments on this proposed AD by July 23, 2020.

    ADDRESSES:

    You may send comments by any of the following methods:

    • Federal eRulemaking Docket: Go to https://www.regulations.gov. Follow the online instructions for sending your comments electronically.
    • Fax: 202-493-2251.
    • Mail: Send comments to the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590-0001.
    • Hand Delivery: Deliver to the “Mail” address between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

    Examining the AD Docket

    You may examine the AD docket on the internet at https://Start Printed Page 35019www.regulations.gov by searching for and locating Docket No. FAA-2020-0554; or in person at the Docket Operations Office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD, any comments received, and other information. The street address for Docket Operations is listed above. Comments will be available in the AD docket shortly after receipt.

    For service information identified in this proposed rule, contact Leonardo S.p.a. Helicopters, Emanuele Bufano, Head of Airworthiness, Viale G.Agusta 520, 21017 C.Costa di Samarate (Va) Italy; telephone +39-0331-225074; fax +39-0331-229046; or at https://www.leonardocompany.com/​en/​home. You may view the referenced service information at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Rao Edupuganti, Aviation Safety Engineer, Regulations and Policy Section, Rotorcraft Standards Branch, FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone 817-222-5110; email rao.edupuganti@faa.gov.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Comments Invited

    The FAA invites you to participate in this rulemaking by submitting written comments, data, or views. The FAA also invites comments relating to the economic, environmental, energy, or federalism impacts that might result from adopting the proposals in this document. The most helpful comments reference a specific portion of the proposal, explain the reason for any recommended change, and include supporting data. To ensure the docket does not contain duplicate comments, commenters should send only one copy of written comments, or if comments are filed electronically, commenters should submit only one time.

    The FAA will file in the docket all comments received, as well as a report summarizing each substantive public contact with FAA personnel concerning this proposed rulemaking. Before acting on this proposal, the FAA will consider all comments received on or before the closing date for comments. The FAA will consider comments filed after the comment period has closed if it is possible to do so without incurring expense or delay. The FAA may change this proposal in light of the comments received.

    Discussion

    EASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2016-0255R1, dated January 17, 2017 (EASA AD 2016-0255R1) to correct an unsafe condition for Leonardo (formerly Finmeccanica S.p.A., AgustaWestland Philadelphia Corporation, Agusta Aerospace Corporation) Model AB139 and AW139 helicopters with certain serial-numbered MGB input modules part-number (P/N) 3K6320A00135 or P/N 3K6320A00136 installed. EASA advises that the supplier of a batch of duplex bearings installed on MGB input modules reported that the bearings were defective, due to a quality control issue. This condition, if not detected or corrected, could lead to damage of the input module duplex ball bearing inner race, possibly resulting in loss of engine power and reduced control of the helicopter. Accordingly, EASA AD 2016-0255R1 requires removing the affected MGB input modules from service.

    FAA's Determination

    These helicopters have been approved by EASA and are approved for operation in the United States. Pursuant to the FAA's bilateral agreement with the European Union, EASA has notified the FAA about the unsafe condition described in its AD. The FAA is proposing this AD after evaluating all known relevant information and determining that an unsafe condition is likely to exist or develop on other helicopters of the same type designs.

    Related Service Information

    The FAA reviewed Leonardo Helicopters Bollettino Tecnico No. 139-303, dated September 20, 2016, which specifies replacing certain duplex bearings on MGB left-hand and right-hand input modules on Model AB139 and AW139 helicopters.

    Proposed AD Requirements

    This proposed AD would require compliance with certain procedures described in the manufacturer's service bulletin. For helicopters with one affected MGB input module installed, this proposed AD would require the affected MGB input module to be removed from service within 1200 hours time-in-service (TIS). For helicopters with two affected MGB input modules installed, this proposed AD would require both affected MGB input modules to be removed from service within 300 hours TIS.

    Differences Between This Proposed AD and the EASA AD

    The EASA AD requires returning affected parts and sending information to Leonardo; however, this proposed AD would not.

    Costs of Compliance

    The FAA estimates that this proposed AD would affect 71 helicopters of U.S. Registry. The FAA estimates that operators may incur the following costs in order to comply with this AD. Labor costs are estimated at $85 per work-hour.

    Replacing one input module would require about 60 work-hours for an estimated cost of $5,100 and parts would cost about $84,847 for an estimated cost of $89,947 per helicopter.

    Replacing two input modules would require about 100 work-hours for an estimated cost of $8,500 and parts would cost about $169,694 for an estimated cost of $178,194 per helicopter.

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

    The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    Regulatory Findings

    The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed, I certify this proposed regulation:

    1. Is not a “significant regulatory action” under Executive Order 12866,

    2. Will not affect intrastate aviation in Alaska, andStart Printed Page 35020

    3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    The Proposed Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

    Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

    End Amendment Part

    Leonardo S.p.a.: Docket No. FAA-2020-0554; Product Identifier 2016-SW-088-AD.

    (a) Applicability

    This AD applies to Leonardo S.p.a. Model AB139 and AW139 helicopters, certified in any category, with main gearbox (MGB) input module part number (P/N) 3K6320A00135 with serial number (S/N) KHI-200 or P/N 3K6320A00136 with an S/N listed in Table 1 to this paragraph installed.

    (b) Unsafe Condition

    This AD defines the unsafe condition as defective duplex bearings on MGB input modules, due to a quality control issue. This condition could result in damage including corrosion and cracking, which could result in excessive heat of the input module duplex ball bearing inner race and subsequent loss of engine power and loss of helicopter control.

    (c) Comments Due Date

    The FAA must receive comments by July 23, 2020.

    (d) Compliance

    You are responsible for performing each action required by this AD within the specified compliance time unless it has already been accomplished prior to that time.

    (e) Required Actions

    (1) If the P/N and S/N of both MGB input modules are listed in paragraph (a) of this AD, within 300 hours time-in-service (TIS), remove from service each MGB input module.

    (2) If the P/N and S/N of only one MGB input module are listed in paragraph (a) of this AD, within 1,200 hours TIS, remove from service that MGB input module.

    (3) After the effective date of this AD, do not install an MGB input module with a P/N and S/N listed in paragraph (a) of this AD on any helicopter.

    (f) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, Safety Management Section, Rotorcraft Standards Branch, FAA, may approve AMOCs for this AD. Send your proposal to: Rao Edupuganti, Aviation Safety Engineer, Regulations and Policy Section, Rotorcraft Standards Branch, FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone 817-222-5110; email 9-ASW-FTW-AMOC-Requests@faa.gov.

    (2) For operations conducted under a 14 CFR part 119 operating certificate or under 14 CFR part 91, subpart K, the FAA suggests that you notify your principal inspector, or lacking a principal inspector, the manager of the local flight standards district office or certificate holding district office before Start Printed Page 35021operating any aircraft complying with this AD through an AMOC.

    (g) Additional Information

    The subject of this AD is addressed in European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD No. 2016-0255R1, dated January 17, 2017. You may view the EASA AD on the internet at https://www.regulations.gov in the AD Docket.

    (h) Subject

    Joint Aircraft Service Component (JASC) Code: 6320, Rotor Drive—Gearbox.

    Start Signature

    Issued on June 1, 2020.

    Lance T. Gant,

    Director, Compliance & Airworthiness Division, Aircraft Certification Service.

    End Signature End Supplemental Information

    [FR Doc. 2020-12155 Filed 6-5-20; 8:45 am]

    BILLING CODE 4910-13-P

Document Information

Published:
06/08/2020
Department:
Federal Aviation Administration
Entry Type:
Proposed Rule
Action:
Notice of proposed rulemaking (NPRM).
Document Number:
2020-12155
Dates:
The FAA must receive comments on this proposed AD by July 23, 2020.
Pages:
35018-35021 (4 pages)
Docket Numbers:
Docket No. FAA-2020-0554, Product Identifier 2016-SW-088-AD
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
2020-12155.Pdf
Supporting Documents:
» Airworthiness Directives: Leonardo S.p.a. Helicopters
» Supporting AD Documents
» Airworthiness Directives: Leonardo S.p.a. Helicopters
CFR: (1)
14 CFR 39.13