[Federal Register Volume 64, Number 138 (Tuesday, July 20, 1999)]
[Proposed Rules]
[Pages 38850-38851]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 99-18410]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 98-NM-384-AD]
RIN 2120-AA64
Airworthiness Directives; Bombardier Model DHC-8-100 and -300
Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: This document proposes the adoption of a new airworthiness
directive (AD) that is applicable to certain Bombardier Model DHC-8-100
and -300 series airplanes. This proposal would require replacement of
the main landing gear (MLG) uplock actuator on both the left and right
MLG with a new redesigned uplock assembly. This proposal is prompted by
issuance of mandatory continuing airworthiness information by a foreign
civil airworthiness authority. The actions specified by the proposed AD
are intended to prevent failure of the MLG to extend when a ``gear
down'' selection is made.
DATES: Comments must be received by August 19, 1999.
ADDRESSES: Submit comments in triplicate to the Federal Aviation
Administration (FAA), Transport Airplane Directorate, ANM-114,
Attention: Rules Docket No. 98-NM-384-AD, 1601 Lind Avenue, SW.,
Renton, Washington 98055-4056. Comments may be inspected at this
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except
Federal holidays.
The service information referenced in the proposed rule may be
obtained from Bombardier, Inc., Bombardier Regional Aircraft Division,
Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. This information
may be examined at the FAA, Transport Airplane Directorate, 1601 Lind
Avenue, SW., Renton, Washington; or at the FAA, Engine and Propeller
Directorate, New York Aircraft Certification Office, 10 Fifth Street,
Third Floor, Valley Stream, New York.
FOR FURTHER INFORMATION CONTACT: Paolo Farina, Aerospace Engineer,
Systems and Flight Test Branch, ANE-172, FAA, Engine and Propeller
Directorate, New York Aircraft Certification Office, 10 Fifth Street,
Third Floor, Valley Stream, New York 11581; telephone (516) 256-7530;
fax (516) 568-2716.
SUPPLEMENTARY INFORMATION:
Comments Invited
Interested persons are invited to participate in the making of the
proposed rule by submitting such written data, views, or arguments as
they may desire. Communications shall identify the Rules Docket number
and be submitted in triplicate to the address specified above. All
communications received on or before the closing date for comments,
specified above, will be considered before taking action on the
proposed rule. The proposals contained in this notice may be changed in
light of the comments received.
Comments are specifically invited on the overall regulatory,
economic, environmental, and energy aspects of the proposed rule. All
comments submitted will be available, both before and after the closing
date for comments, in the Rules Docket for examination by interested
persons. A report summarizing each FAA-public contact concerned with
the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments
submitted in response to this notice must submit a self-addressed,
stamped postcard on which the following statement is made: ``Comments
to Docket Number 98-NM-384-AD.'' The postcard will be date stamped and
returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request
to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules
Docket No. 98-NM-384-AD, 1601 Lind Avenue, SW., Renton, Washington
98055-4056.
Discussion
Transport Canada Aviation (TCA), which is the airworthiness
authority for Canada, notified the FAA that an unsafe condition may
exist on certain Bombardier Model DHC-8-100 and -300 series airplanes.
TCA advises that operators have reported incidents of the main landing
gear (MLG) failing to extend (gear hung up) when a down selection is
made. The cause is attributed to failure of the uplock unit to
disengage due to wear. This condition, if not corrected, could result
in a gear-up landing.
Explanation of Relevant Service Information
Bombardier has issued Service Bulletin S.B. 8-32-98, Revision `C,'
dated July 31, 1998, which describes procedures for replacement of the
main landing gear uplock actuator on both the left and right main
landing gear with a new redesigned uplock assembly. Accomplishment of
the actions specified in the service bulletin is intended to adequately
address the identified unsafe condition. TCA classified this service
bulletin as mandatory and issued Canadian airworthiness directive CF-
98-26, dated August 26, 1998, in order to assure the continued
airworthiness of these airplanes in Canada.
FAA's Conclusions
These airplane models are manufactured in Canada and are type
[[Page 38851]]
certificated for operation in the United States under the provisions of
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and
the applicable bilateral airworthiness agreement. Pursuant to this
bilateral airworthiness agreement, TCA has kept the FAA informed of the
situation described above. The FAA has examined the findings of TCA,
reviewed all available information, and determined that AD action is
necessary for products of this type design that are certificated for
operation in the United States.
Explanation of Requirements of Proposed Rule
Since an unsafe condition has been identified that is likely to
exist or develop on other airplanes of the same type design registered
in the United States, the proposed AD would require accomplishment of
the actions specified in the service bulletin described previously.
Cost Impact
The FAA estimates that 148 airplanes of U.S. registry would be
affected by this proposed AD, that it would take approximately 6 work
hours per airplane to accomplish the proposed replacement, and that the
average labor rate is $60 per work hour. Required parts would cost
between $4,030 and $5,016 per airplane. Based on these figures, the
cost impact of the proposed AD on U.S. operators is estimated to be
between $649,720 and $795,648, or between $4,390 and $5,376 per
airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the proposed requirements of
this AD action, and that no operator would accomplish those actions in
the future if this AD were not adopted.
Regulatory Impact
The regulations proposed herein would not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this
proposal would not have sufficient federalism implications to warrant
the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this proposed
regulation (1) Is not a ``significant regulatory action'' under
Executive Order 12866; (2) is not a ``significant rule'' under the DOT
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
and (3) if promulgated, will not have a significant economic impact,
positive or negative, on a substantial number of small entities under
the criteria of the Regulatory Flexibility Act. A copy of the draft
regulatory evaluation prepared for this action is contained in the
Rules Docket. A copy of it may be obtained by contacting the Rules
Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration proposes to amend
part 39 of the Federal Aviation Regulations (14 CFR part 39) as
follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
Bombardier, Inc. (Formerly de Havilland, Inc.): Docket 98-NM-384-AD.
Applicability: Model DHC-8-100 and -300 series airplanes, serial
numbers 3 through 339 inclusive, except those on which Modification
8/1828 has been incorporated; certificated in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
otherwise modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (b) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent failure of the main landing gear to extend when a
``gear down'' selection is made, accomplish the following:
(a) Within 12 months after the effective date of this AD:
Replace the uplock actuator with a new, improved part in accordance
with deHavilland Service Bulletin S.B. 8-32-98, Revision `C,' dated
July 31, 1998.
Alternative Methods of Compliance
(b) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, New York Aircraft Certification
Office (ACO), FAA, Engine and Propeller Directorate. Operators shall
submit their requests through an appropriate FAA Principal
Maintenance Inspector, who may add comments and then send it to the
Manager, New York ACO.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the New York ACO.
Special Flight Permits
(c) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
Note 3: The subject of this AD is addressed in Canadian
airworthiness directive CF-98-26, dated August 26, 1998.
Issued in Renton, Washington, on July 14, 1999.
D.L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 99-18410 Filed 7-19-99; 8:45 am]
BILLING CODE 4910-13-U
