2019-17500. Airworthiness Directives; The Boeing Company Airplanes  

  • Start Preamble Start Printed Page 43080

    AGENCY:

    Federal Aviation Administration (FAA), DOT.

    ACTION:

    Notice of proposed rulemaking (NPRM).

    SUMMARY:

    The FAA proposes to adopt a new airworthiness directive (AD) for all The Boeing Company Model 757 airplanes and Model 767-200, -300, and -300F series airplanes. This proposed AD was prompted by reports of excessively high flight deck or cabin temperatures. This proposed AD would require revising certificate limitations and operating procedures of the existing airplane flight manual (AFM), to provide the flightcrew with procedures for hot flight deck or cabin temperatures to follow under certain conditions. The FAA is proposing this AD to address the unsafe condition on these products.

    DATES:

    The FAA must receive comments on this proposed AD by October 4, 2019.

    ADDRESSES:

    You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

    • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
    • Fax: 202-493-2251.
    • Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.
    • Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

    Examining the AD Docket

    You may examine the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2019-0605; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, the regulatory evaluation, any comments received, and other information. The street address for Docket Operations is listed above. Comments will be available in the AD docket shortly after receipt.

    Start Further Info

    FOR FURTHER INFORMATION CONTACT:

    Susan L. Monroe, Aerospace Engineer, Cabin Safety and Environmental Systems Section, FAA, Seattle ACO Branch, 2200 South 216th St., Des Moines, WA 98198; phone and fax: 206-231-3570; email: susan.l.monroe@faa.gov.

    End Further Info End Preamble Start Supplemental Information

    SUPPLEMENTARY INFORMATION:

    Comments Invited

    The FAA invites you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2019-0605; Product Identifier 2019-NM-093-AD” at the beginning of your comments. The FAA specifically invites comments on the overall regulatory, economic, environmental, and energy aspects of this NPRM. The FAA will consider all comments received by the closing date and may amend this NPRM because of those comments.

    The FAA will post all comments received, without change, to http://www.regulations.gov,, including any personal information you provide. The FAA will also post a report summarizing each substantive verbal contact received about this NPRM.

    Discussion

    The FAA has received reports of excessively high flight deck or cabin temperatures caused by a loss of power or open circuit breaker on the pack flow control assembly combined with a PACK OFF selection. This combination can drive a single pack into full hot output, which results in the pack operating hot without indication, and without overheat protection. This condition, if not addressed, could result in excessively high flight deck temperatures, which may inhibit safe operation of the airplane by the flightcrew and contribute to loss of continued safe flight and landing. It could also result in excessively high cabin temperatures, which may cause physiological distress to passengers and cabin crew.

    FAA's Determination

    We are proposing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.

    Proposed AD Requirements

    This proposed AD would require revising certificate limitations and operating procedures of the existing AFM, to provide the flightcrew with procedures for hot flight deck or cabin temperatures to follow under certain conditions.

    Costs of Compliance

    The FAA estimates that this proposed AD affects 866 airplanes of U.S. registry. The FAA estimates the following costs to comply with this proposed AD:

    Estimated Costs

    ActionLabor costParts costCost per productCost on U.S. operators
    AFM Revision1 work-hour × $85 per hour = $85$0$85$73,610

    Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

    The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

    This proposed AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is Start Printed Page 43081normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to transport category airplanes and associated appliances to the Director of the System Oversight Division.

    Regulatory Findings

    The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

    For the reasons discussed above, I certify this proposed regulation:

    (1) Is not a “significant regulatory action” under Executive Order 12866,

    (2) Will not affect intrastate aviation in Alaska, and

    (3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    Start List of Subjects

    List of Subjects in 14 CFR Part 39

    • Air transportation
    • Aircraft
    • Aviation safety
    • Incorporation by reference
    • Safety
    End List of Subjects

    The Proposed Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

    Start Part

    PART 39—AIRWORTHINESS DIRECTIVES

    End Part Start Amendment Part

    1. The authority citation for part 39 continues to read as follows:

    End Amendment Part Start Authority

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    End Authority
    [Amended]
    Start Amendment Part

    2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

    End Amendment Part

    The Boeing Company: Docket No. FAA-2019-0605; Product Identifier 2019-NM-093-AD.

    (a) Comments Due Date

    The FAA must receive comments by October 4, 2019.

    (b) Affected ADs

    None.

    (c) Applicability

    This AD applies to all The Boeing Company airplanes specified in paragraphs (c)(1) and (2) of this AD, certificated in any category.

    (1) Model 757-200, -200PF, -200CB, and -300 series airplanes.

    (2) Model 767-200, -300, and -300F series airplanes.

    (d) Subject

    Air Transport Association (ATA) of America Code 21, Air conditioning.

    (e) Unsafe Condition

    This AD was prompted by reports of excessively high flight deck or cabin temperatures. The FAA is issuing this AD to address this condition, which may inhibit safe operation of the airplane by the flightcrew and contribute to loss of continued safe flight and landing, or may cause physiological distress to passengers and cabin crew.

    (f) Compliance

    Comply with this AD within the compliance times specified, unless already done.

    (g) Airplane Flight Manual (AFM) Revisions

    Within 60 days after the effective date of this AD, do the actions specified in paragraphs (g)(1) and (2) of this AD.

    (1) Revise the “Certificate Limitations” chapter of the existing AFM to include the information specified in figures 1 through 3 to paragraph (g)(1) of this AD, as applicable.

    (2) Revise the “Operating Procedures” chapter of the existing AFM to include the information specified in figures 4 through 7 to paragraph (g)(2) of this AD, as applicable.

    Start Printed Page 43082

    Start Printed Page 43083

    Start Printed Page 43084

    Start Printed Page 43085

    (h) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, Seattle ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to the attention of the person identified in paragraph (i) of this AD. Information may be emailed to: 9-ANM-Seattle-ACO-AMOC-Requests@faa.gov.

    (2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

    (3) An AMOC that provides an acceptable level of safety may be used for any repair, modification, or alteration required by this AD if it is approved by The Boeing Company Organization Designation Authorization (ODA) that has been authorized by the Manager, Seattle ACO Branch, FAA, to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically refer to this AD.

    (i) Related Information

    For more information about this AD, contact Susan L. Monroe, Aerospace Engineer, Cabin Safety and Environmental Systems Section, FAA, Seattle ACO Branch, 2200 South 216th St., Des Moines, WA 98198; phone and fax: 206-231-3570; email: susan.l.monroe@faa.gov.

    Start Signature

    Issued in Des Moines, Washington, on August 7, 2019.

    Dionne Palermo,

    Acting Director, System Oversight Division, Aircraft Certification Service.

    End Signature End Supplemental Information

    BILLING CODE 4910-13-P

    [FR Doc. 2019-17500 Filed 8-19-19; 8:45 am]

    BILLING CODE 4910-13-C

Document Information

Published:
08/20/2019
Department:
Federal Aviation Administration
Entry Type:
Proposed Rule
Action:
Notice of proposed rulemaking (NPRM).
Document Number:
2019-17500
Dates:
The FAA must receive comments on this proposed AD by October 4, 2019.
Pages:
43080-43085 (6 pages)
Docket Numbers:
Docket No. FAA-2019-0605, Product Identifier 2019-NM-093-AD
RINs:
2120-AA64: Airworthiness Directives
RIN Links:
https://www.federalregister.gov/regulations/2120-AA64/airworthiness-directives
Topics:
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety
PDF File:
2019-17500.Pdf
CFR: (1)
14 CFR 39.13