[Federal Register Volume 62, Number 155 (Tuesday, August 12, 1997)]
[Corrections]
[Page 43201]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: X97-20812]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Railroad Administration
49 CFR Part 213
[Docket No. RST-90-1, Notice No. 5]
RIN 2130-AA75
Track Safety Standards; Miscellaneous Proposed Revisions
Correction
In proposed rule document 97-16663, beginning on page 36138, in the
issue of Thursday, July 3, 1997, make the following corrections:
Subpart C--Track Geometry
Sec. 213.53 [Corrected]
1. On page 36166, in the first table, in the second column, in the
last entry 14'8'' should read 4'8''.
Subpart D--Track Structure
Sec. 213.113 [Corrected]
2. On page 36170, in the ``Remedial Action'' table, in the first
column, in the fifth entry ``Defective weld 25'' should read
``Defective weld''.
3. On page 36171, in the third column, in the paragraph numbered
(12), in the fourth line, remove the open quotes before ``inch'' and
insert ``3/8''.
Subpart G--Train Operations at Track Classes 6 and Higher
Sec. 213.333 [Corrected]
4. On page 36180, in the table entitled ``Vehicle/Track Interaction
Performance Limits'', the second entry in the ``Safety Limit'' column
should read
tan--.5 1+.5tan
Sec. 213.355 [Corrected]
5. On page 36185, the table in the second column should read:
------------------------------------------------------------------------
Guard
check
gage--The
distance
between Guard
the gage face
line of a gage--The
frog to distance
the guard between
line\1\ guard
of its lines\1\,
guard measured
Class of track rail or across
guarding the track
face, at right
measured angles to
across the gage
the track line\2\,
at right may not
angles to be more
the gage than--
line\2\,
may not
be less
than--
------------------------------------------------------------------------
Class 6 track..................................... 4' 6\1/
2\'' 4' 5''
Class 7 track..................................... 4' 6\1/
2\'' 4' 5''
Class 8 track..................................... 4' 6\1/
2\'' 4' 5''
Class 9 track..................................... 4' 6\1/
2\'' 4' 5''
------------------------------------------------------------------------
\1\ A line along that side of the flangeway which is nearer to the
center of the track and at the same elevation as the gage line.
\2\ A line \5/8\ inch below the top of the center line of the head of
the running rail, or corresponding location of the tread portion of
the track structure.
Appendix A to Part 213 [Corrected]
6. On page 36187, in the first table:
a. Under the column heading ``Elevation of outer rail (inches)'',
``1/2'' should read ``5 1/2''.
b. In the last column, in the tenth line from the bottom, ``41''
should read``51''.
BILLING CODE 1505-01-D
