99-16591. Airworthiness Directives; Eurocopter Deutschland (Eurocopter) Model EC135 Helicopters  

  • [Federal Register Volume 64, Number 126 (Thursday, July 1, 1999)]
    [Rules and Regulations]
    [Pages 35559-35562]
    From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
    [FR Doc No: 99-16591]
    
    
    =======================================================================
    -----------------------------------------------------------------------
    
    DEPARTMENT OF TRANSPORTATION
    
    Federal Aviation Administration
    
    14 CFR Part 39
    
    [Docket No. 99-SW-38-AD; Amendment 39-11217; AD 99-12-01]
    RIN 2120-AA64
    
    
    Airworthiness Directives; Eurocopter Deutschland (Eurocopter) 
    Model EC135 Helicopters
    
    AGENCY: Federal Aviation Administration, DOT.
    
    ACTION: Final rule; request for comments.
    
    -----------------------------------------------------------------------
    
    SUMMARY: This document publishes in the Federal Register an amendment 
    adopting Airworthiness Directive (AD) 99-12-01, which was sent 
    previously to all known U.S. owners and operators of Eurocopter Model 
    EC135 helicopters by individual letters. This AD requires initial and 
    repetitive visual inspections and one dye-penetrant inspection of the 
    main rotor hub shaft (shaft) for cracks. If a crack is found during any 
    of the inspections, this AD requires replacing the shaft with an 
    airworthy shaft before further flight. This amendment is prompted by 
    the discovery of fatigue cracks on the shaft of a helicopter. The 
    actions specified by this AD are intended to detect fatigue cracks in 
    the shaft that could lead to shaft failure and subsequent loss of 
    control of the helicopter.
    
    DATES: Effective July 16, 1999, to all persons except those persons to 
    whom it was made immediately effective by Priority Letter AD 99-12-01, 
    issued on May 27, 1999, which contained the requirements of this 
    amendment.
        Comments for inclusion in the Rules Docket must be received on or 
    before August 30, 1999.
    
    ADDRESSES: Submit comments in triplicate to the Federal Aviation 
    Administration (FAA), Office of the Regional Counsel, Southwest Region, 
    Attention: Rules Docket No. 99-SW-38-AD, 2601 Meacham Blvd., Room 663, 
    Fort Worth, Texas 76137.
    
    FOR FURTHER INFORMATION CONTACT: Mike Mathias, Aerospace Engineer, FAA, 
    Rotorcraft Directorate, Rotorcraft Standards Staff, 2601 Meacham Blvd., 
    Fort Worth, Texas 76137, telephone (817) 222-5123, fax (817) 222-5961.
    
    SUPPLEMENTARY INFORMATION: On May 27, 1999, the FAA issued Priority 
    Letter AD 99-12-01, applicable to Eurocopter Model EC135 helicopters, 
    which requires initial and repetitive visual inspections and one dye-
    penetrant inspection of the shaft for cracks. If a crack is found 
    during any of the inspections, the AD requires replacing the shaft with 
    an airworthy shaft before further flight. That action was prompted by 
    the discovery of fatigue cracks on the shaft of a helicopter. This 
    condition, if not corrected, could result in failure of the shaft and 
    subsequent loss of control of the helicopter.
        Eurocopter has issued Eurocopter EC135 Alert Service Bulletin (ASB) 
    EC 135-62A-004, dated May 5, 1999, which specifies inspecting the shaft 
    for cracks. The Luftfahrt-Bundesamt (LBA), which is the airworthiness 
    authority for the Federal Republic of Germany, classified this service 
    bulletin as mandatory and issued AD 1999-185, dated May 6, 1999, to 
    assure the continued airworthiness of these helicopters in the Federal 
    Republic of Germany. Eurocopter later issued ASB EC135-62A-004, Rev. 1, 
    dated May 7, 1999.
        Since the unsafe condition described is likely to exist or develop 
    on other Eurocopter Model EC135 helicopters of the same type design, 
    the FAA issued Priority Letter AD 99-12-01 to detect fatigue cracks in 
    the shaft that could lead to shaft failure and subsequent loss of 
    control of the helicopter. The AD requires initial and repetitive 
    visual inspections and one dye-penetrant inspection of the shaft for 
    cracks. The short compliance time involved is required because the 
    previously described critical unsafe condition can adversely affect the 
    structural integrity of the helicopter. Therefore, inspecting the shaft 
    for cracks is required before further flight and this AD must be issued 
    immediately.
        Since it was found that immediate corrective action was required, 
    notice and opportunity for prior public comment thereon were 
    impracticable
    
    [[Page 35560]]
    
    and contrary to the public interest, and good cause existed to make the 
    AD effective immediately by individual letters issued on May 27, 1999, 
    to all known U.S. owners and operators of Eurocopter Model EC135 
    helicopters. These conditions still exist, and the AD is hereby 
    published in the Federal Register as an amendment to section 39.13 of 
    the Federal Aviation Regulations (14 CFR 39.13) to make it effective to 
    all persons.
        The FAA estimates that 10 helicopters will be affected by this AD; 
    that it will take approximately 0.5 work hour per helicopter to perform 
    the visual inspections, 1 work hour per helicopter to perform the dye-
    penetrant inspection, 10 work hours to replace the shaft, if necessary; 
    and that the average labor rate is $60 per work hour. Required parts 
    will cost approximately $25,000 per shaft. Based on these figures, the 
    total cost impact of the AD on U.S. operators is estimated to be 
    $55,900 per year, assuming the initial inspection, one dye-penetrant 
    inspection, and 100 visual inspections per year on each helicopter, and 
    one shaft replacement in the fleet.
    
    Comments Invited
    
        Although this action is in the form of a final rule that involves 
    requirements affecting flight safety and, thus, was not preceded by 
    notice and an opportunity for public comment, comments are invited on 
    this rule. Interested persons are invited to comment on this rule by 
    submitting such written data, views, or arguments as they may desire. 
    Communications should identify the Rules Docket number and be submitted 
    in triplicate to the address specified under the caption ADDRESSES. All 
    communications received on or before the closing date for comments will 
    be considered, and this rule may be amended in light of the comments 
    received. Factual information that supports the commenter's ideas and 
    suggestions is extremely helpful in evaluating the effectiveness of the 
    AD action and determining whether additional rulemaking action would be 
    needed.
        Comments are specifically invited on the overall regulatory, 
    economic, environmental, and energy aspects of the rule that might 
    suggest a need to modify the rule. All comments submitted will be 
    available, both before and after the closing date for comments, in the 
    Rules Docket for examination by interested persons. A report that 
    summarizes each FAA-public contact concerned with the substance of this 
    AD will be filed in the Rules Docket.
        Commenters wishing the FAA to acknowledge receipt of their comments 
    submitted in response to this rule must submit a self-addressed, 
    stamped postcard on which the following statement is made: ``Comments 
    to Docket No. 99-SW-38-AD.'' The postcard will be date stamped and 
    returned to the commenter.
        The regulations adopted herein will not have substantial direct 
    effects on the States, on the relationship between the national 
    government and the States, or on the distribution of power and 
    responsibilities among the various levels of government. Therefore, in 
    accordance with Executive Order 12612, it is determined that this final 
    rule does not have sufficient federalism implications to warrant the 
    preparation of a Federalism Assessment.
        The FAA has determined that this regulation is an emergency 
    regulation that must be issued immediately to correct an unsafe 
    condition in aircraft, and that it is not a ``significant regulatory 
    action'' under Executive Order 12866. It has been determined further 
    that this action involves an emergency regulation under DOT Regulatory 
    Policies and Procedures (44 FR 11034, February 26, 1979). If it is 
    determined that this emergency regulation otherwise would be 
    significant under DOT Regulatory Policies and Procedures, a final 
    regulatory evaluation will be prepared and placed in the Rules Docket. 
    A copy of it, if filed, may be obtained from the Rules Docket at the 
    location provided under the caption ADDRESSES.
    
    List of Subjects in 14 CFR Part 39
    
        Air transportation, Aircraft, Aviation safety, Safety.
    
    Adoption of the Amendment
    
        Accordingly, pursuant to the authority delegated to me by the 
    Administrator, the Federal Aviation Administration amends part 39 of 
    the Federal Aviation Regulations (14 CFR part 39) as follows:
    
    PART 39--AIRWORTHINESS DIRECTIVES
    
        1. The authority citation for part 39 continues to read as follows:
    
        Authority: 49 U.S.C. 106(g), 40113 and 44701.
    
    
    Sec. 39.13  [Amended]
    
        2. Section 39.13 is amended by adding a new airworthiness directive 
    to read as follows:
    
    AD 99-12-01  Eurocopter Deutschland GmbH: Amendment 39-11217. Docket 
    No. 99-SW-38-AD.
    
        Applicability: Model EC135 helicopter with main rotor hub shaft 
    (shaft), part number (P/N) L623M100S 101, installed, certificated in 
    any category.
    
        Note 1: This AD applies to each helicopter identified in the 
    preceding applicability provision, regardless of whether it has been 
    otherwise modified, altered, or repaired in the area subject to the 
    requirements of this AD. For helicopters that have been modified, 
    altered, or repaired so that the performance of the requirements of 
    this AD is affected, the owner/operator must request approval for an 
    alternative method of compliance in accordance with paragraph (c) of 
    this AD. The request should include an assessment of the effect of 
    the modification, alteration, or repair on the unsafe condition 
    addressed by this AD; and, if the unsafe condition has not been 
    eliminated, the request should include specific proposed actions to 
    address it.
    
        Compliance: Required as indicated, unless accomplished 
    previously.
        To detect a fatigue crack in the shaft that could lead to shaft 
    failure and subsequent loss of control of the helicopter, accomplish 
    the following:
        (a) Before further flight, and thereafter, at intervals not to 
    exceed 15 hours time-in-service (TIS), visually inspect the shaft, 
    P/N L623M100S 101, for any crack in the area marked in Figure 1. 
    Clean the shaft before using a bright light source to inspect for 
    cracks. If any crack is found, replace the shaft with an airworthy 
    shaft before further flight.
    
        (b) Within 10 hours TIS, conduct a one-time dye-penetrant 
    inspection of the shaft using the MIL-STD-6866 or ASTM-E-1417 
    procedure in the area shown in Figure 1. If any crack is found, 
    replace the shaft with an airworthy shaft before further flight.
        Note 2: Eurocopter EC 135 Alert Service Bulletin EC 135-62A-004, 
    Rev. 1, dated May 7, 1999, pertains to the subject of this AD.
    
    BILLING CODE 4910-13-P
    
    [[Page 35561]]
    
    [GRAPHIC] [TIFF OMITTED] TR01JY99.039
    
    
    BILLING CODE 4910-13-C
    
    [[Page 35562]]
    
        (c) An alternative method of compliance or adjustment of the 
    compliance time that provides an acceptable level of safety may be 
    used if approved by the Manager, Rotorcraft Standards Staff, FAA, 
    Rotorcraft Directorate. Operators shall submit their requests 
    through an FAA Principal Maintenance Inspector, who may concur or 
    comment and then send it to the Manager, Rotorcraft Standards Staff.
    
        Note 3: Information concerning the existence of approved 
    alternative methods of compliance with this AD, if any, may be 
    obtained from the Rotorcraft Standards Staff.
    
        (d) Special flight permits will not be issued.
        (e) This amendment becomes effective on July 16, 1999, to all 
    persons except those persons to whom it was made immediately 
    effective by Priority Letter AD 99-12-01, issued May 27, 1999, which 
    contained the requirements of this amendment.
    
        Note 4: The subject of this AD is addressed in Luftfahrt-
    Bundesamt (Federal Republic of Germany) AD 1999-185, dated May 6, 
    1999.
    
        Issued in Fort Worth, Texas, on June 23, 1999.
    Henry A. Armstrong,
    Manager, Rotorcraft Directorate, Aircraft Certification Service.
    [FR Doc. 99-16591 Filed 6-30-99; 8:45 am]
    BILLING CODE 4910-13-P
    
    
    

Document Information

Effective Date:
7/16/1999
Published:
07/01/1999
Department:
Federal Aviation Administration
Entry Type:
Rule
Action:
Final rule; request for comments.
Document Number:
99-16591
Dates:
Effective July 16, 1999, to all persons except those persons to whom it was made immediately effective by Priority Letter AD 99-12-01, issued on May 27, 1999, which contained the requirements of this amendment.
Pages:
35559-35562 (4 pages)
Docket Numbers:
Docket No. 99-SW-38-AD, Amendment 39-11217, AD 99-12-01
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
PDF File:
99-16591.pdf
CFR: (1)
14 CFR 39.13