E7-16655. Airworthiness Directives; Gulfstream Aerospace LP Model Galaxy Airplanes and Model Gulfstream 200 Airplanes

AGENCY:

Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION:

Final rule.

SUMMARY:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

During the manufacturing process of the Poppet Covers of the Pressurization Safety Valves, burrs that could damage the Valve Diaphragms were not removed. The damage may eventually cause faulty operation of the relief valves resulting in an unsafe condition when combined with additional failures. The serial numbers of the defective valves and the affected aircraft were identified.

The unsafe condition is damage and subsequent failure of the safety relief valves, which could result in rapid decompression of the airplane. We are issuing this AD to require actions to correct the unsafe condition on these products.

DATES:

This AD becomes effective October 2, 2007.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of October 2, 2007.

ADDRESSES:

You may examine the AD docket on the Internet at http://dms.dot.gov or in person at the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC.

FOR FURTHER INFORMATION CONTACT:

Mike Borfitz, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone [phone]; fax [phone].

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on June 6, 2007 (72 FR 31204). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

During the manufacturing process of the Poppet Covers of the Pressurization Safety Valves, burrs that could damage the Valve Diaphragms were not removed. The damage may eventually cause faulty operation of the relief valves resulting in an unsafe condition when combined with additional failures. The serial numbers of the defective valves and the affected aircraft were identified.

The unsafe condition is damage and subsequent failure of the safety relief valves, which could result in rapid decompression of the airplane. The corrective action includes replacing the pressurization safety valve, part number 103842-3. You may obtain further information by examining the MCAI in the AD docket.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

Differences Between This AD and the MCAI or Service Information

We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a NOTE within the AD.

Costs of Compliance

Based on the service information, we estimate that this AD affects about 7 products of U.S. registry. We also estimate that it takes about 10 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $80 per work-hour. Required parts cost about $0 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these costs. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the AD on U.S. operators to be $5,600, or $800 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Examining the AD Docket

You may examine the AD docket on the Internet at http://dms.dot.gov;​; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone [phone]) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

§ 39.13

[Amended]

2. The FAA amends § 39.13 by adding the following new AD:

2007-17-16 Gulfstream Aerospace LP (Formerly Israel Aircraft Industries, Ltd.): Amendment 39-15174. Docket No. FAA-2007-28353; Directorate Identifier 2007-NM-065-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective October 2, 2007.

Affected ADs

(b) None.

Applicability

(c) This AD applies to Gulfstream Model Galaxy airplanes and Model Gulfstream 200 airplanes, serial numbers 101 through 104, 109, 110, and 118, certificated in any category.

Subject

(d) Air Transport Association (ATA) of America Code 21: Air Conditioning.

Reason

(e) The mandatory continuing airworthiness information (MCAI) states:

During the manufacturing process of the Poppet Covers of the Pressurization Safety Valves, burrs that could damage the Valve Diaphragms were not removed. The damage may eventually cause faulty operation of the relief valves resulting in an unsafe condition when combined with additional failures. The serial numbers of the defective valves and the affected aircraft were identified.

The unsafe condition is damage and subsequent failure of the safety relief valves, which could result in rapid decompression of the airplane. The corrective action includes replacing the pressurization safety valve, part number 103842-3.

Actions and Compliance

(f) Unless already done, do the following actions. Within 500 flight hours or 12 months after the effective date of this AD, whichever occurs first: Replace the pressurization safety valve, part number 103842-3, according to Gulfstream Service Bulletin 200-21-308, dated February 23, 2007.

FAA AD Differences

Note:

This AD differs from the MCAI and/ or service information as follows: No differences.

Other FAA AD Provisions

(g) The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Mike Borfitz, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone [phone]; fax [phone]. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056.

Related Information

(h) Refer to MCAI Israeli Airworthiness Directive 21-07-01-01, dated February 20, 2007; and Gulfstream Service Bulletin 200-21-308, dated February 23, 2007; and Honeywell Service Bulletin 103842-21-4126, dated December 5, 2006; for related information.

Material Incorporated by Reference

(i) You must use Gulfstream Service Bulletin 200-21-308, dated February 23, 2007, to do the actions required by this AD, unless the AD specifies otherwise.

(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact Gulfstream Aerospace Corporation, P.O. Box 2206, Mail Station D-25, Savannah, Georgia 31402-2206.

(3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call [phone], or go to: http://www.archives.gov/​federal-register/​cfr/​ibr-locations.html.

Issued in Renton, Washington, on August 14, 2007.

Stephen P. Boyd,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.